Comparison of Measured and AASHTO LRFD-Predicted Residual Prestress Forces, Shear and Flexural Capacities of High-Strength Prestressed-Concrete Bridge Girders
Publication: Journal of Bridge Engineering
Volume 20, Issue 1
Abstract
This paper describes a case study to quantify the behavior of precast, prestressed-concrete bridge girders made with high-strength concrete. As part of the case study, four bridge girders made with 77.2-MPa (11.2-ksi) concrete were salvaged from a decommissioned bridge in Orem, Utah. Each girder was subjected to a flexural cracking test to determine a prestress loss of 22% after approximately 7 years of service life. Once the prestress losses were quantified, a flexural capacity test was performed on one girder. Shear capacity tests were performed at various distances from the support on the remaining three girders. The measured prestress losses and various capacities were compared with estimated values calculated according to procedures in current bridge specifications. The predicted flexural capacity was found to be 7.3% conservative compared with the measured capacity. The measured shear capacities were all within 12% conservative compared with the AASHTO shear procedures. In addition to the physical tests, a nonlinear finite-element analysis was conducted and was found to replicate the experimental behavior, failure mechanism, and magnitude.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (2012). LRFD bridge design specifications, 6th Ed., Washington, DC.
Ahlborn, T. M., French, C. E., and Shield, C. K. (2000). “High-strength concrete prestressed bridge girders: Long term and flexural behavior.” Final Rep. 2000-32, Minnesota DOT, St. Paul, MN.
Al-Omaishi, N., Tadros, M. K., and Seguirant, S. J. (2009). “Estimating prestress loss in pretensioned, high-strength concrete members.” PCI J., 54(4), 132–159.
ANSYS. (2009). Element reference, ANSYS, Canonsburg, PA.
ANSYS14 [Computer software]. Canonsburg, PA, ANSYS.
Baran, E., Shield, C. K., French, C. E., (2005). “A comparison of methods for experimentally determining prestress losses in pretensioned prestressed concrete girders.” Proc., Ned H. Burns Symp. on Historic Innovations in Prestressed Concrete (SP-231), American Concrete Institute, Detroit, 161–179.
Barr, P. J., Kukay, B. M., and Halling, M. W. (2008). “Comparison of prestress losses for a prestress concrete bridge made with high-performance concrete.” J. Bridge Eng., 468–475.
Bruce, R. N., Russell, H. G., and Roller, J. (2005). “Fatigue and shear behavior of HPC bulb-tee girders.” Rep. FHWA/LA.05/395, Louisiana Transportation Research Center, Baton Rouge, LA.
Caro, L. A., Marti-Vargas, J. R., and Serna, P. (2013a). “Prestressed losses evaluation in prestressed concrete prismatic specimens.” Eng. Struct., 48(Mar), 704–715.
Caro, L. A., Marti-Vargas, J. R., and Serna, P. (2013b). “Time-dependent evolution of strand transfer length in pretensioned prestressed concrete members.” Mech. Time-Depend. Mater., 17(4), 501–527.
Elzanaty, A. H., Nilson, A. H., and Slate, F. O. (1986). “Shear capacity of prestressed concrete beams using high-strength concrete.” ACI Struct. J., 83(3), 359–368.
Hawkins, N. M., and Kuchma, D. A. (2007). “Application of LRFD bridge design specifications to high-strength structural concrete: Shear provisions.” NCHRP Rep. 579, Transportation Research Board, Washington, DC.
Pastor, J. A. (1986). “High-strength concrete beams.” Ph.D. thesis, Dept. of Civil Engineering, Cornell Univ., Ithaca, NY.
Pessiki, S., Kaczinski, M., and Wescott, H. H. (1996). “Evaluation of effective prestress force in 28-year-old prestressed concrete bridge beams.” PCI J., 41(6), 78–89.
Rashid, M. A., and Mansur, M. A. (2005). “Reinforced high-strength concrete beams in flexure.” ACI Struct. J., 102(3), 462–471.
Rizkalla, S., Mirmiran, A., Zia, P., Russell, H., and Mast, R. (2007). “Application of the LRFD bridge design specifications to high-strength structural concrete: Flexure and compression provisions.” NCHRP Rep. 595, Transportation Research Board, Washington, DC.
Roller, J. J., Russell, H. G., Bruce, R. N., and Martin, B. T. (1995). “Long-term performance of prestressed, pretensioned high strength concrete bridge girders.” PCI J., 43(6), 48–59.
Shams, M. K., and Kahn, L. F. (2000). “Time-dependent behavior of high-strength concrete: Task 3, use of high strength/high performance concrete for precast prestressed concrete bridges in Georgia.” Structural Engineering, Mechanics, and Materials Research Rep. 00-1, Georgia Institute of Technology, Atlanta.
Tadros, M. K., Al-Omaishi, N., Segurant, S. J., and Gallt, J. G. (2003). “Prestress losses in pretensioned high-strength concrete bridge girders.” NCHRP Rep. 496, Transportation Research Board, Washington, DC.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 6, 2013
Accepted: May 2, 2014
Published online: Jun 4, 2014
Published in print: Jan 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.