Premature Failure of Externally Plated Reinforced Concrete Beams
Publication: Journal of Structural Engineering
Volume 116, Issue 4
Abstract
Reinforced concrete beams can be strengthened and stiffened by gluing mild steel plates to the tension face of the beam. However, experimental tests show that these externally bonded plates have a tendency to peel away after the formation of shear diagonal cracks or when the curvature in the beam is increased. Fifty‐seven plated reinforced concrete beams are tested to study peeling induced by increasing curvature; in these tests, the geometry and material properties of the beams are varied, and the reinforced concrete beams are subjected to pre‐cracking and pre‐cambering, as might occur in an existing structure. A method is derived for determining the moment at which peeling starts (serviceability limit) and the moment that causes complete separation of the plate (ultimate limit). This method, which depends on the flexural rigidity of the plated beam, the thickness of the plate, and the tensile strength of the concrete, can be used to adjust the size and extent of plating so that flexural peeling does not occur under the design load.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Johnson, R. P., and Tait, C. J. (1981). “The strength in combined bending and tension of concrete beams with externally bonded reinforcing plates.” Build. Environ., 16(4), 287–299.
2.
Jones, R., Swamy, R. N., and Charif, A. (1988). “Plate separation and anchorage of reinforced concrete beams strengthened by epoxy‐bonded steel plates.” Struct. Engr., 66(5), 85–94.
3.
Moloney, G. F. K. (1986). “The repair and strengthening of reinforced concrete beams with externally bonded mild steel plates,” thesis presented to the National University of Ireland, at Cork, Ireland, in partial fulfillment of the requirements for the degree of Master of Engineering.
4.
Moran, J. P. (1988). “Separation of externally bonded steel plates from reinforced concrete beams in flexure,” thesis presented to the National University of Ireland, at Cork, Ireland, in partial fulfillment of the requirements for the degree of Master of Engineering.
5.
Ong, K. C. G., and Cusens, A. R. (1982). “Flexural tests of steel‐concrete open sandwiches.” Mag. Concr. Res., 34(120), 130–138.
6.
Parkinson, J. (1978). “Glue solves a sticky problem for Gestetner.” New Civ. Engr., 310, Sep., 26–27.
7.
Van Gemert, D. A. (1981). “Repairing of concrete structures by externally bonded steel plates.” Proc. ICP/RILEM/IBK Int. Symp. Plastics in Materials and Struct. Engrg., Prague, Czechoslovakia, 519–526.
Information & Authors
Information
Published In
Copyright
Copyright © 1990 ASCE.
History
Published online: Apr 1, 1990
Published in print: Apr 1990
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.