Nonlocal Smeared Cracking Model for Concrete Fracture
Publication: Journal of Structural Engineering
Volume 114, Issue 11
Abstract
The classical smeared cracking model widely used in finite‐element analysis of concrete and rock cannot describe the size effect experimentally observed in brittle failures and exhibits spurious mesh sensitivity with incorrect convergence to zero energy dissipation at failure. The crack band model circumvents these deficiencies but has limitations with respect to mesh refinement, shear locking on zig‐zag crack bands, and directional bias of the mesh. It is shown that all of these problems can be avoided by a nonlocal generalization, in which the damage that characterizes strain softening is considered to be a function of the spatial average of the positive part of the maximum principal strain. Two alternatives are presented: (1) Smeared cracking whose direction is fixed when cracks start to form; and (2) smeared cracking whose orientation rotates with the maximum principal strain. Furthermore, fracture tests on specimens of various sizes are analyzed by finite elements. It is shown that the model correctly reproduces the experimentally observed size effect and agrees with Bažant's size effect law. Orthogonal and slanted meshes are shown to yield approximately the same cracking zones and propagation directions. The model is easily programmed and computationally more efficient than the corresponding local version.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bažant, Z. P. (1976). “Instability, ductility and size effect in strain‐softening concrete.” J. Engrg. Mech., ASCE, 102(2), 331–344.
Discussions, 103, 357–358, 775–777;
104, 501–502
(based on Struct. Engrg. Report No. 74‐8/640, Northwestern University, August 1974).
2.
Bažant, Z. P. (1983). “Comment on orthotropic models for concrete and geomaterials.” J. Engrg. Mech., ASCE, 109(3), 849–865.
3.
Bažant, Z. P. (1984). “Size effect in blunt fracture: Concrete, Rock, Metal.” J. Engrg. Mech., ASCE, 110(4), 518–535.
4.
Bažant, Z. P. (1986). “Mechanics of distributed cracking.” Appl. Mech. Rev., ASME, 39(5), 675–705.
5.
Bažant, Z. P. (1987). “Snapback instability at crack ligament tearing and its implication for fracture micromechanics.” Cement and Concrete Res., 17(6), 951–967.
6.
Bažant, Z. P., Belytschko, T. B., and Chang, T. P. (1984). “Continuum theory for strain‐softening.” J. Engrg. Mech., ASCE, 110(12), 1666–1692.
7.
Bažant, Z. P., and Cedolin, L. (1979). “Blunt crack band propagation in finite element analysis.” J. Engrg. Mech., ASCE, 105(2), 297–315.
8.
Bažant, Z. P., and Cedolin, L. (1980). “Fracture mechanices of reinforced concrete.” J. Engrg. Mech., ASCE, 106(6), 1287–1306.
Discussion and Closure (1982), 108, 464–471.
9.
Bažant, Z. P., and Gambarova, P. (1981). “Rough cracks in reinforced concrete.” J. Struct. Engrg., ASCE, 106(4), 819–842.
Discussions and Closure, 2579–2581, 1377–1388.
10.
Bažant, Z. P., Lin, F. B., and Pijaudier‐Cabot G. (1987). “Yield limit degradation: Nonlocal continuum model with local strain.” Preprints, Int. Conf. on Computational Plasticity, held in Barcelona, D. R. J. Owen, E. Hinton, and E. Onate, eds. Univ. of Wales, Swansea, 1757–1780.
11.
Bažant, Z. P., and Oh, B. H. (1983). “Crack band theory for fracture of concrete.” Materials and Structures, RILEM, Paris, France, 16, 155–177.
12.
Bažant, Z. P., and Oh, B. H. (1984). “Rock fracture via strain‐softening finite elements.” J. Engrg. Mech., ASCE, 110(7), 1015–1035.
13.
Bažant, Z. P., and Pfeiffer, P. A. (1987). “Determination of fracture energy from size effect and brittleness number.” ACI Mat. J. 84 (Nov.–Dec.), 463–480.
14.
Bažant, Z. P., and Pijaudier‐Cabot, G. (1987). “Modeling of distributed damage by nonlocal continuum with local strain.” Preprints. 4th Intern. Conf. on Numerical Methods in Fracture Mechanics, A. R. Luxmore, D. R. J. Owen, and M. F. Kanninen, eds., held in San Antonio, Texas, Mar., 411–432.
15.
Bažant, Z. P., and Pijaudier‐Cabot, G. (1988). “Nonlocal continuum damage, localization instability and convergence.” J. Appl. Mech., ASME, 55(June), 287–293.
16.
Bažant, Z. P., and Prat, P. C. (1988). “Microplane model for brittle‐plastic material—I. Theory, II. Verification.” J. Engrg. Mech., ASCE, 114(10), 1672–1702.
17.
Cedolin, L., and Bažant, Z. P. (1980). “Effects of finite element choice in blunt crack band analysis.” Computer Methods in Appl. Mech. and Engrg. 24(3), 305–316.
18.
Darwin, D. (1985). “Concrete crack propagation—Study of model parameters.” Proc. Finite Element Analysis of Reinforced Concrete Structures. C. Meyer and H. Okamura, eds. ASCE, New York, 184–203.
19.
De Borst, R. (1984). “Application of advanced solution techniques to concrete cracking and non‐associated plasticity.” Numerical methods for non‐linear problems, C. Taylor et al., eds. Vol. 2, Pineridge Press, Swansea, United Kingdom, 314–325.
20.
De Borst, R, and Nauta, P. (1984). “Smeared crack analysis of reinforced concrete beams and slabs failing in shear.” Proc. Int. Conf. on Computer‐aided Analysis and Design of Concrete Structures, Split, Yugoslavia, 261–274.
21.
De Borst, R., and Nauta, P. (1985). “Non‐orthogonal cracks in a smeared finite element model.” Eng. Computation, 2, 35–46.
22.
Droz, P. (1987). “Numerical modeling of the non‐linear behavior of massive structures of unreinforced concrete,” doctoral thesis No. 682, Ecole Polytéchnique Fédérate de Lausanne, Switzerland.
23.
Eringen, A. C., and Edelen, D. G. B. (1972). “On nonlocal elasticity.” Int. J. Eng. Sci., No. 10, 233–248.
24.
“Finite element analysis of reinforced concrete.” (1982). State of the Art Report, prepared by Task Committees, chaired by A. H. Nilson, ASCE, New York, Chapter 4, 204–233.
25.
Gupta, A. K., and Akbar, H. (1984). “Cracking in reinforced concrete analysis.” J. Struct. Engrg., ASCE, 110(8), 1735.
26.
Hand, F. R., Pecknold, D. A., and Schnobrich, W. C. (1973). “Nonlinear layered analysis of RC plates and shells, J. Struct. Engrg., ASCE, 99(7), 1491–1505.
27.
Hillerborg, A. (1985). “Numerical methods to simulate softening and fracture of concrete.” Fracture mechanics of concrete: Structural application and numerical calculation, G. C. Sih and A. DiTomasso, eds. Martinus Nijhoff, Doordrecht‐Boston, 141–170.
28.
Hillerborg, A., Modéer, M., and Petersson, P. E. (1976). “Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elements.” Cement and Concrete Res. 6(6), 773–782.
29.
Ingraffea, A. (1985). “Fracture propagation in rock.” Mechanics of geomaterials: Rocks, concretes, soils, Z. P. Bažant, ed. John Wiley and Sons, Inc., New York, N.Y., 219–258.
30.
Ingraffea, A. R., and Saouma, V. (1985). “Numerical modeling of discrete crack propagation in reinforced and plain concrete.” Fracture mechanics of concrete: Structural application and numerical calculation, G. C. Sih and A. DiTomasso, eds. Martinus Nijhoff, Doordrecht‐Boston, 171–225.
31.
Leroy, Y., and Ortiz, M. (1988). “Finite element analysis of strain localization in frictional materials,” Report, Div. of Engrg., Brown Univ., Providence, R.I.
32.
Lin, C.‐S., and Scordelis, A. (1975). “Nonlinear analysis of RC shells of general form.” J. Struct. Engrg., ASCE, 101(3), 523–538.
33.
Marcheitas, A. H., Kulak, R. F., and Pan, Y. C. (1982). “Performance of blunt crack approach within a general purpose code.” Nonlinear numerical analysis of reinforced concrete, L. E. Schwer, ed. ASME, New York, N.Y., 107–123.
34.
Ngo, D., and Scordelis, A. C. (1967). “Finite element analysis of reinforced concrete beams.” ACI J. 64(3), 152–163.
35.
Pan, Y. C., Marchertas, A. H., and Kennedy, J. M. (1983). “Finite element analysis of blunt crack propagation, a modified J‐integral approach.” Trans. 7th Int. Conf. on Structural Mechanics in Reactor Technology, Paper H5/3, North‐Holland, Amsterdam, 235–292.
36.
Pan, Y. C., Marchertas, A. H., Pfeiffer, P. A., and Kennedy, J. M. (1984). “Concrete cracking simulations for nuclear applications.” Theoret. Appl. Fracture Mech., 2(1), 27–38.
37.
Pijaudier‐Cabot, G., and Bažant, Z. P. (1986). “Nonlocal damage theory.” Report No. 86‐8/428n, Center for Concrete and Geomaterials, Northwestern Univ., Evanston, Ill.
38.
Pijaudier‐Cabot, G., and Bažant, Z. P. (1987). “Nonlocal damage theory.” J. Engrg. Mech., ASCE, 113(10). 1512–1533.
39.
Rashid, Y. R. (1968). “Analysis of prestressed concrete pressure vessels.” Nuclear Engrg. and Design 7(4), 334–355.
40.
Suidan, M., and Schnobrich, W. C. (1973). “Finite element analysis of reinforced concrete.” J. Struct. Engrg., ASCE, 99(10), 2109–2122.
41.
Yuzugullu, O., and Schnobrich, W. C. (1973). “A numerical procedure for the determination of the behavior of a shear wall frame system.” ACI. J. 70(7), 474–479.
Information & Authors
Information
Published In
Copyright
Copyright © 1988 ASCE.
History
Published online: Nov 1, 1988
Published in print: Nov 1988
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.