Strength and Stability of Steel Frames in Fire: Rankine Approach
Publication: Journal of Structural Engineering
Volume 127, Issue 4
Abstract
A simple analytical approach based on the Rankine principle has been developed to determine the ultimate resistance of steel frames in fire. The proposed Rankine approach gives an approximation of the frames' fire resistance through a simple interaction between two idealized structural behaviors—strength and stability. Here, the strength and stability of the structures are evaluated using the rigid-plastic and the elastic buckling analyses, both incorporating the thermal effects. The proposed approach is first verified using a finite-element model. The verification studies include the effects of column and frame slenderness ratios, beam-column stiffness ratio, steel grades, initial sway imperfections, and initial residual stresses. These studies indicate that frame slenderness ratio is an important parameter governing the behavior of simple frames in fire, and the performance of the proposed approach is related to it. The Rankine approach is then applied to a series of 18 test frames from the literature. It is shown that the proposed approach can provide predictions with sufficient accuracy for simple frames in fire.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Cheng, W. C., and Mak, C. K. (1975). “Computer analysis of steel frame in fire.”J. Struct. Div., ASCE, 101(4), 854–856.
2.
Commission of European Communities. ( 1992). “Design of steel structures: Part 1.1. General rules and rules for buildings (EC3-1.1).” Eurocode 3, Brussels.
3.
Commission of European Communities. ( 1995). “Design of steel structures: Part 1.2. General rules. Structural fire design (EC3-1.2).” Eurocode 3, Brussels.
4.
Franssen, J. M., Schleich, J. B., Talamona, D., and Twilt, L. ( 1994). “A comparison between five structural fire codes applied to steel elements.” Proc., 4th Int. Symp. Fire Safety Sci., T. Kashiwagi, ed., IAFSS, Gaithersburg, Md., 1125–1136.
5.
Furumura, F., and Shinohara, Y. ( 1978). “Inelastic behaviour of protected steel beams and frames in fire.” Rep. No. 3, Res. Lab. of Engrg. Mat., Tokyo.
6.
Horne, M. R. ( 1960). “Instability and the plastic theory of structures.” Trans. Engrg. Inst. Ca., 4(2).
7.
Horne, M. R. ( 1963). “Elastic-plastic failure loads of plane frames.” Proc., Royal Soc., London, 274, 343–364.
8.
Horne, M. R., and Merchant, W. ( 1965). The stability of frames, Pergamon, Tarrytown, N.Y.
9.
Merchant, W. ( 1954). “The failure load of rigid jointed frameworks as influenced by stability.” The Struct. Engr., London, 32, 185–190.
10.
Najjar, S. R., and Burgess, I. W. ( 1995). “A nonlinear analysis for three-dimensional steel frames in fire conditions.” Engrg. Struct., 18(1), 77–89.
11.
Rubert, A., and Schaumann, P. ( 1986). “Structural steel and plane-frame assemblies under fire action.” Fire Safety J., 10, 173–184.
12.
Talamona, D. ( 1995). “Buckling curves in case of fire—ECSC 7210 SA 316/515/931/618: Fire resistance of steel columns with eccentric load. Part 1.” Rep. No. INC-96/450-DT/VG Part 1, CTICM, Saint-Remy-les-Chevreuse, Paris.
13.
Talamona, D., Franssen, J. M., Schleich, J. B., and Kruppa, J. (1997). “Stability of steel columns in case of fire: Numerical modeling.”J. Struct. Engrg., ASCE, 123(6), 713–720.
14.
Tan, K. H., Fung, T. C., and Toh, W. S. ( 1999). “A first-order elastic-plastic analysis of steel frames in fire.” Proc., 7th East Asia-Pacific Conf. on Struct. Engrg. and Constr., H. Okamura and H. Shima, eds., Social System Institute, Tokyo, 423–428.
15.
Toh, W. S. ( 2000). “Strength and stability of steel structures under thermal effects.” PhD thesis, Nanyang Technological University, Singapore.
16.
Toh, W. S., Tan, K. H., and Fung, T. C. (2000). “Compressive resistance of steel columns in fire: Rankine approach.”J. Struct. Engrg., ASCE, 126(3), 398–405.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 127 • Issue 4 • April 2001
Pages: 461 - 469
History
Received: Feb 22, 2000
Published online: Apr 1, 2001
Published in print: Apr 2001
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.