Laboratory Investigation on Reactivated Residual Strength
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 134, Issue 3
Abstract
Recent research has outlined that mobilized in situ strength at the reactivation of displacements along a preexisting sliding surface may be slightly greater than laboratory residual strength. Although geotechnical literature explains this difference in various ways—for instance, strength gain due to soil aging—little work has been devoted to this topic. Bromhead ring shear tests were carried out on remolded samples of the Cormons flysch, a typical geological formation in northeastern Friuli-Venezia Giulia (Italy). The specimens came from the shallow weathered crust of the Cormons flysch, near the areas of Montona and Rosazzo. This experimental study aimed at highlighting the effect of a limited number of parameters on strength gain at the reactivation of displacements along aged sliding surfaces. The results of this research confirm that aging may cause a rising of reactivated shear strength above the residual value, depending on time of aging and vertical stress. The longest aging period—about a month—showed a 20% strength increase for the Rosazzo flysch, and a 30% increase for the Montona flysch. Reactivated strength increases according to a power law: Almost 50% develops over a short time, i.e., after of aging. In the long term, strength growth is characterized by a deviatoric creep rate gradually approaching zero.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bellino, S., and Maugeri, M. (1985). “Confronto tra valori di resistenza residua ottenuti con diverse apparecchiature anulari di taglio.” Riv. Ital. Geotec., 2, 101–114.
Bjerrum, L. (1967). “Engineering geology of Norwegian normally consolidated marine clays as related to settlements of buildings.” 7th Rankine Lecture, Geotechnique, 17(2), 81–118.
Carrubba, P., Meriggi, R., and Del Fabbro, M. (2004). “Reactivated shear strength for the Montona flysch clay.” Proc., Int. Symp. Interpraevent 2004, Riva del Garda, Trento, Italy, Vol. III, Part IV, 69–79.
Carrubba, P., Meriggi, R., and Nadin, M. (2003). “Ageing and stress history effects on reactivated residual strength of Cormons flysch.” Proc., Int. Conf. on Fast Slope Movements: Prediction and Prevention for Risk Mitigation, Naples, Italy, 79–84.
Chandler, R. J. (1984). “Recent European experience in landslides in over-consolidated clays and soft rocks.” Proc., 4th Int. Symp. Landslides, Toronto, Canada, 1, 61–81.
Cotecchia, V. (1998). “La grande frana di Ancona. Caratteri evolutivi e criteri di stabilizzazione dell’area mobilizzatasi nel 1982.” Quarry and Construction, 81–94.
D’Appolonia, E., Alperstein, R., and D’Appolonia, D. J. (1967). “Behaviour of a colluvial slope.” J. Soil Mech. and Found. Div., 93(4), 447–473.
D’Elia, B., Esu, F., Pellegrino, A., and Pescatore, T. S. (1985). “Some effects on natural slope stability induced by the 1980 Italian earthquake.” Proc., 11th Int. Conf. on Soil Mech. Found. Eng., Vol. IV, 1943–1950.
D’Elia, B., Pescatore, T. S., Rippa, F., and Tancredi, G. (1986). “Occurrence and development of a large landslide (Andretta, Italy) reactivated by the Nov. 23, 1980 earthquake.” Proc., Int. Symp. Eng. Geol. Problems in Seismic Areas, Vol. II, Bari, Italy, 365–381.
D’Elia, B., Picarelli, L., Leroueil, S., and Vaunat, J. (1998). “Geotechnical characterisation of slope movements in structurally complex clay soils and stiff jointed clays.” Riv. Ital. Geotec., 3, 5–47.
Di Maio, C., and Fenelli, G. B. (1994). “Residual strength of kaolin and bentonite: The influence of their constituent pore fluid.” Geotechnique, 44(4), 217–226.
Fenelli, G. B., and Picarelli, L. (1986). “Instabilità di una trincea in argille a scaglie.” Proc., 20th Conv. Naz. Stradale, Vol. I, Cagliari, Italy, 81–86.
Gibo, S., Egashira, K., Ohtsubo, M., and Nakamura, S. (2002). “Strength recovery from residual state in reactivated landslides.” Geotechnique, 52(9), 683–686.
Grim, R. E. (1962). Applied clay mineralogy, McGraw-Hill, New York.
Hutchinson, J. N. (1987). “Mechanisms producing large displacements in landslides on pre-existing shears.” Mem. Geol. Soc. of China, 9, 175–200.
Kenney, T. C. (1977). “Residual strength of mineral mixture.” Proc., 10th I.C.S.M.F.E., Vol. 1, 155–160.
Larini, G., Marchi, G., Pellegrini, M., and Tellini, C. (1996). “La grande frana di Corniglio (Appennino Settentrionale, Provincia di Parma), riattivata negli anni 1994–1996.” Proc. Convegno Internazionale: La prevenzione delle catastrofi idrogeologiche—II contributo della ricerca scientifica, Alba, Cuneo, Italy, 505–516.
Lemos, L. J. L. (2003). “Shear behaviour of pre-existing shear zones under fast loading—Insights on the landslide motion.” Proc., Int. Work.: Occurrence and Mechanisms of Flow-Like Landslides in Natural Slopes and Earthfills, Sorrento, Italy, 229–236.
Leroueil, S. (2001). “Natural slopes and cuts: Movement and failure mechanisms.” 39th Rankine Lecture, Geotechnique, 51(3), 197–243.
Leroueil, S. (2003). “Soil mechanics in the context of slopes.” Proc., Conferenze di Geotecnica di Torino, Torino, Vol. 19.01.
Lupini, J. F., Skinner, A. E., and Vaughan, P. R. (1981). “The drained residual strength of cohesive soils.” Geotechnique, 31(31), 181–213.
Martinis, B. (1962). “Ricerche geologiche e paleontologiche sulla regione compresa tra il torrente Iudrio e il fiume Timavo.” Riv. Ital. Pal. Strat., Milano, Mem., 8, 70–83.
Miscevic, P. (1998). “The investigation of weathering process in eocene flysch.” Proc., 2nd Int. Symp. on Hard Soils-Soft Rocks, Napoli, Italy, E. Picarelli, ed., Balkema, Rotterdam, The Netherlands, 267–272.
Mitchell, J. K. (1960). “Fundamental aspects of thixotropy in soils.” J. Soil Mech. and Found. Div., 86(3), 23–54.
Mitchell, J. K., and Soga, K. (2005). Fundamentals of soil behavior, 3rd Ed., Wiley, New York.
Moum, J., Löken, T., and Torrance, J. K. (1971). “A geotechnical investigation of the sensitivity of a normally consolidated clay from Drammen, Norway.” Geotechnique, 21(4), 329–340.
Onofri, R. (1982). “Caratteristiche geolitologiche e geomecchaniche del Flysch della Provincia di Trieste.” Studi Trentini di Scienze Naturali—Acta Geologica, N., 59, 77–103.
Picarelli, L., and Viggiani, C. (1988). “A landslide in a structurally complex formation.” Proc., 5th Int. Symp. on Landslides, Vol. I, Lausanne, Switzerland, 289–294.
Sangrey, D. (1970). “Discussion of Houston and Mitchell 1969.” J. Soil Mech. and Found. Div., 96(3), 1067–1080.
Schmertmann, J. H. (1991). “The mechanical aging of soils.” J. Geotech. Engrg., 117(9), 1288–1330.
Skempton, A. W. (1985). “Residual strength of clays in landslides, folded strata and the laboratory.” Geotechnique, 35(1), 3–18.
Stark, T. D., Choi, H., and McCone, S. (2005). “Drained shear strength parameters for analysis of landslides.” J. Geotech. Geoenviron. Eng., 131(5), 575–588.
Taylor, R. K., and Cripps, J. C. (1987). “Weathering effects: Slopes in mudrocks and overconsolidated clay.” Slope stability, Wiley, New York, 405–445.
Tika, T. E., Vaughan, P. R., and Lemos, L. J. (1996). “Fast shearing of pre-existing shearing zones in soil.” Geotechnique, 46(2), 197–233.
Urciuoli, G. (1997). “Caratterizzazione meccanica di corpi di frana in terreni argillosi.” Interventi di Stabilizzazione dei Pendii, a cura di A. Pellegrino, C.I.S.M., Udine, Italy, 65–98.
Varnes, D. J. (1978). “Slope movement and types and processes in landslides: Analysis and control.” Transportation Research Record. 176, Transportation Research Board, Washington, D.C.
Venturini, S., and Tunis, G. (1991). “Nuovi dati stratigrafici, paleoambientali e tettonici sul Flysch di Cormons (Friuli Orientale).” Gortania, Atti del Museo di Storia Naturale, No. 13, Udine, Italy, 5–30.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Apr 24, 2006
Accepted: Jun 22, 2007
Published online: Mar 1, 2008
Published in print: Mar 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.