Initial Shear Modulus of Remolded Sand-Clay Mixtures
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 7
Abstract
This paper presents the dynamic properties of undisturbed and remolded clays and sand-clay mixtures based on the results of undrained hollow cylindrical torsional cyclic simple shear tests. The clays were obtained from different sites having a wide range of plasticity, covering fluvial and marine sediments. The main focus of this investigation is the dynamic properties of sand-clay mixtures whose properties are intermediate between those of clays and sands. The initial shear moduli are examined in terms of fines content, and conventional plasticity index. An equivalent plasticity index has been defined in the present investigation and a better correlation is obtained between the initial shear modulus of sand-clay mixtures and this parameter than with the conventional plasticity index. Further, a simple method has been suggested to determine the equivalent plasticity index based on the conventional consistency limit tests and grain size analysis. An empirical correlation for predicting the initial shear modulus is also proposed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The fourth author (S. V. Dinesh) would like to thank the NPEEE and DST (Seismology) Division (No. DST/23(534)/SU/2005) for the financial support extended to him.
References
ASTM. (2005). “Standard test methods for liquid limit, plastic limit, and plasticity index of soils.” ASTM D4318-05, Philadelphia.
Coastal Development Institute of Technology (CDIT). (1997). Handbook on liquefaction remediation of reclaimed lands, Revised Ed., Yokosuka, Japan, 66–69 (in Japanese).
Hardin, B. O., and Black, W. L. (1966). “Sand stiffness under various triaxial stresses.” J. Soil Mech. and Found. Div., 92(2), 27–42.
Hardin, B. O., and Black, W. L. (1968). “Vibration modulus of normally consolidated clay.” J. Soil Mech. and Found. Div., 94(2), 353–369.
Hardin, B. O., and Black, W. L. (1969). “Closure to vibration modulus of normally consolidated clay.” J. Soil Mech. and Found. Div., 95(6), 1531–1537.
Hardin, B. O., and Drnevich, V. P. (1972). “Shear modulus and damping in soils: Design equations and curves.” J. Soil Mech. and Found. Div., 98(7), 667–692.
Hardin, B. O., and Richart, F. E., Jr. (1963). “Elastic wave velocities in granular soils.” J. Soil Mech. and Found. Div., 89(1), 33–65.
Iwasaki, T., and Tatsuoka, F. (1977). “Effects of grain size and grading on dynamic shear moduli of sands.” Soils Found., 17(3), 19–35.
Iwasaki, T., Tatsuoka, F., and Takagi, Y. (1978). “Shear moduli of sands under cyclic torsional shear loading.” Soils Found., 18(1), 39–59.
Japan Port and Harbour Association (JPHA). (1999). Technical standards for port and harbour facilities and commentaries, Vol. 1, Tokyo (in Japanese).
Japanese Geotechnical Society (JGS). (1992). “Intermediate Soil—Is it sand or clay?” Geotech-Note No. 2, Tokyo (in Japanese).
Japanese Geotechnical Society (JGS). (2000a). “Method of classification of geomaterials for engineering purposes.” JGS 0051-2000, Tokyo (in Japanese).
Japanese Geotechnical Society (JGS). (2000b). “Method for cyclic torsional shear test on hollow cylindrical specimens to determine deformation properties of soils.” JGS 0543-2000, Tokyo (in Japanese).
Japanese Society of Soil Mechanics and Foundation Engineering (JSSMFE). (1979). Soil testing manual, Tokyo, 516 (in Japanese).
Japanese Standard Association (JSA). (1999). “Test method for liquid limit and plastic limit of soils.” JIS A 1205, Tokyo (in Japanese).
Jardine, R. J. (1992). “Some observations of the kinematic nature of soil stiffness.” Soils Found., 32(2), 111–124.
Kamei, T., Ogawa, S., and Tanaka, N. (1987). “The variation in undrained shear characteristics during consolidation process.” Soils Found., 27(3), 91–98.
Kokusho, T. (1980). “Cyclic triaxial test of dynamic soil properties for wide strain range.” Soils Found., 20(2), 45–60.
Kokusho, T., Yoshida, Y., and Esashi, Y. (1982). “Dynamic properties of soft clay for wide strain range.” Soils Found., 22(4), 1–18.
Marcuson, W. E., and Wahls, H. E. (1972). “Time effects on dynamic shear modulus of clays.” J. Soil Mech. and Found. Div., 98(12), 1359–1373.
Omine, K., Ochiai, H., and Yoshida, N. (1994) “Deformation-strength properties of intermediate soils under triaxial conditions.” Proc., Int. Symp. on Pre-Failure Deformation Characteristics of Geomaterials, Balkema, Rotterdam, 407–413.
Seed, H. B., and Idriss, I. M. (1970). “Soils moduli and damping factors for dynamic response analysis.” Rep. of Earthquake Engineering Research Center No. EERC 70-10, Univ. of California, Calif.
Shibuya, S., Mitachi, T., Fukuda, F., and Degoshi, T. (1995). “Strain rate effect on the shear modulus and damping of normally consolidated clay.” Geotech. Test. J., 18(3), 365–375.
Tatsuoka, F., Shibuya, S., and Kuwano, R. (2001). Advanced laboratory stress-strain testing of geomaterials, Balkema, Rotterdam, The Netherlands, 92–110.
Yamada, S., Hyodo, M., Orense, R., Dinesh, S. V., and. Hyodo, T. (2008). “Strain-dependent dynamic properties of remolded sand-clay mixtures.” J. Geotech. Geoenviron. Eng., 134(7), 972–981.
Zen, K., Umehara, Y., and Hamada, K. (1978). “Laboratory tests and in-situ seismic survey on vibratory shear modulus of clayey soils with various plasticities.” Proc. 5th Japanese Symp. on Earthquake Engineering, Architectural Institute of Japan, Tokyo, 721–728.
Zen, K., Yamazaki, H., and Umehara, Y. (1987). “Experimental study on dynamic properties of soils for use in seismic response analysis.” Rep. of Port and Harbour Research Institute, Vol. 26, No. 1, Port and Harbour Research Institute, Yokosuka, Japan (in Japanese).
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Oct 24, 2006
Accepted: Feb 20, 2007
Published online: Jul 1, 2008
Published in print: Jul 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.