Vertical Loads on Concrete Box Culverts under High Embankments
Publication: Journal of Bridge Engineering
Volume 10, Issue 6
Abstract
Vertical loads on concrete box culverts under high embankments are examined, where a high embankment is defined herein as one where the height of the fill above the culvert is greater than the width of the culvert. Results from an instrumented culvert are described, with results from pressure cells, strain gages in the wall, and strain gages in the roof showing reasonable agreement. There was strong correlation between the height of fill and the pressure and internal forces in the culvert, suggesting that the soil–structure interaction factor is independent of the ratio. The results of the instrumented culvert were compared to those of other instrumented culverts under high embankments. The measured roof pressures were significantly greater than the pressure due to the soil overburden, with the measured pressures averaging 1.5 times the soil overburden pressure. Although the soil–structure interaction factor recommended by the American Society of Highway and Transportation Officials specification tends to under-predict the loads acting on concrete culverts, a simplified reliability analysis suggests that the Specification provides a sufficient level of safety.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was sponsored by the Tennessee Department of Transportation. This support is gratefully acknowledged.
References
American Association of State Highway and Transportation Officials (AASHTO). 1996). Standard specifications for highway bridges, 16th Ed., AASHTO, Washington, D.C.
American Association of State Highway and Transportation Officials (AASHTO). (1998). AASHTO LRFD bridge design specifications, 2nd Ed., AASHTO, Washington, D.C.
Binger, W. V. (1947). “Discussion to ‘Underground conduits—An appraisal of modern research’ .” Proc. Am. Soc. Civ. Eng., 73, 1543–1545.
Braune, G. M., Cain, W., and Janda, H. F. (1929). “Earth pressure experiments on culvert pipe.” Public Roads, 10(9), 153–176.
Clarke, N. W. B. (1967). “The loads imposed on conduits laid under embankments or valley fills.” Proc. Inst. Civ. Eng., Struct. Build., 36, 63–98.
Dasgupta, A., and Sengupta, B. (1991). “Large-scale model test on square box culvert backfilled with sand.” J. Geotech. Eng. Div., Am. Soc. Civ. Eng., 117(1), 156–161.
Duncan, J. M. (2000). “Factors of safety and reliability in geotechnical engineering.” J. Geotech. Geoenviron. Eng., 126(4), 307–316.
Girdler, H. F. (1974). “Loads on culverts under high embankments.” Research Rep. No. 386, Interim Rep. No. KYHPR-72-68; HPR-1(9), Part II, Department of Transportation, Lexington, Ky.
Höeg, K. (1968). “Stresses against underground structural cylinders.” J. Soil Mech. Found. Div., 94(4), 833–858.
Katona, M. G., Vittes, P. D., Lee, C. H., and Ho, H. T. (1981). “CANDE-1980: Box culverts and soil models.” Rep. No. FHWA/RD-80/172, Federal Highway Administration, Washington, D.C.
Mirza, S. A., Hatzinikolas, M., and MacGregor, J. G. (1979). “Statistical descriptions of strength of concrete.” J. Struct. Div. ASCE, 105(6), 1021–1037.
Nowak, A. S. (1995). “Calibration of LRFD bridge code.” J. Struct. Eng., 121(8), 1245–1251.
Penman, A. D. M., Charles, J. A., Nash, J. K. T. L., and Humphreys, J. D. (1975). “Performance of culvert under Winscar dam.” Geotechnique, 25(4), 713–730.
Spangler, M. G. (1947). “Underground conduits—An appraisal of modern research.” Proc. Am. Soc. Civ. Eng., 73, 855–884.
Spangler, M. G. (1950). “Field measurements of the settlement ratios of various highway culverts.” Iowa Engineering Experiment Station Bulletin 170, Ames, Iowa.
Spangler, M. G. (1968). “Discussion to ‘The modification of the pressures on rigid culverts with fill procedures’ .” Highway Research Record, 249, Highway Research Board, Washington, D.C., 41–43.
Trollope, D. H., Speedie, M. G., and Lee, I. K. (1963). “Pressure measurements on Tullaroop dam culvert.” Proc., 4th Australia–New Zealand Conf. on Soil Mechanics and Foundation Engineering, 81–92.
Vaslestad, J., Johansen, T. H., and Holm, W. (1993). “Load reduction on rigid culverts beneath high fills: Long-term behavior.” Transportation Research Record. 1415, Transportation Research Board, Washington, D.C., 58–68.
Wood, S. M. (2000). “Internal forces in a reinforced concrete box culvert.” Master’s thesis, The Univ. of Tennessee, Knoxville, Tenn.
Woodbury, W. H., Bayer, E. J., Botts, A. E., Daley, C. A., Pettus, J. K., and Wilks, J. R. (1926). “Corrugated metal culverts for railroad purposes. Preparing specifications, with assistance of committee on iron and steel structures.” Bull. Am. Railway Eng. Assoc., 27(284), 794–828.
Yang, M. Z. (2000). “Evaluation of factors affecting earth pressures on buried box culverts.” PhD dissertation, Univ. of Tennessee, Knoxville, Tenn.
Information & Authors
Information
Published In
Journal of Bridge Engineering
Volume 10 • Issue 6 • November 2005
Pages: 643 - 649
Copyright
© 2005 ASCE.
History
Received: Jul 1, 2004
Accepted: Sep 23, 2004
Published online: Nov 1, 2005
Published in print: Nov 2005
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.