Crack Initiation Model from Asphalt Slab Tests
Publication: Journal of Materials in Civil Engineering
Volume 14, Issue 4
Abstract
The Strategic Highway Research Program (SHRP) fatigue crack initiation life prediction model was based on a sophisticated analysis of the results of intensive bending beam fatigue tests under controlled stress and controlled strain. The definition of crack initiation was defined as the period during which initial microcracks developed into a macrocrack 7.5-mm deep. Due to the lack of the measured crack data, the numbers of loading cycles corresponding to the 7.5-mm deep crack were not observed from the tests but predicted based on a microfracture mechanics model. The objective of this study was to evaluate SHRP fatigue crack initiation life prediction model with the crack measurements in laboratory slab fatigue tests. The study showed that the SHRP crack initiation life model significantly underestimated the fatigue crack initiation life for the slabs. However, the ratio of the observed fatigue life from the slab tests to the crack initiation life predicted from SHRP equation was shown to be approximately constant.
Get full access to this article
View all available purchase options and get full access to this article.
References
ABAQUS manual, version 5.6. (1997). Hibbitt, Karlsson & Sorensen, Pawtucket, R.I.
Asphalt Institute. (1981). “Thickness design-asphalt pavements for highways and streets.” Manual series No. 1, College Park, Md.
AUSTROADS. (1992). Pavement design: A guide to the structural design of road pavements, AUSTROADS. Sydney, Australia.
Carlton, P. F., and Behrmann, R. M. (1958). “Model studies of prestressed rigid pavements for airfield.” Bull. 179, Highway Research Board, Washington, D.C., 32.
Daleiden, J. F., Rauhut, J. B., Killingsworth, B., Antwi, E. O., Darter, M. I., and Ahmad, R. (1994). “Evaluation of the AASHTO design equations and recommended improvements.” Rep. No. SHRP-P-394, SHRP Program, National Research Council, Washington, D.C.
Finn, F. N., Saraf, C. L., Kulkarni, R., Nair, K., Smith, W., and Abdullah, A. (1986). “Development of pavement structural subsystems.” NCHRP Rep. No. 291. Transportation Research Board, Washington, D.C.
Li, Y., Metcalf, J. B., Romanoschi, S. A., and Rasoulian, M. (1999). “Performance and failure modes of Louisiana asphalt pavements with soil-cement bases under full-scale accelerated loading.” TRR 1673, Transportation Research Board, Washington, D.C., 9–15.
Louisiana Dept. of Transportation and Development. (1992). Louisiana department of transportation and development (LA DOTD) standard specifications for roads and bridges, Baton Rouge, La.
Lytton, R. L., Uzan, J., Fernando, E. G., Roque, R., Hiltunen, D., and Stoffels, S. M. (1993). “Development and validation of performance prediction models and specifications for asphalt binders and paving mixes.” Rep. No. SHRP-A-357, SHRP Program, National Research Council, Washington, D.C.
Majidzadeh, K., Kaufmann, E. M., and Ramsamooj, D. V. (1971). “Application of fracture mechanics in the analysis of pavement fatigue.” Proc., Association of Asphalt Paving Technologists, 40, 227–246.
Majidzadeh, K., Ramsamooj, D. V., and Fletcher, T. A. (1969). “Analysis of fatigue of a sand asphalt mixture.” Proc., Association of Asphalt Paving Technologists, 39, 495–518.
Molenaar, A. A. A. (1983). “Structural performance and design of flexible road constructions and asphalt concrete overlays.” PhD thesis, Delft Univ. of Technology, Delft, The Netherlands.
Monismith, C. L., Epps, J. A., Kasianchuk, A. A., and McLean, D. B. (1972). “Asphalt mixture behavior in repeated flexure.” Rep. No. TE70-5, Institute of Transportation and Traffic Engineering, Univ. of California, Berkeley, Calif.
Narasimhan, R., and Rosakis, A. J. (1988). “Three dimensional effects near a crack tip in a ductile three point bend specimen. Part I: A numerical investigation.” Rep. SM 88-6, Div. of Engineering and Applied Science, California Institute of Technology, Pasadena, Calif.
Nussbaum, P. J., and Larsen, T. J. (1965). “Load deflection characteristics of soil-cement pavements.” HRR 86, Highway Research Board, Washington, D.C., 1–14.
Pell, P. S. (1973). “Characterization of fatigue behavior.” Special Rep. 140: Structural design of asphalt concrete pavement systems to prevent cracking, Highway Research Board, Washington, D.C., 49–64.
Roesler, J. R., and Barenberg, E. J. (1999). “Fatigue and static testing of concrete slabs.” TRR 1684, Transportation Research Board, Washington, D.C., 71–80.
Salam, Y. M., and Monismith, C. L. (1972). “Fracture characteristics of asphalt concrete.” Proc., Association of Asphalt Paving Technologists, 41, 215–256.
Shell International Petroleum. (1978). Pavement design manual—asphalt pavements and overlays for road traffic, London.
Tayebali, A. A., Deacon, J. A., Coplantz, J. S., Harvey, J. T., Finn, F. N., and Monismith, C. L. (1994). “Fatigue response of asphalt-aggregate mixes.” Rep. No. SHRP-A-404, SHRP Program, National Research Council, Washington, D.C.
Uzan, J. (1997). “Evaluation of fatigue cracking.” TRR 1570, Transportation Research Board, Washington, D.C., 89–95.
Von Quintus, H., and Killingsworth, B. (1998). “Analyses relating to pavement material characterizations and their effects on pavement performance.” Publication No. FHWA-RD-97-085, Federal Highway Administration, Washington, D.C.
Yuce, R., and Monismith, C. L. (1974). “Prediction of load associated cracking in pavement slabs from laboratory determined fatigue data.” Proc., Assoc. of Asphalt Paving Technol., 43, 332–349.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Nov 16, 1999
Accepted: Apr 27, 2001
Published online: Jul 15, 2002
Published in print: Aug 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.