Performances of Large-Diameter Cast-in-Place Concrete Pipe Piles and Pile Groups under Lateral Loads
Publication: Journal of Performance of Constructed Facilities
Volume 27, Issue 2
Abstract
Large-diameter cast-in-place concrete pipe (PCC) pile is widely used for pile foundation and pile-supported embankment over soft clay in China. However, studies on PCC pile-soil reactions ( curves) or performance of the pile groups under lateral load are not widely reported. A large-scale model test of a single PCC pile under lateral load is carried out, and its lateral bearing capacity, bending moment, and curves are measured and analyzed. The deflection and bending moment of this PCC pile is calculated by the curves method and modified pile modulus using LPILE software. Three-dimensional numerical analyses are conducted using ABAQUS software. The reliability and accuracy of the numerical simulation model are verified by comparing the results of the large-scale model test with the LPILE calculation. The distribution of deflection and bending moment along the pile and pile group efficiencies of the PCC piles are comparatively analyzed with those of a drilled shaft, which has the same concrete volume. Then, the lateral performance of the PCC pile-supported embankment influence factors are analyzed and discussed. The results show that the PCC piles under lateral load can be calculated by the curves developed for drilled shaft and modified pile modulus using LPILE software. It also shows that PCC pile-supported embankment is more cost effective than conventional pile (solid circular section pile) supported embankment.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
We acknowledge financial support from the National Natural Science Foundation of China (Grant Nos. 51008116 and 51278170), the National Science Joint High Speed Railway Foundation of China (No. U1134207), and the 111 Project (No. B13024). We gratefully acknowledge Dr. Jian-Wei Zhang and Master Xue-Jun Tao for their contributions to the model tests. Finally, Kenneth L. Carper of Washington State University, the three anonymous reviewers, and the editor are sincerely appreciated for their great comments and suggestions, which substantially improved the presentation of this paper.
References
ABAQUS [Computer software]. Pawtucket, RI, Hibbitt, Karlsson & Sorensen, Inc.
American Petroleum Institute. (1993). “Recommended practice for planning designing and constructing fixed offshore platforms—Working stress design.” API RP2A-WSD, American Petroleum Institute, Washington, DC.
Chen, R. P., Xu, Z. Z., Chen, Y. M., Ling, D. S., and Zhu, B. (2010). “Field tests on pile-supported embankments over soft ground.” J. Geotech. Geoenviron. Eng., 136(6), 777–785.
China Academy of Building Research. (2008). “Code for techniques of pile foundation work.” JGJ94-2008, China Architecture and Building Press, Beijing.
Han, J., and Akins, K. (2002). “Use of geogrid-reinforced and pile supported earth structures.” Proc., Deep Found. 2002: An Int. Perspect. Theor. Design Const. Perform., ASCE, Reston, VA, 668–679.
Han, J., and Gabr, M. A. (2002). “Numerical analysis of geosynthetic reinforced and pile-supported Earth platforms over soft soil.” J. Geotech. Geoenviron. Eng., 128(1), 44–53.
Jones, C. J. F. P., Lawson, C. R., and Ayres, D. J. (1990). “Geotextile reinforced piled embankments.” Proc., 4th Int. Conf. Geotext. Geomemb. Relat. Prod., Balkema, Rotterdam, Netherlands, 155–160.
Lin, K. Q., and Wong, I. H. (1999). “Use of deep cement mixing to reduce settlements at bridge approaches.” J. Geotech. Geoenviron. Eng., 125(4), 309–320.
Liu, H. L., Chu, J., and Deng, A. (2009). “Use of large-diameter, cast-in situ concrete pipe piles for embankment over soft clay.” Can. Geotech. J., 46(8), 915–927.
Liu, H. L., Ng, C. W. W., and Fei, K. (2007). “Performance of a geogrid-reinforced and pile-supported highway embankment over soft clay: Case study.” J. Geotech. Geoenviron. Eng., 133(12), 1483–1493.
Ma, Z. T., Liu, H. L., Zhang, T., and Fei, K. (2006). “Behaviors of PCC pile under lateral loading test.” Rock Soil Mech., 27(Supp. 1), 818–821.
Matlock, H. (1970). “Correlations for design of laterally loaded piles in soft clay.” Proc., 2nd Annual Offshore Technology Conf., Paper No. OTC 1204, Houston, 577–594.
Reese, L. C., Cox, W. R., and Koop, F. D. (1974). “Analysis of laterally loaded piles in sand.” Proc., 6th Offshore Technology Conf., Houston, 473–483.
Reese, L. C., Wang, S. T., Isenhower, W. M., Arrellaga, J. A., and Hendrix, J. (2004). User’s manual of LPILE plus 5.0 for Windows, Ensoft, Inc., Austin, TX.
Wang, S. T., and Reese, L. C. (1993). “COM624P—Laterally loaded pile analysis program for the microcomputer.” Publication No. FHWA-SA-91-048, Federal Highway Administration, Austin.
Xu, X. T., Liu, H. L., and Lehane, B. M. (2006). “Pipe pile installation effects in soft clay.” Proc., Instit. Civil Eng. Geotech. Eng., 159(4), 285–296.
Zhu, X. R., Zhu, M. S., and Wang, J. C. (2006). “Experimental analysis of bearing capacity of cast-in-place tubular pile.” Rock Soil Mech., 27(10), 1749–1753.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Mar 15, 2011
Accepted: Oct 17, 2011
Published online: Oct 20, 2011
Published in print: Apr 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.