Change Intervals and Lost Time at Single‐Point Urban Interchanges
Publication: Journal of Transportation Engineering
Volume 118, Issue 5
Abstract
The single‐point urban interchange (SPUI) is a relatively new type of diamond interchange. It is claimed to offer improved operational efficiency, improved safety, and reduced right‐of‐way requirements over other interchange forms. This paper addresses the area of operational efficiency by focusing on the SPUI's change interval requirements and the implications of these requirements on the amount of lost time incurred at the end of the signal phase. Values of end lost time are calculated for the SPUI and compared to those of a typical, high‐type at‐grade intersection (AGI). End lost time calculations for the SPUIs and AGIs indicated that the SPUI signal phases have longer end lost times than do the AGI phases. In particular, the SPUI through phase was found to have 1.5‐2.5 sec more end lost time than the AGI through phase. Similarly, the SPUI left‐turn phase was found to have about 1.0‐2.0 sec more end lost time than the AGI left‐turn phase.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bonneson, J. A. (1990). “Operational characteristics of the single‐point urban interchange,” PhD thesis, Texas A&M University, College Station, Tex.
2.
Bonneson, J. A., and Messer, C. J. (1989). “A national survey of single‐point urban interchanges.” Report No. TTI‐2‐18‐88‐1148‐1, Texas Transportation Institute, College Station, Tex.
3.
Brown, S., and Walters, G. (1988). “The single‐signal interchange.” ITE 1988 Compendium of Technical Papers, Institute of Transportation Engineers, Washington, D.C., 180–184.
4.
Carstens, R. L. (1971). “Some traffic parameters at signalized intersections.” Traffic Engrg., Institute of Transportation Engineers, 41(8), 33–36.
5.
Chang, M. S., Messer, C. J., and Santiago, A. J. (1985). “Timing traffic signal change intervals based on driver behavior.” Transportation Research Record 1027, Transportation Research Board, National Research Council, Washington, D.C., 20–30.
6.
“Determining vehicle signal change intervals (proposed recommended practice). “(1989). ITE Technical Committee 4A‐16, ITE J., Institute of Transportation Engineers, 59 (7), 27–32.
7.
Leisch, J. P., Urbanik, T., and Oxley, J. P. (1989). “A comparison of two diamond interchange forms in urban areas.” ITE J., Institute of Transportation Engineers, 59(5), 21–27.
8.
Messer, C. J., Bonneson, J. A., Anderson, S. D., and McFarland, W. F. (1991). “Single point urban interchange design and operations analysis.” Nat. Cooperative Hwy. Res. Program Report 345, Transp. Res. Board, Washington, D.C.
9.
A policy on geometric design of highways and streets. (1990). American Association of State Highway and Transportation Officials, Washington, D.C., 192–199.
10.
SAS/STAT user's guide. (1988). Release 6.03 Ed., SAS Institute Inc., Cary, N.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Sep 1, 1992
Published in print: Sep 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.