Unsteady Flow in Installations with Polymeric Additional Pipe
Publication: Journal of Hydraulic Engineering
Volume 121, Issue 11
Abstract
This paper presents results of a theoretical and experimental study on the reduction of unsteady flow oscillations by using additional pipes of high-density polyethylene (HDPE) inserted at the upstream end of the pipeline in a pumping installation. The experiments generally show a reduction of the oscillations with respect to the case without the additional pipe. The reduction of the oscillations is higher for larger volumes of the device, while oscillations tend to be amplified for very small volumes. Experimental data are used to evaluate the mechanical parameters of the pipe material using a numerical model based on the method of characteristics. The additional pipe is treated as a lumped parameter system. The mechanical behavior of the HDPE is described both by a linear elastic model and by a Kelvin-Voigt viscoelastic model. The numerical tests show that the viscoelastic model better describes the general phenomenon, but the elastic model adequately estimates the maximum and minimum oscillations. An analytical solution for frictionless pipelines with the additional pipe considered as elastic is presented. The case of pipelines with friction is described in graphs that report the results of numerical integrations and allow the design of the device.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Allievi, L. (1903). “Teoria generale del moto perturbato dell'acqua nei tubi in pressione.”Annali Soc. Ing. Arch., Milan, Italy (in Italian).
2.
Allievi, L. (1934). “Arresto di una colonna liquida in moto ascendente.”L'Elettrotecnica, Milan, Italy, 21(30), 694–701 (in Italian).
3.
Bratland, O. (1986). “Frequency-dependent friction and radial kinetic energy variation in transient pipe flow.”Proc., 5th Int. Conf. on Pressure Surges, British Hydromechanics Research Association (BHRA), Cranfield, U.K., 95–101.
4.
Evangelisti, G. (1965). “Teoria generale del colpo d'ariete col metodo delle caratteristiche.”L'Energia Elettrica, Milan, Italy, 42(2–3), 65–90, 145–162 (in Italian).
5.
Evangelisti, G. (1969). “Water hammer analysis by the method of the characteristics.”L'Energia Elettrica, Milan, Italy, 46(10–12), 673–692, 759–771, 839–858.
6.
Ferry, J. D. (1980). Viscoelastic properties of polymers . John Wiley and Sons, Chichester, U.K.
7.
Franke, P. G., and Seyler, F.(1983). “Computation of unsteady pipe flow with respect to visco-elastic material properties.”J. Hydr. Res., Delft, The Netherlands, 21(5), 345–353.
8.
Ghilardi, P., and Paoletti, A. (1986a). “I parametri viscoelastici per lo studio dei transitori idraulici in condotte di materiale polimerico.”Atti, XX Conv. di Idraulica e Costruzioni Idrauliche, Edizioni Libreria Progetto, Padua, Italy, 993–1106 (in Italian).
9.
Ghilardi, P., and Paoletti, A. (1986b). “Additional viscoelastic pipes as pressure surges suppressors.”Proc., 5th Int. Conf. on Pressure Surges, British Hydromechanics Research Association (BHRA), Cranfield, U.K., 113–121.
10.
Ghilardi, P., and Paoletti, A. (1987). “Problemi relativi al moto vario in condotti viscoelastici.”L'Energia Elettrica, Milan, Italy, 64(7–8), 273–282 (in Italian).
11.
Grundy, A. K., and Fox, J. A. (1980). “The effect of compressible pipe-liners on pressure transient generation.”Proc., 3rd Int. Conf. on Pressure Surges, British Hydromechanics Research Association (BHRA), Cranfield, U.K., 241–260.
12.
Guney, M. S. (1983). “Waterhammer in viscoelastic pipes where cross-section parameters are time dependent.”Proc., 4th Int. Conf. on Pressure Surges, British Hydromechanics Research Association (BHRA), Cranfield, U.K., 189–204.
13.
Jaeger, C. (1977). Fluid transients . Blackie, Glasgow, U.K.
14.
Larson, M., and Jonsson, L.(1991). “Elastic properties of pipe materials during hydraulic transients.”J. Hydr. Engrg., ASCE, 117(10), 1317–1331.
15.
Massouh, F., and Comolet, R. (1984). “Étude d'un système antibélier en ligne.”La Houille Blanche, Paris, France, 39(5), 355–361 (in French).
16.
Modica, C., and Pezzinga, G. (1992). “Un modello quasi bidimensionale per il moto vario elastico in regime turbolento.”Atti, XXIII Conv. di Idraulica e Costruzioni Idrauliche, Officine Grafiche Tecnoprint, Bologna, Italy, E191–E206 (in Italian).
17.
Pezzinga, G. (1986). “Moto vario in condotte di sollevamento a caratteristiche geometriche ed elastiche non uniformi.”Atti, XX Conv. di Idraulica e Costruzioni Idrauliche, Edizioni Libreria Progetto, Padua, Italy, 1017–1026 (in Italian).
18.
Pezzinga, G. (1988). “Transitori in condotte di sollevamento con tronchi a comportamento viscoelastico.”L'Energia Elettrica, Milan, Italy, 65(7–8), 293–302 (in Italian).
19.
Pezzinga, G. (1990). “Su alcuni fenomeni di risonanza in sistemi idraulici in pressione.”Pubbl. n. 133 dell'Istituto di Idraulica Idrologia e Gestione delle Acque, Università di Catania, Catania, Italy (in Italian).
20.
Rieutord, E., and Blanchard, A. (1979). “Ecoulement non permanent en conduite viscoelastique—coup de bélier.”J. Hydr. Res., Delft, The Netherlands, 17(3), 217–229 (in French).
21.
Vardy, A. E., and Hwang, K.(1991). “A characteristics model of transient friction in pipes.”J. Hydr. Res., Delft, The Netherlands, 29(5), 669–684.
22.
Wylie, E. B., and Streeter, V. L. (1982). Fluid transients, FEB PRESS, Ann Arbor, Mich.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Nov 1, 1995
Published in print: Nov 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.