Hydraulic Performance of Geosynthetic Clay Liners in a Landfill Final Cover
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 133, Issue 7
Abstract
Percolation from a landfill final cover containing a geosynthetic clay liner (GCL) as the hydraulic barrier is described. The GCL was covered with of vegetated silty sand and underlain with two gravel-filled lysimeters to monitor percolation from the base of the cover. Higher than anticipated percolation rates were recorded in both lysimeters within after installation of the GCL. The GCL was subsequently replaced with a GCL laminated with a polyethylene geofilm on one surface (a “composite” GCL). The composite GCL was installed in two ways, with the geofilm oriented upwards or downwards. Low percolation rates have been transmitted from the composite GCL for more than regardless of the orientation of the geofilm. Samples of the conventional GCL that were exhumed from the cover ultimately had hydraulic conductivities on the order of . These high hydraulic conductivities apparently were caused by exchange of Ca and Mg for Na on the bentonite combined with dehydration. The overlying and underlying soils likely were the source of the Ca and Mg involved in the exchange. Column experiments and numerical modeling indicated that plant roots and hydraulic anomalies caused by the lysimeters were not responsible for the high hydraulic conductivity of the GCL. Despite reports by others, the findings of this study indicate that a surface layer thick is unlikely to protect conventional GCLs from damage caused by cation exchange and dehydration. Accordingly, GCLs should be used in final covers with caution unless if cation exchange and dehydration can be prevented or another barrier layer is present (geomembrane or geofilm).
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Support for the laboratory experiments and field exhumations conducted in this study was provided in part by the United States National Science Foundation (NSF) under Grant No. NSFCMS-9900336. Inc. and RMT Inc. of Madison, Wis., collected the lysimeter data. Alliant Energy permitted sampling and testing of the GCLs exhumed from the final cover and use of the lysimeter data. Assistance provided by each of these companies is gratefully acknowledged. Stephen Meer conducted some of the laboratory tests and Brian Albrecht assisted with the field work. Their assistance is greatly appreciated.
References
Albright, W., Benson, C., Gee, G., Roesler, A., Abichou, T., Apiwantragoon, P., Lyles, B., and Rock, S. (2004). “Field water balance of landfill final covers.” J. Environ. Qual., 33(6), 2317–2332.
Blümel, W., Müller-Kirchenbauer, A., Reuter, E., Ehrenberg, H., and von Maubeuge, K. (2002). “Performance of geosynthetic clay liners in lysimeters.” Clay geosynthetic barriers, H. Zanzinger, R. Koerner, and E. Gartung, eds., Swets and Zeitlinger, Lesse, 287–294.
Böhm, W. (1979). Methods of studying root systems, Springer, New York.
Bohn, H., McNeal, B., and O’Connor, G. (1985). Soil chemistry, 2nd Ed., Wiley, New York.
Brye, K., Norman, J., and Gower, S. (2002). “Assessing the progress of a tallgrass prairie restoration in southern wisconsin.” Am. Midl. Nat., 148, 218–235.
Campbell, G., and Norman, J. (1998). An introduction to environmental biophysics, 2nd Ed., Springer, New York.
Carsel, R., and Parrish, R. (1988). “Developing joint probability distributions of soil water retention characteristics.” Water Resour. Res., 24(5), 755–769.
Chadwick, D., Ankeny, M., Greer, L., Mackey, C., and McClain, M. (1999). “Field test of potential RCRA-equivalent covers at the Rocky Mountain arsenal.” Proc., SWANA 4th Annual Landfill Symp., Solid Waste Association of North America, Silver Spring, Md., 12–33.
Chiang, I. (1998). “Effects of fines and gradation on soil water characteristic curves of sands.” MS thesis, Univ. of Wisconsin-Madison, Madison, Wis.
Egloffstein, T. (1995). “Properties and test methods to assess bentonite used in geosynthetic clay liners.” Geosynthetic clay liners, Balkema, Rotterdam, The Netherlands, 51–72.
Egloffstein, T. (2001). “Natural bentonites-influence of the ion exchange and partial desiccation on permeability and self-healing capacity of bentonites used in GCLs.” Geotext. Geomembr., 19, 427–444.
Egloffstein, T. (2002). “Bentonite as sealing material in geosynthetic clay liners—Influence of the electrolytic concentration, the ion exchange and ion exchange, with simultaneous partial desiccation on permeability.” Clay geosynthetic barriers, H. Zanzinger, R. Koerner, and E. Gartung, eds., Swets and Zeitlinger, Lesse, 141–153.
Henken-Mellies, W., Zanzinger, H., and Gartung, H. (2002). “Long-term field test of a clay geosynthetic barrier in a landfill cover system.” Clay geosynthetic barriers, H. Zanzinger, R. Koerner, and E. Gartung, eds., Swets and Zeitlinger, Lesse, 303–309.
James, A., Fullerton, D., and Drake, R. (1997). “Field performance of GCL under ion exchange conditions.” J. Geotech. Geoenviron. Eng., 123(10), 897–901.
Jo, H., Benson, C., and Edil, T. (2004). “Hydraulic conductivity and cation exchange in nonprehydrated and prehydrated bentonite permeated with weak inorganic salt solutions.” Clays Clay Miner., 52(6), 661–679.
Jo, H., Benson, C., and Edil, T. (2006). “Rate-limited cation exchange in thin bentonitic barrier layers.” Can. Geotech. J., 43, 370–391.
Jo, H., Benson, C., Lee, J., Shackelford, C., and Edil, T. (2005). “Long-term hydraulic conductivity of a geosynthetic clay liner permeated with inorganic salt solutions.” J. Geotech. Geoenviron. Eng., 131(4), 405–417.
Jo, H., Katsumi, T., Benson, C., and Edil, T. (2001). “Hydraulic conductivity and swelling of nonprehydrated GCLs permeated with single-species salt solutions.” J. Geotech. Geoenviron. Eng., 127(7), 557–567.
Khire, M., Benson, C., and Bosscher, P. (1997). “Water balance modeling of earthen final covers.” J. Geotech. Geoenviron. Eng., 123(8), 744–754.
Khire, M., Benson, C., and Bosscher, P. (2000). “Capillary barriers: Design variables and water balance.” J. Geotech. Geoenviron. Eng., 126(8), 695–708.
Kirkham, M. (2005). Principles of soil and plant water relations, Elsevier Academic, Amsterdam, The Netherlands.
Kolstad, D., Benson, C., and Edil, T. (2004). “Hydraulic conductivity and swell of nonprehydrated [GCLs] permeated with multispecies inorganic solutions.” J. Geotech. Geoenviron. Eng., 130(12), 1236–1249.
Liang, Y., Hazlett, D., and Lauenroth, W. (1989). “Biomass dynamics and water use efficiencies of five plant communities in the shortgrass steppe.” Oecologia, 80, 148–153.
Lin, L., and Benson, C. (2000). “Effect of wet-dry cycling on swelling and hydraulic conductivity of GCLs.” J. Geotech. Geoenviron. Eng., 126(1), 40–49.
Mackey, R., and Olsta, J. (2004). “Performance of geosynthetic clay liners used in two landfill closures in a coastal area of Florida.” Advances in Geosynthetic Clay Liners Technology: 2nd Symp., STP 1456, R. Mackey and K. von Maugeuge, eds., ASTM International, West Conshohocken, Pa., 53–71.
Mansour, R. (2001), “GCL performance in semiarid climate conditions.” Proc., Sardinia 2001, 8th Int. Waste Management and Landfill Symp., T. Christensen, R. Cossu, and R. Stegmann, eds., CISA, Cagliari, Italy, 219–226.
Melchior, S. (1997). “In situ studies on the performance of landfill caps.” Proc., Int. Containment Technology Conf., Florida State University, Tallahassee, Fla., 365–373.
Melchior, S. (2002). “Field studies and excavations of geosynthetic clay barriers in landfill covers.” Clay geosynthetic barriers, H. Zanzinger, R. Koerner, and E. Gartung, eds., Swets and Zeitlinger, Lesse, 321–330.
Norrish, K., and Quirk, J. (1954). “Crystalline swelling of montmorillonite, use of electrolytes to control swelling.” Nature (London), 173, 255–257.
Petrov, R., and Rowe, R. (1997). “Geosynthetic clay liner (GCL)—Chemical compatibility by hydraulic conductivity testing and factors impacting its performance.” Can. Geotech. J., 34, 863–885.
Rhoades, J. (1982a). “Chapter 8: cation exchange capacity.” Methods of soil analysis. Part 2: Chemical and microbiological properties, 2nd Ed., A. Page, R. Miller, and D. Keeney, eds., Soil Science Society of America, Madison, Wis., 149–157.
Rhoades, J. (1982b). “Chapter 10: Soluble salts.” Methods of soil analysis. Part 2: Chemical and microbiological properties, 2nd Ed., A. Page, R. Miller, and D. Keeney, eds., Soil Science Society of America, Madison, Wis., 67–179.
Shackelford, C., Benson, C., Katsumi, T., and Edil, T. (2000). “Evaluating the hydraulic conductivity of Gcls permeated with nonstandard liquids.” Geotext. Geomembr., 18(2–3), 133–161.
Šimůnek, J., van Genuchten, T. Th., and Šejna, M. (1999). The HYDRUS-2D software package for simulating two-dimensional movement of water, heat, and multiple solutes in variably-saturated media, version 2.0, U.S. Salinity Laboratory, United States Department of Agriculture, Riverside, Calif.
Sivakumar Babu, G., Sporer, H., Zanzinger, H., and Gartung, E. (2002). “Desiccation behavior of selected geosynthetic clay liners.” Clay geosynthetic barriers, H. Zanzinger, R. Koerner, and E. Gartung, eds., Swets and Zeitlinger, Lesse, 295–302.
Sposito, G. (1981). The thermodynamics of soil solutions, Oxford Uni-versity Press, New York.
Sposito, G. (1989). The chemistry of soils, Oxford University Press, New York.
Thomas, G. (1982). “Chapter 9: Exchangeable cations.” Methods of soil analysis. Part 2: Chemical and microbiological properties, 2nd Ed., A. Page, R. Miller, and D. Keeney, eds., Soil Science Society of America, Madison, Wis., 159–165.
Wagner, J., and Schnatmeyer, C. (2002). “Test field study of different cover sealing systems for industrial dumps and pollutes sites.” Appl. Clay Sci., 21, 99–116.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 133 • Issue 7 • July 2007
Pages: 814 - 827
Copyright
© 2007 ASCE.
History
Received: May 3, 2006
Accepted: Nov 27, 2006
Published online: Jul 1, 2007
Published in print: Jul 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.