Cyclic Behavior of RC Beams Strengthened with Carbon Fiber Sheets Bonded by Inorganic Matrix
Publication: Journal of Materials in Civil Engineering
Volume 18, Issue 1
Abstract
The objective of this paper is to study the fatigue performance of concrete beams strengthened with carbon fiber sheets bonded by an inorganic matrix. Large size reinforced concrete (RC) beams were strengthened with three layers of carbon fiber sheets and tested under fatigue loading. The relationship between fatigue strength, crack width, and number of cycles was studied and analyzed. Results showed that both load capacity and number of cycles of the RC beams were significantly increased with carbon fiber sheets. The fatigue strength increased by as much as 55% as compared with that of the control beams. Fatigue failure of the RC beams strengthened with carbon fiber sheets bonded with an inorganic matrix started with steel rupturing followed by fiber rupture. It was observed that the fatigue cracks developed during the first few cycles. With increasing number of cycles, the crack width and crack depth increased during the first half million cycles of loading, and thereafter the crack width and depth tended to stabilize.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers would like to acknowledge the financial support of the National Science Foundation Grant CMS-9900431. The contribution of materials from Master Builders Inc. is also gratefully acknowledged.
References
Aas-Jakobsen, K. (1970). “Fatigue of concrete beams and columns.” Bulletin No. 70–1, NTH Institute of Betonkonstruksjoner, Trondheim, Norway.
American Concrete Institute (ACI) Committee 215. (1992). “Consideration for design of concrete structures subjected to fatigue loading.” ACI J., 71(3), 97–121.
American Concrete Institute (ACI) Committee 440. (1996). State of the art report on fiber reinforced plastic reinforcement for concrete structures, Detroit.
Balaguru, P., and Kurtz., S. (1997). “Use of inorganic polymer-fiber composites for repair and rehabilitation of infrastructures.” Proc., Int. Conf. on Repair and Rehabilitation of Reinforced Concrete Structures, ASCE, New York, 155–168.
Barnes, R. A., and Mays, G. C. (1999). “Fatigue performance of concrete beams strengthened with CFRP plates.” J. Compos. Constr., 3(2), 63–72.
Bizindavyi, L., Neale, K. W., and Erki, M. A. (2003). “Experimental investigation of bonded fiber reinforced polymer-concrete joints under cyclic loading.” J. Compos. Constr., 7(2), 127–134.
Deng, Y. (2002). “Static and fatigue behaviors of RC beams strengthened with carbon fiber sheets bonded by organic and inorganic matrices.” PhD thesis, Univ. of Alabama, Huntsville, Ala.
Foden, A., Lyon, R., Balaguru, P., and Davidovitz, J. (1996). “High temperature inorganic resin for use in fiber reinforced composites.” Proc. 1st Int. Conf. on Composites in Infrastructures, Univ. of Arizona, Tucson, Ariz., 166–177.
Helgason, T., and Hanson, J. M. (1974). “Investigation of design factors affecting fatigue strength of reinforcing bars—statistical analysis.” Proc., Abeles Symp. on Fatigue of Concrete, American Concrete Institute, Detroit, 107–138.
Jia, J. (2002). “Mode-I fatigue fracture of interface for FRP composite bonded to wood.” PhD thesis, West Virginia Univ., Morgantown, W.Va.
Meier, U., Deuring, M., Meier, H., and Schwegler, G. (1992). “Strengthening of structures with CFRP laminates: Research and applications in Switzerland.” Advanced composite materials in bridges and structures, K. W. Neale and P. Labossiere, eds., Canadian Society for Civil Engineers, Montreal.
Moss, D. S. (1982). “Bending fatigue of high-yield reinforcing bars in concrete.” TRRL Supplementary Rep. 748, Transport and Road Research Laboratory, Crowthome, U.K.
Papakonstantinou, C., Petrou, M., and Harries, K. (2001). “Fatigue behavior of RC beams strengthened with GFRP sheets.” J. Compos. Constr., 5(4), 246–253.
Sarkani, S., Michaelov, G., Kihl, D., and Bonanni, D. (2001) “Comparative study of nonlinear damage accumulation models in stochastic fatigue of FRP laminates.” J. Struct. Eng., 127(3), 314–322.
Shahawy, M., and Beitelman, T. E. (1999). “Static and fatigue performance of RC beams strengthened with CFRP laminates.” J. Struct. Eng., 125(6), 613–621.
Shi, X. P., Fwa, T. F., and Tan, S. A. (1993). “Flexural fatigue strength of plain concrete.” ACI Mater. J., 90(5), 435–440.
Toutanji, H., Deng, Y., Zhang, Y., and Balaguru, P. (2001). “The use of inorganic matrix for strengthening of RC beams with carbon sheets.” Proc., 1st Int. Conf. on FRP Composites in Civil Engineering, Hong Kong Polytechnic Univ., Hong Kong, 2, 1117–1126.
Toutanji, H., and Gomez, W. (1997). “Durability of concrete beams externally bonded with FRP sheets in aggressive environments.” Cem. Concr. Compos., 19(4), 351–358.
Toutanji, H., Zhang, Y., and Zhao, L. (2004). “Moment failure of RC beams externally bonded with CFRP sheets bonded with organic and inorganic matrices.” Proc., Innovative Materials and Technologies for Construction and Restoration, Univ. of Lecce, Lecce, Italy, 117–127.
Wight, R. G., and Erki, M. A. (2003). “Prestressed CFRP sheets for strengthening concrete slabs in fatigue.” Adv. Struct. Eng., 6(3), 175–182.
Zhang, Y. (2002). “Flexural behavior of reinforced concrete beams externally bonded with CFRP sheets.” MS thesis, Univ. of Alabama, Huntsville, Ala.
Zhao, L. (2005). “Characterizations of RC beams strengthened with carbon fiber sheets.” PhD thesis, Univ. of Alabama, Huntsville, Ala.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: May 29, 2002
Accepted: Aug 23, 2005
Published online: Feb 1, 2006
Published in print: Feb 2006
Notes
Note. Associate Editor: Roberto Lopez-Anido
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.