Influence of Joint Thickness and Mortar-Block Elastic Properties on the Strength and Stresses Developed in Soil-Cement Block Masonry
Publication: Journal of Materials in Civil Engineering
Volume 21, Issue 10
Abstract
Soil-cement blocks are employed for load bearing masonry buildings. This paper deals with the study on the influence of bed joint thickness and elastic properties of the soil-cement blocks, and the mortar on the strength and behavior of soil-cement block masonry prisms. Influence of joint thickness on compressive strength has been examined through an experimental program. The nature of stresses developed and their distribution, in the block and the mortar of the soil-cement block masonry prism under compression, has been analyzed by an elastic analysis using FEM. Influence of various parameters like joint thickness, ratio of block to mortar modulus, and Poisson’s ratio of the block and the mortar are considered in FEM analysis. Some of the major conclusions of the study are: (1) masonry compressive strength is sensitive to the ratio of modulus of block to that of the mortar and masonry compressive strength decreases as the mortar joint thickness is increased for the case where the ratio of block to mortar modulus is more than 1; (2) the lateral tensile stresses developed in the masonry unit are sensitive to the ratio and the Poisson’s ratio of mortar and the masonry unit; and (3) lateral stresses developed in the masonry unit are more sensitive to the Poisson’s ratio of the mortar than the Poisson’s ratio of the masonry unit.
Get full access to this article
View all available purchase options and get full access to this article.
References
ANSYS 8.0. (2005). ANSYS Inc., Canonsburg, Pa.
ASTM. (2007). “Standard test method for compressive strength of masonry prisms.” C 1314-07, West Conshohocken, Pa.
British Standards Institution. (1980). “British standard methods of testing mortars, screeds, and plasters.” BS 4551, London.
Bureau of Indian Standards. (1980). “Indian standard code of practice for specifications for sand for masonry mortars.” IS 2116, New Delhi, India.
Bureau of Indian Standards. (1987). “Code of practice for structural use of unreinforced masonry (third revision).” IS 1905, New Delhi, India.
Bureau of Indian Standards. (1989). “Specification for 43 grade ordinary Portland cement.” IS 8112, New Delhi, India.
Fitzmaurice, R. F. (1958). Manual on stabilized soil construction for housing, U.N. Technical Assistance Programme, New York.
Francis, A. J., Horman, C. B., and Jerrems, L. E. (1971). “The effect of joint thickness and other factors on the compressive strength of brickwork.” Proc., 2nd Int. Brick Masonry Conf. (Stoke-on-Trent), H. W. H. West, ed., British Ceramic Association, 31–37.
Gupta, A. (2003). “Studies on characteristics of cement-soil mortars and soil-cement block masonry.” MS thesis, Dept. of Civil Eng., Indian Institute of Science, Bangalore, India.
Heathcote, K. (1991). “Compressive strength of cement stabilized pressed earth blocks.” Build. Res. Inf., 19(2), 101–105.
Hendry, A. W. (1998) Structural masonry, Macmillan, London.
Houben, H., and Guillaud, H. (1994). Earth construction—A comprehensive guide, Intermediate Technology, London.
Houston, J. Y., and Grimm, C. T. (1972). “Effect of brick height on masonry compressive strength.” J. Mater., 7, 388–397.
Jagadish, K. S. (1988). “The progress of stabilised soil construction in India.” Proc., National Seminar on Application of Stabilised Mud Blocks in Housing and Building, Vol. 1, Bangalore, India, 17–43.
Khoo, C. L. (1972). “A failure criterion for brickwork in axial compression.” Ph.D. thesis, Univ. of Edinburgh, Edinburgh, U.K.
Lunt, M. G. (1980). “Stabilized soil blocks for buildings.” Rep. No. 184, Building Research Establishment, U.K.
Mukerji, K. (1994). Stabilisers and mortars for compressed earth blocks, GATE-ISAT, Eschborn, Germany.
Neville, A. M. (1996). Properties of concrete, 4th Ed., Addison Wesley Longman Limited, Essex, U.K.
Neville, A. M., and Brooks, J. J. (1996). Concrete technology, Addison Wesley Longman Limited, Essex, U.K.
Olivier, M., and Mesbah, A. (1987). “Influence of different parameters on the resistance of earth, used as a building material.” Proc., Int. Conf. on Mud Architecture, Trivandrum, India.
Sahlin, S. (1971). Structural masonry, Prentice-Hall, Englewood Cliffs, N.J.
Shrinivasa Rao, S., Venkatarama Reddy, B. V., and Jagadish, K. S. (1995). “Strength characteristics of soil-cement block masonry.” Indian Concr. J., 69(2), 127–131.
Structural Clay Products Research Foundation (SCPRF). (1964). “Small scale specimen testing.” Rep. Prepared for the National Testing Program, Structural Clay Products Research Foundation, Geneva.
Structural Clay Products Research Foundation (SCPRF). (1965). “Compressive and transverse tests of five-inch brick walls.” Research Rep. No. 8, Structural Clay Products Research Foundation, Geneva.
Theunissen, P. (1985). “Building with earth.” Rep. No. 4, Service of the Belgian Administration for Development Cooperation, Belgium.
United Nations (UN). (1964). “Soil-cement—Its use in building.” Rep. Prepared for Dept. of Economic and Social Affairs, United Nations, New York.
Venkatarama Reddy, B. V., and Gupta, A. (2005a). “Characteristics of soil-cement blocks using highly sandy soils.” Mater. Struct., 38(280), 651–658.
Venkatarama Reddy, B. V., and Gupta, A. (2005b). “Characteristics of cement-soil mortars.” Mater. Struct., 38(280), 639–650.
Venkatarama Reddy, B. V., and Gupta, A. (2006). “Strength and elastic properties of stabilised mud block masonry using cement soil mortars.” J. Mater. Civ. Eng., 18(3), 472–476.
Venkatarama Reddy, B. V., and Jagadish, K. S. (1989). “Properties of soil-cement block masonry.” Masonry Int., 3(2), 80–84.
Venkatarama Reddy, B. V., and Jagadish, K. S. (1990). “The strength of soil-cement block masonry walls.” Proc., 3rd Int. Seminar on Structural Masonry for Developing Countries, Thomas Telford, London, 117–122.
Venkatarama Reddy, B. V., and Jagadish, K. S. (1993). “The static compaction of soils.” Geotechnique, 43(2), 337–341.
Venkatarama Reddy, B. V., and Jagadish, K. S. (1995). “Influence of soil composition on the strength and durability of soil-cement blocks.” Indian Concr. J., 69(9), 517–524.
Venkatarama Reddy, B. V., Lal, R., and Nanjunda Rao, K. S. (2007). “Optimum soil grading for the soil-cement blocks.” J. Mater. Civ. Eng., 19(2), 139–148.
Venkatarama Reddy, B. V., and Walker, P. (2005). “Stabilised mud blocks: Problems, prospects.” Proc., Int. Earth Building Conf.—EarthBuild 2005, Faculty of Design Architecture and Building, Univ. of Technology, Sydney, Australia, 63–75.
Venumadhava Rao, K., Venkatarama Reddy, B. V. and Jagadish K. S. (1996). “Flexural bond strength of masonry using various blocks and mortars.” Mater. Struct., 29, 119–124.
Walker, P. (1999). “Bond characteristics of earth block masonry.” J. Mater. Civ. Eng., 11(3), 249–256.
Walker, P., and Stace, T. (1997). “Properties of some cement stabilized compressed earth blocks and mortars.” Mater. Struct., 30, 545–551.
Walker, P., Venkatarama Reddy, B. V., Mesbah, A., and Morel, J. -C. (2000). “The case for compressed earth block construction.” Proc., 6th Int. Seminar on Structural Masonry for Developing Countries, Allied Publishers Ltd., Bangalore, India.
Walker, P. J. (2004). “Strength and erosion characteristics of earth blocks and earth block masonry.” J. Mater. Civ. Eng., 16(5), 497–506.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 12, 2006
Accepted: Jan 22, 2009
Published online: Sep 15, 2009
Published in print: Oct 2009
Notes
Note. Associate Editor: Chiu Liu
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.