Interference of Two Closely Spaced Strip Footings on Sand Using Model Tests
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 135, Issue 4
Abstract
By using small scale model tests, the interference effect on the ultimate bearing capacity of two closely spaced strip footings, placed on the surface of dry sand, was investigated. At any time, the footings were assumed to (1) carry exactly the same magnitude of load; and (2) settle to the same extent. No tilt of the footing was allowed. The effect of clear spacing (s) between two footings was explicitly studied. An interference of footings leads to a significant increase in their bearing capacity; the interference effect becomes even more substantial with an increase in the relative density of sand. The bearing capacity attains a peak magnitude at a certain (critical) spacing between two footings. The experimental observations presented in this technical note were similar to those given by different available theories. However, in a quantitative sense, the difference between the experiments and theories was seen to be still significant and it emphasizes the need of doing a further rigorous analysis in which the effect of stress level on the shear strength parameters of soil mass can be incorporated properly.
Get full access to this article
View all available purchase options and get full access to this article.
References
Banimahd, M., and Woodward, P. K. (2006). “Load–displacement and bearing capacity of foundations on granular soils using a multi-surface kinematic constitutive soil model.” Int. J. Numer. Analyt. Meth. Geomech., 30(9), 865–886.
Bowles, J. E. (1997). Foundation analysis and design, McGraw-Hill, New York.
Clark, J. I. (1998). “The settlement and bearing capacity of very large foundations on strong soils: The 1996 R. M. Hardy lecture.” Can. Geotech. J., 35(1), 131–145.
Das, B. M., and Larbi-Cherif, S. (1983). “Bearing capacity of two closely-spaced shallow foundations on sand.” Soils Found., 23(1), 1–7.
Das, B. M., and Omar, M. T. (1994). “The effects of foundation width on model tests for the bearing capacity of sand with geogrid reinforcement.” Geotech. Geologic. Eng., 12(2), 133–141.
De Beer, E. E. (1965). “Bearing capacity and settlement of shallow foundations on sand.” Proc., Bearing Capacity and Settlement of Foundations Symp., Duke University, Durham, 15–34.
Kumar, A., and Saran, S. (2003). “Closely spaced footings on geogrid-reinforced sand.” J. Geotech. Geoenviron. Eng., 129(7), 660–664.
Kumar, J., and Ghosh, P. (2007a). “Ultimate bearing capacity of two interfering rough strip footings.” Int. J. Geomech., 7(1), 53–62.
Kumar, J., and Ghosh, P. (2007b). “Upper bound limit analysis for finding interference effect of two nearby strip footings on sand.” Geotech. Geologic. Eng., 25(5), 499–507.
Kumar, J., and Kouzer, K. M. (2007). “Bearing capacity of two interfering footings.” Int. J. Numer. Analyt. Meth. Geomech., 32(3), 251–264.
Lancelot, L., Shahrour, I., and Mahmoud, M. A. (2006). “Failure and dilatancy properties of sand at relatively low stresses.” J. Eng. Mech., 132(12), 1396–1399.
Lyamin, A. V., and Sloan, S. W. (2002). “Lower bound limit analysis using non-linear programming.” Int. J. Numer. Methods Eng., 55(5), 573–611.
Meyerhof, G. G. (1963). “Some recent research on the bearing capacity of foundations.” Can. Geotech. J., 1(1), 16–26.
Perkins, S., and Madson, C. (2000). “Bearing capacity of shallow foundations on sand: A relative density approach.” J. Geotech. Geoenviron. Eng., 126(6), 521–530.
Saran, S., and Agarwal, V. C. (1974). “Interference of surface footings on sand.” Indian Geotech. J., 4(2), 129–139.
Sloan, S. W. (1988). “Lower bound limit analysis using finite elements and linear programming.” Int. J. Numer. Analyt. Meth. Geomech., 12(1), 61–77.
Sloan, S. W. (1989). “Upper bound limit analysis using finite elements and linear programming.” Int. J. Numer. Analyt. Meth. Geomech., 13(3), 263–282.
Sloan, S. W., and Kleeman, P. W. (1995). “Upper bound limit analysis using discontinuous velocity fields.” Comput. Methods Appl. Mech. Eng., 127(1), 293–314.
Stuart, J. G. (1962). “Interference between foundations, with special reference to surface footings in sand.” Geotechnique, 12(1), 15–22.
West, J. M., and Stuart, J. G. (1965). “Oblique loading resulting from interference between surface footings on sand.” Proc., 6th Int. Conf. on Soil Mechanics and Foundation Engineering, Montreal, Vol. 2, 214–217.
Zhu, F., Clark, J. I., and Phillips, R. (1998). “Bearing capacity of ring foundations under vertical load.” Proc., Int. Conf. Centrifuge ’98, T. Kimura, O. Kusakabe, and T. Takemura, eds., Balkema, Rotterdam, The Netherlands, 441–446.
Zhu, F., Clark, J. I., and Phillips, R. (2001). “Scale effect of strip and circular footings resting on dense sand.” J. Geotech. Geoenviron. Eng., 127(7), 613–621.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 12, 2007
Accepted: May 31, 2008
Published online: Apr 1, 2009
Published in print: Apr 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.