Static and Fatigue Analyses of RC Beams Strengthened with CFRP Laminates
Publication: Journal of Composites for Construction
Volume 5, Issue 4
Abstract
Extensive testing has shown that externally bonded carbon fiber reinforced polymer (CFRP) laminates are particularly suited for improving the short-term behavior of deficient reinforced concrete beams. Accelerated fatigue tests conducted to date confirm that fatigue response is also improved. This paper describes an analytical model for simulating the static response and accelerated fatigue behavior of reinforced concrete beams strengthened with CFRP laminates. Static and fatigue calculations are carried out using a fiber section model that accounts for the nonlinear time-dependent behavior of concrete, steel yielding, and rupture of CFRP laminates. Analysis results are compared with experimental data from two sets of accelerated fatigue tests on CFRP strengthened beams and show good agreement. Cyclic fatigue causes a time-dependent redistribution of stresses, which leads to a mild increase in steel and CFRP laminate stresses as fatigue life is exhausted. Based on the findings, design considerations are suggested for the repair and/or strengthening of reinforced concrete beams using CFRP laminates.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
American Concrete Institute (ACI). ( 1974). “Considerations for design of concrete structures subjected to fatigue loading.” ACI Rep. 215-74, Detroit.
2.
American Concrete Institute (ACI). ( 1999). “Building code requirements for structural concrete.” ACI 318-99, Detroit.
3.
Bakht, B., et al. (2000). “Canadian Bridge Design Code provisions for fiber-reinforced structures.”J. Compos. for Constr., ASCE, 4(1), 3–15.
4.
Barnes, R. A., and Mayes, G. C. (1999). “Fatigue performance of concrete beams strengthened with CFRP plates.”J. Compos. for Constr., ASCE, 3(2), 63–72.
5.
Barsom, J. M., and Rolfe, S. T. ( 1987). Fracture and fatigue control in structures, Prentice-Hall, Englewood Cliffs, N.J.
6.
Bazant, Z. P. ( 1988). Mathematical modeling of creep and shrinkage of concrete, Wiley, New York.
7.
Bennet, E. W., and Raju, N. K. ( 1971). “Cumulative fatigue damage of plain concrete in compression.” Structure, solid mechanics and engineering design, Wiley-Interscience, London, 1089–1102.
8.
Corley, W. G., Hanson, J. M., and Helgason, T. (1978). “Design of reinforced concrete for fatigue.”J. Struct. Div., ASCE, 104(6), 921–932.
9.
El-Tawil, S., Sanz-Picon, C. F., and Deierlein, G. G. ( 1995). “Evaluation of ACI-318 and AISC (LRFD) strength provisions for composite columns.” J. Constr. Steel Res., 34(1), 103–126.
10.
Holmen, J. O. ( 1982). “Fatigue of concrete by constant and variable amplitude loading.” Fatigue of concrete structures, American Concrete Institute, Detroit, 71–110.
11.
Holloway, L. C., and Leeming, M. B. ( 1999). Strengthening of reinforced concrete structures: Using externally-bonded FRP composites in structural and civil engineering, CRC Press, Boca Raton, Fla.
12.
Hull, D. ( 1981). An introduction to composite materials, Cambridge University Press, London.
13.
Inoue, S., Nishibayashi, S., Kuroda, T., and Omata, F. ( 1995). “Fatigue strength and deformation characteristics of reinforced concrete beams strengthened with carbon fiber-reinforced plastic plates.” Trans., Japan Concrete Inst., 17, 149–156.
14.
Meier, U., Deuring, M., Meier, H., and Schwegler, G. ( 1992). “Strengthening of structures with CFRP laminates: Research and applications in Switzerland.” Advanced composite materials in bridges and structures, K. W. Neale and P. Labossiere, eds., Canadian Society for Civil Engineering, Montreal.
15.
Moustafa, S. E. ( 1986). “Nonlinear analysis of reinforced and prestressed concrete members.” Prestressed Concrete Inst. J., 31(5), 126–147.
16.
Neville, A. M. ( 1996). Properties of concrete, 4th Ed., Wiley, New York.
17.
Okeil, A. M., El-Tawil, S., and Shahawy, M. ( 2000). “Short-term tensile strength of CFRP laminates for flexural strengthening of concrete girders.” ACI Struct. J., 98(4), 470–478.
18.
Plevris, N., and Triantafillou, T. C. (1994). “Time-dependent behavior of RC members strengthened with FRP laminates.”J. Struct. Engrg., ASCE, 120(3), 1016–1042.
19.
Plevris, N., Triantafillou, T. C., and Venesiano, D. (1995). “Reliability of RC members strengthened with CFRP laminates.”J. Struct. Engrg., ASCE, 121(7), 1037–1044.
20.
Popovics, S. ( 1970). “A review of stress-strain relationships for concrete.” ACI Struct. J., 67(3), 243–248.
21.
Rao, A. S. P., and Jayaraman, R. (1989). “Creep and shrinkage analysis of partially prestressed concrete members.”J. Struct. Engrg., ASCE, 115(5), 1169–1189.
22.
Saadatmanesh, H., and Malek, A. M. (1998). “Design guidelines for flexural strengthening of RC beams with FRP plates.”J. Compos. for Constr., ASCE, 2(4), 158–164.
23.
Shahawy, M., and Beitelman, T. E. ( 2000). Static and fatigue performance of RC beams strengthened with CFRP laminates, Struct. Res. Ctr., Florida Department of Transportation, Tallahassee, Fla.
24.
Shahawy, M., and Beitelman, T. E. (1999). “Static and fatigue performance of RC beams strengthened with CFRP laminates.”J. Struct. Engrg., ASCE, 125(6), 613–621.
25.
Shahawy, M. A., Arockiasamy, M., Beitelman, T., and Sowrirajan, R. ( 1996). “Reinforced concrete rectangular beams strengthened with CFRP laminates.” Compos., Part B, 27B, 225–233.
26.
Thorenfeldt, E., Tomaszewicz, A., and Jensen, J. J. ( 1987). “Mechanical properties of high strength concrete and application in design.” Proc., Symp. Utilization of High Strength Concrete, Tapir, Trondheim, Norway, 149–159.
Information & Authors
Information
Published In
History
Received: Aug 11, 2000
Published online: Nov 1, 2001
Published in print: Nov 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.