Axial Load Tests on Bored Piles and Pile Groups in Cemented Sands
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 127, Issue 9
Abstract
The behavior of bored pile groups in cemented sands was examined by a field testing program at a site in South Surra, Kuwait. The program consisted of axial load tests on single bored piles in tension and compression and compression tests on two pile groups each consisting of five piles. The spacing of the piles in the groups was two- and three-pile diameters. Soil exploration included standard penetration tests, dynamic cone tests, and pressure meter tests. Laboratory tests included basic properties and drained triaxial compression tests. Test results on single piles indicated that 70% of the ultimate load was transmitted in side friction that was uniform along the pile shafts. The calculated pile group efficiencies were 1.22 and 1.93 for a pile spacing of two- and three-pile diameters, respectively. Since settlement usually controls the design of pile groups in sand, the group factor defined herein as the ratio of the settlement of the group to the settlement of a single pile at comparable loads in the elastic range was determined from test results. A comparison between the measured values and calculated values based on a simplified formula was made.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
ASCE Committee on Deep Foundations. ( 1984). “Practical guidelines for the selection, design, and installation of piles.” Rep., ASCE, New York.
2.
ASTM Annual Book of Standards. (1987). Soil, Rock, Building Stones, Vol. 4.08, ASTM, West Conshohocken, Pa.
3.
Das Braja M. ( 1999). Principles of foundation engineering, 4th Ed., Brooks/Cole Publishing Co., Pacific Grove, Calif.
4.
Feagin, L. B. ( 1948). “Performance of pile foundations of navigation locks and dams on the Upper Mississippi River.” Proc., 2nd Int. Conf. Soil Mech. Found. Engrg., Vol. 4, Balkema, Rotterdam, The Netherlands, 98–106.
5.
Feld, J. ( 1943). “Friction pile foundations.” Trans. ASCE, 108.
6.
Focht, J. A., Jr. and O'Neill, M. W. ( 1985). “Piles and other deep foundations.” Proc., 11th ICSMFE, Vol. 4, Balkema, Rotterdam, The Netherlands, 187–209.
7.
Garg, K. G. (1979). “Bored pile groups under vertical load in sand.”J. Geotech. Engrg. Div., ASCE, 105(8), 939–956.
8.
Ismael, N. F. (1990). “Behavior of laterally loaded bored piles in cemented sands.”J. Geotech. Engrg., ASCE, 116(11), 1678–1699.
9.
Ismael, N. F. (1996). “Loading tests on circular and ring plates in very dense cemented sands.”J. Geotech. Engrg., ASCE, 122(4), 281–287.
10.
Ismael, N. F., and Al-Sanad, H. A. ( 1993). “Plate loading tests on weakly cemented surface desert sands.” Geotech. Engrg., J. Southeast Asian Geotech. Soc., Bangkok, Thailand, 24(2), 133–150.
11.
Ismael, N. F., Al-Sanad, H. A., and Al-Otaibi, F. ( 1994). “Tension tests on bored piles in cemented desert sands.” Can. Geotech. J., Ottawa, 31(3), 597–603.
12.
Khalaf, F. I., Gharib, I. M., and Al-Hashash, M. Z. ( 1984). “Types of characteristics of the recent surface deposits of Kuwait, Arabian Gulf.” J. Arid Envir., 7(2), 9–33.
13.
Kishida, H. ( 1967). “Ultimate bearing capacity of piles driven into loose sand.” Soils and Found., Tokyo, VII(3), 20–29.
14.
Liu, J. L., Yuan, Z. L., and Zhang, K. P. ( 1985). “Cap-pile-soil interaction of bored pile groups.” Proc., 11th Int. Conf. on Soil Mech. and Found. Engrg., Vol. 3, Balkema, Rotterdam, The Netherlands, 1433–1436.
15.
Meyerhof, G. G. (1976). “Bearing capacity and settlement of pile foundations.”J. Geotech. Engrg. Div., ASCE, 102(3), 195–228.
16.
Singh, A., and Prakash, S. ( 1973). “Axial reaction of model pile groups in sand.” Indian Engrg. J., 53(March), 217–221.
17.
Vesic, A. S. ( 1977). “Design of pile foundations.” Nat. Cooperative Hwy. Res. Program Synthesis of Pract. No. 42, Transportation Research Board, Washington, D.C.
18.
Vesic, A. S. ( 1969). “Experiments with instrumented pile groups in sand.” Performance of deep foundations, ASTM Spec. Tech. Publ. No. 444, 177–222.
Information & Authors
Information
Published In
History
Received: Jan 5, 2001
Published online: Sep 1, 2001
Published in print: Sep 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.