Methodology for Control Delay Estimation Using New Algorithm for Critical Points Identification
Publication: Journal of Transportation Engineering, Part A: Systems
Volume 144, Issue 2
Abstract
Control delay, as a primary indicator of signalized intersection performance, is commonly estimated using analytical models due to difficulty of field measurements. This paper presents a new methodology for control delay estimation using vehicle speed profiles obtained by a global positioning system (GPS) device. An algorithm developed for critical delay points identification is based on threshold values of two parameters: average acceleration and deceleration rate, and a newly established parameter, phase duration. Based on the created algorithm, a five-step procedure is suggested for individual vehicle control delay calculation. The methodology was successfully tested on 112 sample runs at two signalized intersections. Detailed analysis of the acceleration and deceleration processes has shown that these two processes have different characteristics and effects on delay. In contrast to other studies, it was found that acceleration-deceleration delay depends on variation of acceleration delay and cannot be considered as constant. A slightly lower delay value was obtained by the suggested methodology, indicating that the new parameter could eliminate delay that is not affected by traffic signals.
Get full access to this article
View all available purchase options and get full access to this article.
References
Benekohal, R. F. (1992). “Real-time delay measurement and intersection analysis system.” Proc., 4th Int. Conf. on Microcomputers in Transportation, ASCE, New York, 285–296.
Boonsiripant, S., Hunter, M., Dixon, K., and Rodgers, M. (2010). “Measurement and comparison of acceleration and deceleration zones at traffic control intersections.” Transp. Res. Rec., 2171, 1–10.
Čelar, N. (2013). “Contribution to the traffic process analysis at signalized intersections.” Ph.D. thesis, Univ. of Belgrade, Belgrade, Serbia.
Colyar, J., and Rouphail, N. (2003). “Measured distributions of control delay on signalized arterials.” Transp. Res. Rec., 1852, 1–9.
Ko, J., Hunter, M., and Guensler, R. (2007). “Measuring control delay using second-by-second GPS speed data.” Transportation Research Board 86th Annual Meeting, National Research Council, Washington, DC.
Liu, K., Yamamoto, T., and Morikawa, T. (2006). “Estimating delay time at signalized intersections by probe vehicles.” Proc., 5th Int. Conf. on Traffic and Transportation Studies, Xi’an, China, 644–655.
Mousa, R. M. (2002). “Analysis and modeling of measured delays at isolated signalized intersections.” J. Transp. Eng., 347–354.
National Research Council. (1994). Highway capacity manual 1994, Transportation Research Board, Washington, DC.
Olszewski, P. (1993). “Overall delay, stopped delay, and stops at signalized intersections.” J. Transp. Eng., 835–852.
Quiroga, C. A., and Bullock, D. (1999). “Measuring control delay at signalized intersections.” J. Transp. Eng., 271–280.
Richardson, A. J. (1979). “Measurement of the performance of signalized intersections.” Transp. Res. Rec., 699, 49–60.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Mar 21, 2017
Accepted: Jul 24, 2017
Published online: Nov 23, 2017
Published in print: Feb 1, 2018
Discussion open until: Apr 23, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.