TCLP Heavy Metal Leaching of Personal Computer Components
Publication: Journal of Environmental Engineering
Volume 132, Issue 4
Abstract
Electronic waste (E-waste), including all obsolete electronic products, has become the fastest growing component in the solid waste stream. Personal computers (PCs)—the most significant component in E-waste stream—were studied for their potential leaching toxicity of contaminants. All the components in a PC that are composed of, or contain printed wire boards (PWBs) including the motherboard, various expansion cards, disk drives, and power supply unit were tested by the toxicity characteristic leaching procedure (TCLP). The total contents of eight heavy metals including arsenic, barium, cadmium, chromium, lead, mercury, selenium, and silver in the PWBs and their TCLP leaching from the PWBs were examined. Among these eight heavy metals lead was found to be the predominant element that causes the toxicity characteristic of the PC components. The lead concentrations in the TCLP extracts of the vast majority of the PWBs ranged from 150 to , which are 30–100 times the regulatory level of for classifying a waste as hazardous. The motherboard in a PC contributed 50–80% of the total lead that could leach out from all the PWBs in the PC under the TCLP test conditions. The contents of barium and silver were found to be high in some components, but they were not leachable under the TCLP test conditions. The contents of other five elements in all the PC components were hardly detectable. They would not have the potential to cause toxicity characteristic leaching concern.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgment
This paper is based upon work supported by the National Science Foundation under Grant No. NSFBES-0238765.
References
Environmental Protection Agency (EPA). (1992a). “Method 1311: Toxicity characteristic leaching procedure.” SW-846 test methods for evaluating solid wastes, ⟨http://www.epa.gov/epaoswer/hazwaste/test/main.htm⟩ (Jan. 7, 2003).
Environmental Protection Agency (EPA). (1992b). “Method 7000A: Atomic absorption method.” SW-846 test methods for evaluating solid wastes, ⟨http://www.epa.gov/epaoswer/hazwaste/test/main.htm⟩ (Jan. 7, 2003).
Environmental Protection Agency (EPA). (1994). “Method 7471A: Mercury in solid or semisolid waste (manual cold-vapor technique).” SW-846 test methods for evaluating solid wastes, ⟨http://www.epa.gov/epaoswer/hazwaste/test/main.htm⟩ (Jan. 7, 2003).
Environmental Protection Agency (EPA). (1996a). “Method 3050B: Acid digestion of sediments, sludges, and soils.” SW-846 test methods for evaluating solid wastes, ⟨http://www.epa.gov/epaoswer/hazwaste/test/main.htm⟩ (Jan. 7, 2003).
Environmental Protection Agency (EPA). (1996b). “Method 6010B: Inductively coupled plasma-atomic emission spectrometry.” SW-846 test methods for evaluating solid wastes, ⟨http://www.epa.gov/epaoswer/hazwaste/test/main.htm⟩ (Jan. 7, 2003).
Environmental Protection Agency (EPA). (1999). “Identification and listing of hazardous wastes, toxicity characteristics.” Code of Federal Regulations, 40 CFR 261.24, Vol. 18, No. 261, 55–56.
Environmental Protection Agency (EPA). (2002). “Hazardous waste management system; modification of the hazardous waste program; cathode ray tubes and mercury-containing equipment; proposed rule.” Federal Register, 67(113) (June 12).
Environmental Protection Agency (EPA). (2003). “Municipal solid waste in the United States: 2001 facts and figures.” Rep. No. EPA530-R-03-011, Office of Solid Waste and Emergency Response, Washington, D.C.
Harper, C. A. (2000). Electronic packaging and interconnection handbook, 3rd Ed., McGraw-Hill, New York.
Jang, Y. C., and Townsend, T. G. (2003). “Leaching of lead from computer printed wired boards and cathode ray tubes by municipal solid waste landfill leachates.” Environ. Sci. Technol., 37, 4778–4784.
Lee, C. H., and Hsi, C. S. (2002). “Recycling of scrap cathode ray tubes.” Environ. Sci. Technol., 36, 69–75.
Murray, M. (2004). “Electronics comes clean–solving the E-waste crisis in California.” Waste Manage., March–April, 59–65.
Schmidt, D. W. (2002). “E-junk explosion.” Environ. Health Perspect., 110(4), 188–194.
Silicon Valley Toxics Coalition (SVTC). (2004). “Poison PCs and toxic TVs.” Rep., Silicon Valley Toxics Coalition, California, ⟨http://www.svtc.org/cleancc/pubs/poisonpc2004.htm⟩ (Feb. 10, 2004).
Smith, D., Small, M., Dodds, R., Amagai, S., and Strong, T. (1996). “Computer monitor recycling: A case study.” Eng. Sci. Educ. J., 5(4), 159–164.
Townsend, G. T., Musson, S., Jang, Y. C., and Chung, I. H. (1999). “Characterization of lead leachability from cathode ray tubes using the toxicity characteristic leaching procedure.” Rep. No. 99-5, Florida Center for Solid and Hazardous Waste Management, Univ. of Florida, Gainesville, Fla.
Yang, G. C. C. (1992). “Environmental threats of discarded picture tubes and printed wire boards.” J. Hazard. Mater., 34, 235–243.
Information & Authors
Information
Published In
Copyright
© 2006 ASCE.
History
Received: Aug 27, 2004
Accepted: Jul 15, 2005
Published online: Apr 1, 2006
Published in print: Apr 2006
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.