Case Study for Tsunami Design of Coastal Infrastructure: Spencer Creek Bridge, Oregon
Publication: Journal of Bridge Engineering
Volume 20, Issue 1
Abstract
The absence of tsunami load provisions in coastal infrastructure design has led to unchecked resistance capacity of bridges against one of the most eminent natural hazards on the U.S. west coast. The Spencer Creek Bridge, which was completely rebuilt on the Oregon coast in 2009, is a unique example to demonstrate development and implementation of site-specific tsunami loads during the design stage. Two tsunami models, the Cornell Multigrid Coupled Tsunami model (COMCOT) and the Finite-Volume Wave model (FVWAVE), defined the flow fields from three rupture configurations postulated for a Cascadia earthquake, which has a moment magnitude of 9.0 consistent with the seismic design of the bridge structure. Although both models produce comparable surface elevations at the site, the finite-volume formulation of FVWAVE provides higher flow speed because of its capability to conserve momentum and mass even with formation of tsunami bores. The FVWAVE results define the input to the computational fluid dynamic module of LS-DYNA. The computed time history of the horizontal and vertical loads on the bridge deck, in turn, provide the input to a finite-element model of the bridge structure for capacity comparisons and damage analysis. It is concluded that the earthquake design specifications used for this particular bridge provide more than sufficient strength to resist the maximum tsunami horizontal force. The margin of safety is much smaller for the uplift force, but still remains in an acceptable range.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Partial support from the Oregon DOT (ODOT) under Work Order No. 06-09 to Oregon State University is gratefully acknowledged. The authors thank Professor Kwok Fai Cheung for his comments and suggestions that improved the presentation and layout of the paper. This publication is also partially funded by the Joint Institute for the Study of the Atmosphere and Ocean (JISAO) under NOAA Cooperative Agreement NA100AR4320148, JISAO Contribution 2182; PMEL Contribution 4087.
References
AASHTO. (2008). Guide specifications for bridges vulnerable to coastal storms, Washington, DC.
AASHTO. (2011). Guide specifications for LRFD seismic bridge design, 2nd Ed., Washington, DC.
AASHTO. (2012). LRFD bridge design specifications, 6th Ed., Washington, DC.
Akiyama, M., Frangopol, D. M., Arai, M., and Koshimura, S. (2012). “Probabilistic assessment of structural performance of bridges under tsunami hazard.” Proc., Structures Congress 2012, J. Carrato and J. Burns, eds., ASCE, Reston, VA.
Bea, R. G., Xu, T., Stear, J., and Ramos, R. (1999). “Wave forces on decks of offshore platforms.” J. Waterway, Port, Coastal, Ocean Eng., 136–144.
Burwell, D., Tolkova, E., and Chawla, A. (2007). “Diffusion and dispersion characterization of a numerical tsunami model.” Ocean Modell., 19(1–2), 10–30.
Cheung, K. F., Wei, Y., Yamazaki, Y., and Yim, S. C. (2011). “Modeling of 500-year tsunamis for probabilistic design of coastal infrastructure in the Pacific Northwest.” Coastal Eng., 58(10), 970–985.
Clague, J. J. (1997). “Evidence for large earthquakes at the Cascadia subduction zone.” Rev. Geophys., 35(4), 439–460.
Cuomo, G., Shimosako, K.-I., and Takahashi, S. (2009). “Wave-in-deck loads on coastal bridges and the role of air.” Coastal Eng., 56(8), 793–809.
Douglass, S. L., Chen, Q., and Olsen, J. M. (2006). Wave forces on bridge decks, Federal Highway Administration, Washington, DC.
Duncan, J. H. (1983). “The breaking and non-breaking wave resistance of a two-dimensional hydrofoil.” J. Fluid Mech., 126, 507–520.
Fritz, H. M., et al. (2012). “The 2011 Japan tsunami current velocity measurements from survivor videos at Kesennuma Bay using LiDAR.” Geophys. Res. Lett., 39(7), L00G23.
Goldfinger, C., Nelson, C. H., and Johnson, J. E., and Shipboard Scientific Party. (2003). “Holocene earthquake records from the Cascadia subduction zone and northern San Andreas Fault based on precise dating of offshore turbidites.” Annu. Rev. Earth Planet. Sci., 31, 555–577.
Iemura, H., Pradono, M. H., and Takahashi, Y. (2005). “Report on the tsunami damage on the bridges in Banda Aceh and some possible countermeasures.” Proc., 28th JSCE Earthquake Engineering Symp., Japan Society of Civil Engineers, Tokyo, 1–10.
Jacoby, G. C., Bunker, D. E., and Benson, B. E. (1997). “Tree-ring evidence for an AD 1700 Cascadia earthquake in Washington and northern Oregon.” Geology, 25(11), 999–1002.
Kajiura, K. (1970). “Tsunami source, energy and the directivity of wave radiation.” Bull. Earthq. Res. Inst. Univ. Tokyo, 48, 835–869.
Kataoka, S. (2006). “Scenarios of earthquake and tsunami disaster including damage to road bridges.” Proc., 22th US–Japan Bridge Engineering Workshop, Public Works Research Institute, Tsukuba, Japan.
Kawashima, K. (2012). “Damage of bridges due to the 2011 Great East Japan Earthquake.” Proc., Int. Symp. on Engineering Lessons Learned from the 2011 Great East Japan Earthquake, Japan Association of Earthquake Engineering, Tokyo, 82–101.
Kirby, S., Geist, E. L., Lee, W. H. K., Scholl, D., and Blakely, R. (2006). “Tsunami source characterization for western Pacific subduction zones: A preliminary report.” Proc., USGS Tsunami Sources Workshop, USGS, Washington, DC.
Kosa, K., Nii, S., Miyahara, K., and Shoji, M. (2010). “Experimental study for estimating tsunami forces acting on bridge girders.” Proc., 26th US–Japan Bridge Engineering Workshop, Public Works Research Institute, Tsukuba, Japan, 1–14.
Kowalik, Z., and Murty, T. S. (1993). “Numerical simulation of two-dimensional tsunami runup.” Mar. Geod., 16(2), 87–100.
Liu, P. L.-F., Cho, Y.-S., Briggs, M. J., Kanoglu, U., and Synolakis, C. E. (1995). “Runup of solitary waves on a circular island.” J. Fluid Mech., 302, 259–285.
LS-DYNA 971 R5 [Computer software]. Livermore, CA, Livermore Software Technology.
Marks, K. M., and Smith, W. H. F. (2006). “An evaluation of publicly available global bathymetry grids.” Mar. Geophys. Res., 27(1), 19–34.
Maruyama, K., Tanaka, Y., and Hosoda, A. (2012). “Damage of bridges structures by huge tsunami and evaluation of tsunami force on bridges.” Proc., 8th Int. Symp. on Social Management Systems, SSMS2012- Disaster Prevention and Reconstruction Management, United Nations Office for Disaster Risk Reduction, New York, 1–8.
Okada, Y. (1985). “Surface deformation due to shear and tensile faults in a half space.” Bull. Seismol. Soc. Am., 75(4), 1135–1154.
Potisuk, T., and McIntier, D. J. (2009). “Coastal connection.” Civil Eng. Mag., 79(9), 80–87.
Roeber, V., and Cheung, K. F. (2012). “Boussinesq-type model for energetic breaking waves in fringing reef environment.” Coastal Eng., 70, 1–20.
Roeber, V., Cheung, K. F., and Kobayashi, M. H. (2010). “Shock-capturing Boussinesq-type model for nearshore wave processes.” Coastal Eng., 57(4), 407–423.
Satake, K., Wang, K., and Atwater, B. F. (2003). “Fault slip and seismic moment of the 1700 Cascadia earthquake inferred from Japanese tsunami descriptions.” J. Geophys. Res., 108(B11), 2535.
Sugimoto, T., and Unjoh, S. (2007). “Hydraulic model tests on the bridge structures damaged by tsunami and tidal wave.” Proc., 23th US–Japan Bridge Engineering Workshop, Public Works Research Institute, Tsukuba, Japan, 1–10.
Titov, V. V., and Synolakis, C. E. (1995). “Modeling of breaking and nonbreaking long-wave evolution and runup using VTCS-2.” J. Waterway, Port, Coastal, Ocean Eng., 308–316.
Titov, V. V., and Synolakis, C. E. (1998). “Numerical modeling of tidal wave runup.” J. Waterway, Port, Coastal, Ocean Eng., 157–171.
Wei, Y., Cheung, K. F., Curtis, G. D., and McCreery, C. S. (2003). “Inverse algorithm for tsunami forecasts.” J. Waterway, Port, Coastal, Ocean Eng., 60–69.
Wei, Y., Mao, X. Z., and Cheung, K. F. (2006). “Well-balanced finite-volume model for long-wave runup.” J. Waterway, Port, Coastal, Ocean Eng., 114–124.
Yamazaki, Y., Cheung, K. F., and Kowalik, Z. (2011). “Depth-integrated, non-hydrostatic model with grid nesting for tsunami generation, propagation, and run-up.” Int. J. Numer. Methods Fluids, 67(12), 2081–2107.
Yamazaki, Y., Cheung, K. F., and Lay, T. (2013). “Modeling of the 2011 Tohoku near-field tsunami from finite-fault inversion of seismic waves.” Bull. Seismol. Soc. Am., 103(2b), 1444–1455.
Yamazaki, Y., Kowalik, Z., and Cheung, K. F. (2009). “Depth-integrated, non-hydrostatic model for wave breaking and run-up.” Int. J. Numer. Methods Fluids, 61(5), 473–497.
Yamazaki, Y., Wei, Y., Cheung, K. F., and Curtis, C. D. (2006). “Forecast of tsunamis generated at the Japan-Kuril-Kamchatka source region.” Nat. Hazards, 38(3), 411–435.
Yashinsky, M. (2012). “Lessons for Caltrans from the 2011 great Japan earthquake and tsunami.” Proc., Int. Symp. on Engineering Lessons Learned from the 2011 Great East Japan Earthquake, Japan Association of Earthquake Engineering, Tokyo, 1417–1428.
Yim, S. C., Cheung, K. F., Olsen, M. J., and Yamazaki, Y. (2012). “Tohoku tsunami survey, modeling and probabilistic load estimation applications.” Proc., Int. Symp. on Engineering Lessons Learned from the 2011 Great East Japan Earthquake, Japan Association of Earthquake Engineering, Tokyo, 430–443.
Yim, S. C., Olsen, M. J., Cheung, K. F., and Azadbakht, M. (2014). “Tsunami modeling, fluid load simulation, and validation using geospatial field data.” J. Struct. Eng., A4014012.
Zhou, J. G., Causon, D. M., Mingham, C. G., and Ingram, D. M. (2001). “The surface gradient method for the treatment of source terms in the shallow-water equations.” J. Comput. Phys., 168(1), 1–25.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 22, 2014
Accepted: Mar 27, 2014
Published online: May 13, 2014
Published in print: Jan 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.