Infiltration and Saturated Hydraulic Conductivity of Compacted Clay
Publication: Journal of Geotechnical Engineering
Volume 121, Issue 10
Abstract
Infiltration tests were conducted in the laboratory to study water movement during infiltration in compacted clay and to determine the suction head at the wetting front as defined in the Green-Ampt infiltration equation. Tests were conducted on two clays, having low and high plasticity indices. Results of the tests show that the wetting front is diffuse and becomes increasingly so as it penetrates deeper into the soil. The wetting front is also more diffuse for molding water contents near or wet of optimum water content and for clay with higher plasticity index. Suction head at the wetting front has been found to decrease as the wetting front penetrates into the soil, with the rate of dissipation depending on the molding water content and soil type. For the clay with low plasticity index, the initial suction head at the wetting front was largest and decreased the fastest when the molding water content was near optimum. For the clay with high plasticity index, similar initial suction head and rate of dissipation were measured at various molding water contents. Soil-specific equations are presented to estimate the suction head at the wetting front using the air-entry pressure.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Acar, Y., and Oliveri, I. (1990). “Pore fluid effects on the fabric and hydraulic conductivity of laboratory-compacted clay.”Transp. Res. Record 1219, Transp. Res. Board, Washington, D.C., 144–159.
2.
ASTM. (1993). “Soil and rock; dimension stone; geosynthetics.”Annual book of standards, Vol. 04.08, Philadelphia, Pa.
3.
Avci, C., Bodine, D., and Guler, E. (1994). “Effects of swelling on permeability calculations obtained from sealed double ring infiltrometer tests.”Proc., 1st Int. Conf. on Envir. Geotechnics, BiTech Publishers, Richmond, British Columbia, Canada, 127–132.
4.
Benson, C., and Daniel, D.(1990). “Influence of clods on hydraulic conductivity of compacted clay.”J. Geotech. Engrg., ASCE, 116(8), 1231–1248.
5.
Benson, C., and Boutwell, G. (1992). “Compaction control criteria and field-scale hydraulic conductivity of clay liners.”Proc., 15th Annu. Waste Conf., Dept. Engrg. Profl. Dev., Univ. of Wisconsin, 62–83.
6.
Bouwer, H.(1964). “Unsaturated flow in ground-water hydraulics.”J. Hydr. Div., ASCE, 90(5), 121–144.
7.
Bouwer, H. (1966). “Rapid field measurement of air entry value and hydraulic conductivity of soil as significant parameters in flow system analysis.”Water Resour. Res., Vol. 2, 729–732.
8.
Bouwer, H.(1969). “Infiltration of water into nonuniform soil.”J. Irrig. and Drain. Div., ASCE, 95(4), 451–461.
9.
Brooks, R., and Corey, A.(1966). “Properties of porous media affecting fluid flows.”J. Irrig. and Drain. Div., ASCE, 92(2), 61–88.
10.
Colman, E., and Hendrix, T. (1949). “The Fiberglas electrical soil-moisture instrument.”Soil Sci., Vol. 67, 425–429.
11.
Daniel, D. (1994). “State-of-the-art: laboratory hydraulic conductivity tests for saturated soils.”Hydraulic conductivity and waste contaminant transport in soils; ASTM STP 1142, S. Trautwein and D. Daniel, eds., ASTM, Philadelphia, Pa., 30–78.
12.
Daniel, D., Burton, P., and Hwang, S. (1992). “Evaluation of four vadose zone monitoring probes used for leak detection and monitoring.”Current practices in ground water and vadose zone investigations; ASTM STP 1118, D. Nielsen and M. Sara, eds., ASTM, Philadelphia, Pa., 124–139.
13.
Devaurs, M., and Gifford, G.(1986). “Applicability of the Green and Ampt infiltration equation to rangelands.”Water Resour. Bull., AWRA, 22(1), 19–26.
14.
Dunn, J., and Palmer, B. (1994). “Lessons learned from the application of standard test methods for field and laboratory measurement of hydraulic conductivity.”Hydraulic conductivity and waste contaminant transport in soils; ASTM STP 1142, S. Trautwein and D. Daniel, eds., ASTM, Philadelphia, Pa., 335–352.
15.
Elrick, D., Reynolds, W., Parkin, G., and Fallow, D. (1992). “Ponded infiltration from rings and auger holes: an historical perspective.”Proc., Colloquium on Porous or Fractured Unsaturated Media: Transport and Behavior, Ecole Polytechnique Federale de Lausanne, Lausanne, Switzerland, 143–154.
16.
Fernuik, N., and Haug, M.(1990). “Evaluation of in situ permeability testing methods.”J. Geotech. Engrg., ASCE, 116(2), 797–311.
17.
Flerchinger, G., and Watts, F. (1987). “Predicting infiltration parameters for a road sediment model.”Trans. ASAE, Vol. 30, 1700–1705.
18.
Fredlund, D., Xing, A., and Huang, S.(1994). “Predicting the permeability function for unsaturated soils using the soil-water characteristic curve.”Can. Geotech. J., 31(4), 533–546.
19.
Green and Ampt. (1911). “Studies on soil physics. Part I: the flow of air and water through soils.”J. Agr. Res., Vol. 4, 1–24.
20.
Jury, W., Gardner, W. R., and Gardner, W. H. (1991). Soil physics . John Wiley & Sons, Inc., New York, N.Y.
21.
Meerdink, J. (1994). “Unsaturated hydraulic conductivity of barrier soils used for final covers,” MS thesis, Univ. of Wisconsin–Madison.
22.
Mein, R., and Farrell, D. (1974). “Determination of wetting front suction in the Green-Ampt equation.”Proc., Soil Sci. Soc. Am., Vol. 38, 872–876.
23.
Mitchell, J., Hooper, D., and Campanella, R.(1965). “Permeability of compacted clay.”J. Soil Mech. and Found. Div., ASCE, 91(4), 41–65.
24.
Morel-Seytoux, H., and Khanji, J.(1974). “Derivation of an equation of infiltration.”Water Resour. Res., 10(4), 795–800.
25.
Neuman, S.(1976). “Wetting front pressure head in the infiltration model of Green and Ampt.”Water Resour. Res., 12(3), 564–565.
26.
Philip, J. (1957a). “The theory of infiltration. 1: The infiltration equation and its solution.”Soil Sci., Vol. 83, 345–357.
27.
Philip, J. (1957b). “The theory of infiltration. 3: Moisture profiles and relation to experiment.”Soil Sci., Vol. 83, 163–179.
28.
Philip, J. (1958). “The theory of infiltration. 4: Sorptivity and algebraic infiltration equations.”Soil Sci., Vol. 84, 257–264.
29.
Stephens, D., Unruh, M., Havlena, J., Knowlton, R., Mattson, E., and Cox, W.(1988). “Vadose zone characterization of low-permeability sediments using field permeameters.”Ground Water Monitoring Rev., 8(2), 59–66.
30.
Tanner, C., and Elrick, D. (1958). “Volumetric porous (pressure) plate apparatus for moisture hysteresis measurements.”Proc., Soil Sci. Soc. Am., Vol. 22, 575–576.
31.
Trautwein, S., and Boutwell, G. (1993). “In-situ hydraulic conductivity tests for compacted soil liners and caps.”Hydraulic conductivity and waste contaminant transport in soils; ASTM STP 1142, S. Trautwein and D. Daniel, eds., ASTM, Philadelphia, Pa., 184–223.
32.
van Genuchten, M. T. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.”Soil Sci. Soc. Am. J., Vol. 44, 892–898.
33.
Wang, X. (1993). “Evaluating suction head at the wetting front during infiltration in two compacted clays,” MS thesis, Univ. of Wisconsin–Madison.
Information & Authors
Information
Published In
Journal of Geotechnical Engineering
Volume 121 • Issue 10 • October 1995
Pages: 713 - 722
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Oct 1, 1995
Published in print: Oct 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.