Analysis for a Type of Structural Pounding
Publication: Journal of Structural Engineering
Volume 116, Issue 4
Abstract
The formulation and solution of the multiple degree of freedom equations of motion for a type of structural pounding are presented. The subject building undergoes pounding at a single floor level with a rigid adjacent building. The theory is implemented into a microcomputer program and sample analyses of an actual 15‐story building are performed to study the response behaviors. Pounding generates drifts, shears, and overturning moments in the stories above the pounding location that are greater than those from the case where pounding is ignored. It is concluded that: (1) Neglecting the effects of possible pounding leads to unconservative building design; (2) the sample analyses response behavior trends are robust thereby providing insight into the response behavior of other buildings; and (3) pounding can be studied on a case‐by‐case basis using the analytical tools presented in the paper (provided the formulation applies to the case of interest).
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Anagnostopoulos, S. A. (1988). “Pounding of buildings in series during earthquakes.” Earthquake Engrg. Struct. Dyn., 16, 443–456.
2.
Ban, S. (1974). “Collision of two adjacent buildings due to earthquake excitation.” Trans. Architectural Institute of Japan, 221, 1–7, Jul. (in Japanese.)
3.
Bertero, V. V. (1986). “Observations of structural pounding.” Proc. International Conference: The Mexico Earthquake—1985, ASCE.
4.
Bertero, V. V., and Collins, R. G. (1973). “Investigation of the failures of the Olive View Stairtowers during San Fernando earthquake and their implications on seismic design.” Report No. EERC 73‐26, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
5.
Blume, J. A., Newmark, N. M., and Corning, L. H. (1961). Design of multistory concrete buildings for earthquake motions, Portland Cement Assoc., Skokie, Ill., 60–61.
6.
Clough, R., and Penzien, J. (1975). Dynamics of structures, McGraw‐Hill Book Co., Inc., New York, N.Y., 555.
7.
Iwan, W. D. (1977). “Predicting the earthquake response of resiliently mounted equipment with motion‐limiting constraints.” Proc. Sixth World Conference on Earthquake Engineering, Int. Association of Earthquake Engrg., 3, 3292–3297.
8.
“Learning lessons from the rubble of Mexico City.” (1986). Engineering News‐Record. McGraw‐Hill Book Co., Inc., New York, N.Y., Sep. 4.
9.
Mahin, S. A., et al. (1976). “Response of the Olive View Hospital main building during the San Fernando earthquake.” Report No. EERC 76‐22, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
10.
Maison, B. F., and Kasai, K. (1988). SLAM: A computer program for the analysis of structural pounding. Jun. (available from the National Information Service for Earthquake Engrg., University of California, Berkeley, Calif.).
11.
Maison, B. F., and Neuss, C. F. (1983). SUPER‐ETABS: An enhanced version of the ETABS program. Technical Report to the National Science Foundation, J. G. Bouwkamp, Inc., Berkeley, Calif. Jan. (also available from National Information Service for Earthquake Engrg., Univ. of California, Berkeley, Calif.).
12.
Maison, B. F., Neuss, C. F., and Kasai, K. (1983). “The comparative performance of seismic response spectrum combination rules in building analysis.” Earthquake Engrg. and Struct. Dyn., 11(5), 623–647.
13.
Miller, R. K. (1980). “Steady vibroimpact at a seismic joint between adjacent structures.” Proc. Seventh World Conf. on Earthquake Engrg., Int. Association of Earthquake Engrg.
14.
Neuss, C. F., Maison, B. F., and Bouwkamp, J. G. (1983). “A study of computer modeling formulation and special analytical procedures for earthquake response of multistory buildings.” Technical Report to the National Science Foundation, J. G. Bouwkamp, Inc., Jan. (also available from National Information Service for Earthquake Engrg., Univ. of California, Berkeley, Calif.).
15.
Nigam, N. C., and Jennings, P. C. (1969). “Calculation of response spectra from strong‐motion earthquake records.” Bulletin of Seismological Society of America, 59(2), 909–922.
16.
Rea, D., Bouwkamp, J. G., and Clough, R. W. (1968). “The dynamic behavior of steel frame and truss buildings.” Bulletin No. 9, American Iron and Steel Inst., New York, N.Y.
17.
Rosenblueth, E., and Meli, R. (1986). “The 1985 earthquake: Causes and effects in Mexico City.” Concrete International, 8(5), 23–24.
18.
Takayama, K. (1973). “Earthquake response of a building collided with a neighboring building.” Proc. Fifth World Conf. on Earthquake Engrg., Int. Association of Earthquake Engrg., 2, 2211–2214.
19.
Tezcan, S. S., Yerlici, V., and Durgunoglu, H. T. (1978). “A reconnaissance report for the Romanian earthquake of 4 March 1977.” J. Earthquake Engrg. and Struct. Dyn., 6, 397–421.
20.
Uniform building code. (1985). International Conference of Building Officials, Whittier, Calif.
21.
Wada, A., Shinozaki, Y., and Nakamura, N. (1984). “Collapse of building with expansion joints through collision caused by earthquake motion.” Proc. Eighth World Conf. on Earthquake Engrg., Int. Association of Earthquake Engrg., Jul.
22.
Wilson, E. L., Hollings, J. P., and Dovey, H. H. (1975). “Three‐dimensional analysis of building systems” (extended version). Report No. UCB/EERC 75‐13, Earthquake Engrg. Res. Ctr., Univ. of California, Berkeley, Calif.
23.
Wolf, J. P., and Skrikerud, P. E. (1980). “Mutual pounding of adjacent structures during earthquakes.” J. Nucl. Engrg. Design, 57, 253–275.
Information & Authors
Information
Published In
Copyright
Copyright © 1990 ASCE.
History
Published online: Apr 1, 1990
Published in print: Apr 1990
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.