Distortion-Induced Fatigue Cracking in a Seismically Retrofitted Steel Bridge
Publication: Journal of Performance of Constructed Facilities
Volume 30, Issue 4
Abstract
This study examines the effect of a seismic retrofit on distortion-induced fatigue cracking in a steel girder bridge in the Midwestern United States. The seismic retrofit of the bridge was deemed necessary following a structural review initiated by the Federal Highway Administration (FHWA) in response to the 1989 Loma Prieta Earthquake. Following the review, the bridge was modified using a conventional seismic retrofit strategy to meet the 1995 FHWA standards for survivability and seismic performance. Upon completion of the retrofit, subsequent inspections identified new cracks (at the location of the retrofit) in the webs of longitudinal girders at transverse stiffener locations in an area known as the web gap. This study investigates the influence of the seismic retrofit strategy on crack formation by comparing principal stresses in the web-gap region of the original and retrofitted bridge under dead, live and thermal loading. A three-dimensional linear-elastic finite element analysis of the bridge before and after the retrofit is presented with results obtained from a commercial finite element software package. Comparisons of stresses before and after the retrofit indicate a measurable increase in stress near the web-gap region attributable to thermal and live loads following the retrofit. In addition, several viable repair strategies to limit these web-gap stresses and subsequent distortion-induced fatigue are presented. The results to date clearly demonstrate the importance of considering fatigue-sensitive details in seismic-retrofit strategies.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (2012). Bridge design specifications, 6th Ed., Washington, DC.
Banan, M., and Capron, M. (2001). “Seismic retrofit of the US-40/I-64 double deck approach to poplar street bridge in St. Louis.” ASCE, Reston, VA, 1–7.
Bathe, K. J., and Wilson, E. L. (1976). Numerical methods in finite element analysis, Prentice-Hall, Englewood Cliffs, NJ.
Capron, M. R. (1995). “Seismic evaluation and retrofit strategies for route I-55 over the Mississippi River near Caruthersville, Missouri.” Proc., 1st National Seismic Conf. on Bridges and Highways, Transportation Research Board, Washington, DC.
Connor, R. J., and Fisher, J. W. (2006). “Identifying effective and ineffective retrofits for distortion fatigue cracking in steel bridges using field instrumentation.” J. Bridge Eng., 745–752.
Cousins, T. E. (1998). “Field evaluation of fatigue cracking in diaphragm girder connections.” J. Perform. Constr. Facil., 25–32.
Cousins, T. E., Stalling, J. M., and Stafford, T. E. (1999). “Removal of diaphragms from 3-span steel girder bridge.” J. Bridge Eng., 63–70.
DeWolf, J. T., Lindsey, T., and Cuomo, M. (1997). “Fatigue evaluation in steel bridges using field monitoring equipment.” Building to Last: Procedures, Structures Congress, Vol. 15, ASCE, Reston, VA.
FHWA (Federal Highway Administration). (1995). “Seismic retrofitting manual for highway bridges.” FHWA-RD-94-052, Research and Development, Turner-Fairbank Highway Research Center, McLean, VA.
Finke, J. (2006). “Construction of seismic retrofit strategies of the US 40/I-64 double deck bridge complex.” Structures Congress 2006, ASCE, Reston, VA, 1–12.
Fisher, J. W., et al. (1990). “Distortion-induced fatigue cracking in steel bridges.”, Transportation Research Board, Washington, DC, 1–43.
Fisher, J. W., Barthelemy, B. M., Mertiz, D. R., and Edinger, J. A. (1980). “Fatigue behavior of full scale welded bridge attachments.”, Transportation Research Board, Washington, DC.
Fisher, J. W., and Keating, P. B. (1989). “Distortion-induced fatigue cracking of bridge details with web gaps.” J. Constr. Steel Res., 12(3), 215–228.
Fisher, J. W., and Roy, S. (2011). “Fatigue of steel bridge infrastructure.” Struct. Infrastruct. Eng., 7(7–8), 457–475.
Fisher, J. W., Wanger, D., and Yen, B. (1990). “Distortion-induced fatigue cracking in steel bridges.”, Transportation Research Board, Washington, DC.
Fisher, J. W., Yen, B., and Wanger, D. (1987). “Review of field measurements for distortion-induced fatigue cracking in steel bridges.”, Transportation Research Board, Washington, DC, 49–55.
Hartman, A., Heidi, H., Adams, C., Bennett, C., Matamoros, A., and Rolfe, S. (2010). “Effects of cross-frame placement and skew on distortion-induced fatigue in steel bridges.”, Transportation Research Board, Washington, DC, 62–68.
Jajich, D., and Schultz, A. E. (2003). “Measurement and analysis of distortion-induced fatigue in multi-girder steel bridges.” J. Bridge Eng., 84–91.
Jajich, D., Schultz, A. E., Bergson, P. M., and Galambos, T. V. (2000). “Distortion-induced fatigue in multi-girder steel bridges.” Univ. of Minnesota, Minneapolis.
Maddox, S. J. (2002). “Hot-spot stress design curves for fatigue assessment of welded structures.” Int. J. Offshore Polar Eng., 12(2), 134–141.
Marquis, G., and Kahonen, A. (1996). “Fatigue testing and analysis using the hot spot method.” Transportation Research Board, Washington, DC, 3–35.
MoDOT (Missouri Department of Transportation). (2013). “St. Louis district traffic volume and commercial vehicle count map.” 〈http://modot.org/safety/documents/2013_Traffic_SL.pdf〉 (Jun. 7, 2015).
Mueller, J. A., and Yen, B. T. (1968). “Girder web boundary stresses and fatigue.”, Welding Research Council, Shaker Heights, OH.
SAP2000 [Computer software]. Walnut Creek, CA, Computers and Structures.
Shifferaw, Y., and Fanous, F. S. (2013). “Field testing and finite element analysis of steel bridge retrofits for distortion-induced fatigue.” Eng. Struct., 49, 385–395.
Zhao, Y., and Roddis, W. M. (2000). “Fatigue cracking investigation for the Arkansa River bridge in Hutchinson, Kansas.” Constr. Build. Mater., 14(5), 287–295.
Information & Authors
Information
Published In
Journal of Performance of Constructed Facilities
Volume 30 • Issue 4 • August 2016
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Nov 7, 2014
Accepted: Apr 8, 2015
Published online: Jul 30, 2015
Discussion open until: Dec 30, 2015
Published in print: Aug 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.