Aerodynamic Characteristics of Airfoil Cruise Landing and High Lift Configurations in Simulated Rain Environment
Publication: Journal of Aerospace Engineering
Volume 28, Issue 5
Abstract
In this paper, heavy rain effects on the aerodynamic efficiency of National Advisory Committee for Aeronautics (NACA) 23015 airfoil cruise and landing configurations and NACA 64210 high lift configuration have been studied. For this study, preprocessing software Gridgen has been used for creation of geometry and mesh, and fluent software is used as a solver. Discrete phase modeling (DPM) in a Langrangian frame of reference has been used to simulate the rain particles dispersed in continuous phase using two-phase flow approach. The coupling between the two phases and its impact on both phases has been included. In discrete phase model (DPM), the wall film is modeled by the injected rain particles. In a simulated rain environment all the cruise, landing, and high lift configurations of airfoils showed a significant decrease in lift and increase in drag in heavy rain environment. In this study, it is found that the heavy rain causes premature boundary-layer transition at low angle of attack (AOA) and separation at high AOA. The water film layer formed on the surface of the airfoil is thought to alter the airfoil geometry and increase the mass effectively. In the simulation for NACA 23105 the increase in drag is less contrary to simulations done for NACA 64210 high lift configuration airfoil, for which the aerodynamic efficiency degradation is much higher. The relative differences appeared to be related to the susceptibility of each airfoil to premature boundary-layer transition. Postprocessing software like MATLAB, Tec plot, and Origin are used to see the effects of the heavy rain, and the results obtained are compared with the experimental results. It is strongly believed that this study will be useful for the aviation engineers and scientists to design the airplanes and UAVs capable of flying in severe weather conditions and to train the pilots to control the airplane in heavy rain conditions well.
Get full access to this article
View all available purchase options and get full access to this article.
References
Apte, S. V., Gorokhovski, M., and Moin, P. (2003). “LES of atomizing spray with stochastic modeling of secondary breakup.” Int. J. Multiphase Flow, 29(9), 1503–1522.
Ashenden, R., Lindberg, W., and Marwitz, J. (1996). “Two-dimensional NACA 23012 airfoil performance degradation by super-cooled cloud, drizzle, and rain drop icing.” AIAA 34th Aerospace Sciences Meeting, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Bezos, G. M., Campbell, B. A., and Monta, W. J. (1993). “Development of a large-scale, outdoor, ground-based test capability for evaluating the effect of rain on airfoil lift (Vol. 4420).” National Aeronautics and Space Administration, Office of Management, Science and Technical Information Program.
Bezos, G. M., Dunham, R. E., Gentry, G. L., and Melson, W. E., Jr. (1992). “Wind tunnel aerodynamic characteristics of a transport-type airfoil in a simulated heavy rain environment.” National Aeronautics and Space Administration, Office of Management, Scientific and Technical Information Program.
Bilanin, A. J. (1987). “Scaling laws for testing airfoils under heavy rainfall.” J. Aircr., 24(1), 31–37.
Busch, H., et al. (1966). “Rain erosion properties of materials [and discussion].” Philos. Trans. R. Soc. London, Ser. A, Math. Phys. Sci., 260(1110), 168–181.
Calarese, W., and Hankey, W. (1984). “Numerical analysis of rain effects on an airfoil.”, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Campbell, B., and Bezos, G. (1989). “Steady-state and transitional aerodynamic characteristics of a wing in simulated heavy rain.”.
Cao, Y., Wu, Z., and Xu, Z. (2014). “Effects of rainfall on aircraft aerodynamics.” Prog. Aerospace Sci., 71, 85–127.
Craig, A. P., and Hansman, R. J. (1987). “An experimental low Reynolds number comparison of a Wortmann FX67-Kl70 airfoil, A NACA 0012 airfoil, and A.” J. Aircr., 24(8), 559–566.
Dunham, R., Jr. (1986). “Potential influences of heavy rain on general aviation airplane performance.”, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Dunham, R. E., Jr., Bezos, G. M., Gentry, G. L., Jr., and Melson, E., Jr. (1985). “Two-dimensional wind tunnel tests of a transport-type airfoil in a water spray.” AIAA 23rd Aerospace Sciences Meeting, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Eleni, D. C., Athanasios, T. I., and Dionissios, M. P. (2012). “Evaluation of the turbulence models for the simulation of the flow over a national advisory committee for aeronautics (NACA) 0012 airfoil.” J. Mech. Eng. Res., 4(3), 100–111.
Gibson, C. M., et al. (1993). “Relation of vessel wall shear stress to atherosclerosis progression in human coronary arteries.” Arteriosclerosis, Thrombosis, Vascular Biol., 13(2), 310–315.
Haines, P., and Luers, J. (1983). “Aerodynamic penalties of heavy rain on landing airplanes.” J. Aircr., 20(2), 111–119.
Han, Z., Xu, Z., and Trigui, N. (2000). “Spray/wall interaction models for multidimensional engine simulation.” Int. J. Eng. Res., 1(1), 127–146.
Hansman, R., and Barsotti, M. (1985). “The aerodynamic effect of surface wetting characteristics on a laminar flow airfoil in simulated heavy rain.” 23rd Aerospace Sciences Meeting, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Harlow, F. H., and Welch, J. E. (1965). “Numerical calculation of time-dependent viscous incompressible flow of fluid with free surface.” Phys. Fluids, 8(12), 2182.
Hastings, E., and Manuel, G. (1985). “Scale-model tests of airfoils in simulated heavy rain.” J. Aircr., 22(6), 536–540.
Ismail, M., Yihua, C., Bakar, A., and Wu, Z. (2014). “Aerodynamic efficiency study of 2D airfoils and 3D rectangular wing in heavy rain via two-phase flow approach.” Proc. Inst. Mech. Eng. Part G: J. Aerospace Eng., 228(7), 1141–1155.
Ismail, M., Yihua, C., Ming, Z., and Bakar, A. (2012). “Numerical study of airfoils aerodynamic performance in heavy rain environment.” World Acad. Sci. Eng. Tech., 67, 1052–1060.
Joss, J., and Waldvogel, A. (1969). “Raindrop size distribution and sampling size errors.” J. Atmos. Sci., 26(3), 566–569.
Lian, Y., and Shyy, W. (2007). “Laminar-turbulent transition of a low Reynolds number rigid or flexible airfoil.” AIAA J., 45(7), 1501–1513.
Luers, J. K. (1983). “Heavy rain effects on aircraft.” American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Luers, J. K., and Haines, P. A. (1983). “Experimental measurements of rain effects on aircraft aerodynamics.” AIAA 21st Aerospace Sciences Meeting, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Marchman, J. F., III, Robertson, E. A., and Emsley, H. T. (1987). “Rain effects at low Reynolds number.” J. Aircr., 24(9), 638–644.
Markowitz, A. H. (1976). “Raindrop size distribution expressions.” J. Appl. Meteorol., 15(9), 1029–1031.
Melson, W., Jr (1989). “The development of a capability for aerodynamic testing of large-scale wing sections in a simulated natural rain environment.” 27th Aerospace Sciences Meeting, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Mundo, C., Sommerfeld, M., and Tropea, C. (1998). “On the modeling of liquid sprays impinging on surfaces.” Atomization Sprays, 8(6), 625–652.
Mundo, C. H. R., Sommerfeld, M., and Tropea, C. (1995). “Droplet-wall collisions: Experimental studies of the deformation and breakup process.” Int. J. Multiphase Flow, 21(2), 151–173.
Ojha, M., Cobbold, R. S., and Johnston, K. W. (1994). “Influence of angle on wall shear stress distribution for an end-to-side anastomosis.” J. Vasc. Surg., 19(6), 1067–1073.
O’Rourke, P., and Amsden, A. (1996). A particle numerical model for wall film dynamics in port-injected engines, Los Alamos National Lab, NM.
O’Rourke, P. J., and Amsden, A. (2000). “A spray/wall interaction submodel for the KIVA-3 wall film model.” SAE Trans., 109(3), 281–298.
Rhode, R. V. (1941). “Some effects of rainfall on flight of airplanes and on instrument indication.” National Aeronautics and Space Administration Langley Research Center, Hampton, VA.
Riordan, P. (1974). “Weather extremes around the world.” Army Engineer Topographic Laboratories, Fort Belvoir, VA.
Salem, S., and Al-Hassani, S. (1983). “Penetration by high speed oblique jets: Theory and experiment.” Int. J. Mech. Sci., 25(12), 871–886.
Springer, G. S. (1976). “Erosion by liquid impact.” Scripta Publishing, Washington, DC.
Steinbrenner, J. P., Chawner, J. P., and Fouts, C. L. (1991). “The GRIDGEN 3D multiple block grid generation system.” User’s manual, Vol. 2, General Dynamics, Fort Worth, TX.
Thompson, B., Jang, J., and Dion, J. L. (1995). “Wing performance in moderate rain.” J. Aircr., 32(5), 1034–1039.
Thompson, B. E., and Jang, J. (1996). “Aerodynamic efficiency of wings in rain.” J. Aircr., 33(6), 1047–1053.
Valentine, J. (1994). “Airfoil performance in heavy rain.”, Transportation Research Board, Washington, DC.
Valentine, J., and Decker, R. (1995a). “A Lagrangian-Eulerian scheme for flow around an airfoil in rain.” Int. J. Multiphase Flow, 21(4), 639–648.
Valentine, J. R., and Decker, R. A. (1995b). “Tracking of raindrops in flow over an airfoil.” J. Aircr., 32(1), 100–105.
Venkatesh, E. (1986). “Erosion damage in oil and gas wells.” SPE Rocky Mountain Regional Meeting, Society of Petroleum Engineers.
Wan, T., Lin, J. X., and Kuan, H. C. (2013). “Aerodynamic analysis of helicopter rotor blades in heavy rain condition.” 51st AIAA Aerospace Sciences Meeting including the New Horizons Forum and Aerospace Exposition, American Institute of Aeronautics and Astronautics (AIAA), Reston, VA.
Wan, T., and Pan, S.-P. (2010). “Aerodynamic efficiency study under the influence of heavy rain via two-phase flow approach.” Proc., 27th Int. Congress of Aeronautical Sciences (ICAS), Nice, France.
Wan, T., and Wu, S.-W. (2004). “Aerodynamic analysis under influence of heavy rain.” J. Aeronaut. Astronaut. Aviat., 41(3), 173–180.
Wan, T., and Yang, H. (2010). “Aerodynamic performance investigation of a modern blended-wing-body aircraft under the influence of heavy rain condition.” Proc., 27th Int. Congress of Aeronautical Sciences (ICAS), Nice, France.
White, F. M., and Corfield, I. (1991). “Viscous fluid flow (Vol. 3).” McGraw-Hill, New York.
Zhang, R., and Cao, Y. (2010). “Study of aerodynamic characteristics of an airfoil in rain.” J. Aerospace Power, 25(9), 2064–2069.
Zhang, R., and Cao, Y. (2011). “Mechanisms research of rain effects on airfoil aerodynamic performance.” Flight Dyn., 29(1), 70–73.
Information & Authors
Information
Published In
Journal of Aerospace Engineering
Volume 28 • Issue 5 • September 2015
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Mar 19, 2014
Accepted: Sep 9, 2014
Published online: Oct 21, 2014
Discussion open until: Mar 21, 2015
Published in print: Sep 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.