Biological Removal of Gaseous VOCs from Automotive Painting Operations
Publication: Journal of Environmental Engineering
Volume 126, Issue 8
Abstract
Among the pollutants that automotive plants produce, volatile organic compound (VOC) emissions due to paint solvents from painting operations are the largest in quantity. The current control process, based on vapor-phase adsorption followed by thermal oxidation, is costly to install and operate. At Ford, a cost-effective method of removing VOCs has been investigated that involves converting an existing spraybooth scrubber system to a biological reactor. This paper reports the results of a pilot-scale investigation in which two activated-sludge bioreactors, one with and the other without powdered activated carbon (PAC), were operated in parallel for 16 months. The primary findings include (1) The biological VOC removal process was technically feasible, and a scrubber system at a typical assembly plant is sufficiently large to handle the solvent loading used under normal vehicle-production conditions; (2) as compared to the adsorption/thermal oxidation process, the biological process was found to be comparable in VOC removal efficiency, an order of magnitude more cost-effective in capital cost, and a factor of two more cost-effective in operating and maintenance cost; and (3) the bioreactors effectively captured and degraded hydrophilic paint solvents (methyl ethyl ketone, n-butanol, and butyl cellosolve) that were fed via the vapor phase. Toluene, a hydrophobic solvent, was also well-captured and degraded (74 to 91% without PAC and 86 to 93% with PAC).
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bridié, A. L., Wolff, C. J. M., and Winter, M. (1979). “BOD and COD of some petrochemicals.” Water Res., 13, 627–630.
2.
Clysters, H. M. L. (1992). “Air pollution control at Ford plants in Europe—Emissions from paint operations.” Tech. Paper 920191, Society of Automotive Engrs., Warrendale, Pa.
3.
Ford Motor Company. (1998). Envir. Rep., Dearborn, Mich.
4.
Hach Company. (1992). Water Anal. Handbook, 2nd Ed., Loveland, Colo.
5.
Kia, S. F., Rai, D. N., and Williams, R. L. (1996). “Extent of solvents and chemical oxygen demand build-up in boothwater systems using waterborne paint.” J. Coatings Technol., 68, 87–95.
6.
Kim, B. R., et al. (1998). “Biological removal of gaseous VOCs from automotive painting using activated sludge.” Proc., 71st Water Envir. Fedn. Annu. Conf., Water Environment Federation, Alexandria, Va.
7.
Kim, B. R., Kalis, E. M., DeWulf, T., and Andrews, K. M. (2000a). “Henry's law constants for paint solvents and their implications on VOC emissions from automotive painting.” Water Envir. Res., (72), 65–74.
8.
Kim, B. R., et al. (1996). “Evaluating paint-sludge chars for the adsorption of selected paint solvents.”J. Envir. Engrg., ASCE, 122(6), 532–539.
9.
Kim, B. R., and Pingel, L. J. (1989). “Removal of toluene from air using PAC/water slurry reactor.”J. Envir. Engrg., ASCE, 115(5), 1025–1045.
10.
Kim, B. R., Podsiadlik, D. H., Yeh, D. H., Salmeen, I. T., and Briggs, L. M. (1997). “Evaluating the conversion of an automotive paint spraybooth scrubber to an activated sludge system for removing paint VOCs.” Water Envir. Res., 69, 1211–1221.
11.
Kim, B. R., Zinbo, M., Adams, J. A., and Young, W. C. (2000b). “Nonbiodegradable organic compounds found in automotive spraybooth scrubber water.” Water Envir. Res., 72(4).
12.
Kolta, T. (1992). “Selecting equipment to control air pollution from automotive painting operations.” Tech. Paper Ser. 920189, Society of Automotive Engrs., Warrendale, Pa.
13.
Kruse, C. W., et al. (1994). “Use of char for management of paint processing waste.” HWRIC TR-018, Final Rep. Prepared for Hazardous Waste Research and Information Center, HWRIC Proj. No. HWR 92-099, Illinois Department of Energy and Natural Resources, Champagne, Ill.
14.
Metcalf & Eddy. (1991). Wastewater engineering, treatment, disposal, and reuse, 3rd Ed., McGraw-Hill, New York, 83 and 550.
15.
U.S. Environmental Protection Agency. (1983). “Methods for chemical analysis of water and wastes.” EPA-600/4-79-020, Washington, D.C.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 126 • Issue 8 • August 2000
Pages: 745 - 753
History
Received: Apr 26, 1999
Published online: Aug 1, 2000
Published in print: Aug 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.