Physical Model Test Investigation of Mechanical Properties of Double Pipe Culverts Subjected to Vertical Loading
Publication: Journal of Pipeline Systems Engineering and Practice
Volume 15, Issue 1
Abstract
The performance of double-pipe culverts remains unclear due to insufficient research on double culverts. This study made use of polyvinyl chloride pipe to simulate culverts. The effect of culvert spacing and fill height on the mechanical properties of double-pipe culverts before and after expanded polystyrene (EPS) plate load reduction was investigated through a series of model tests, and the results were compared with those obtained from single-pipe culverts. It was found that the earth pressure at the top of the culvert was the smallest when the culvert spacing was (where is the diameter of the double-pipe culvert). When compared with the single-pipe culvert, the earth pressure at the top of the culvert was smaller than that of the single-pipe culverts; only when the culvert spacing was , the earth pressure on the right side of the culvert was slightly larger than that of the single-pipe culvert. The earth pressure at the top of the culvert could be reduced by 20% before load reduction and by 42% after load reduction. The effect of fill height on earth pressure was small, but it could reduce the circumferential strain of the culvert pipe.
Practical Applications
With the widespread use of double-pipe culverts, the study of double-pipe culverts is crucial. However, the current research on double-pipe culverts is insufficient. In order to understand the mechanical characteristics of double-pipe culverts, this study simulated double-pipe culverts through model tests. The influence of culvert spacing and filling height on the mechanical properties of double-pipe culverts with EPS plate before and after load reduction was studied and compared with single-pipe culverts with the same drainage capacity. The results showed that the replacement of single-pipe culverts with double-pipe culverts can effectively reduce the earth pressure at the culvert top and lateral. The earth pressure at the top of the culvert will be reduced by 20% before and 42% after EPS load reduction. The earth pressure on the top of double-pipe culvert decreases with the decrease of culvert spacing, and the circumferential strain of the pipe culvert can be effectively reduced with the increase of filling height.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
Acknowledgments
The authors are grateful for financial support from the National Natural Science Foundation of China (No. 52078194), the Innovation Demonstration Base of Ecological Environment Geotechnical and Ecological Restoration of Rivers and Lakes (No. 2020EJB004), the National Young Top-Notch Talent of the “Ten Thousand Talents Program” and The Young Top-Notch Talent Cultivation Program of Hubei Province, and the Outstanding Young and middle-aged Science and Technology Innovation Team of colleges and universities in Hubei Province (T2022010).
References
AbdelSalam, S. S., R. A. Jama, and M. A. Salah. 2019. “EPS inclusion to reduce vertical stresses on shallow tunnels.” Geosynth. Int. 26 (2): 121–135. https://doi.org/10.1680/jgein.18.00042.
ACI (American Concrete Institute). 2016. “Measured load capacity of buried reinforced concrete pipes.” ACI Struct. J. 113 (1): 63–73. https://doi.org/10.14359/51688059.
Al-Naddaf, M., J. Han, C. Xu, and S. M. Rahmaninezhad. 2019. “Effect of geofoam on vertical stress distribution on buried structures subjected to static and cyclic footing loads.” J. Pipeline Syst. Eng. Pract. 10 (1): 04018027. https://doi.org/10.1061/(ASCE)PS.1949-1204.0000355.
ASTM. 2017. Standard test methods for particle-size distribution (gradation) of soils using sieve analysis. ASTM D6913. West Conshohocken, PA: ASTM.
Azizian, M., S. N. M. Tafreshi, and N. J. Darabi. 2020. “Experimental evaluation of an expanded polystyrene (EPS) block-geogrid system to protect buried pipes.” Soil Dyn. Earthquake Eng. 129 (Feb): 105965. https://doi.org/10.1016/j.soildyn.2019.105965.
Bartlett, S. F., B. N. Lingwall, and J. Vaslestad. 2015. “Methods of protecting buried pipelines and culverts in transportation infrastructure using EPS geofoam.” Geotext. Geomembr. 43 (5): 450–461. https://doi.org/10.1016/j.geotexmem.2015.04.019.
Bourque, S. 2002. “Centrifuge and numerical modeling of induced trench twin conduits.” Master’s thesis, Dept. of Civil Engineering, Univ. of New Brunswick.
Chen, B., and L. Sun. 2013. “The impact of soil properties on the structural integrity of high-fill reinforced concrete culverts.” Comput. Geotech. 52 (1): 46–53. https://doi.org/10.1016/j.compgeo.2013.03.006.
Chen, B., and L. Sun. 2014. “Performance of a reinforced concrete box culvert installed in trapezoidal trenches.” J. Bridge Eng. 19 (1): 120–130. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000494.
Chinese Standard. 2020. Specifications for design of highway culverts. [In Chinese.] JTG/T 3365. Beijing: China Communication Press.
Gu, A. Q., Z. F. Lv, F. L. Jiang, and Z. Yang. 2009. “Load reduction tests and design methods for culverts with high fill soil using EPS slabs.” [In Chinese.] Chin. J. Geotech. Eng. 31 (10): 1481–1486. https://doi.org/10.1016/S1874-8651(10)60073-7.
Kang, J. 2019. “Finite element analysis for deeply buried concrete pipes in proposed imperfect trench installations with expanded polystyrene (EPS) foams.” Eng. Struct. 189 (Jun): 286–295. https://doi.org/10.1016/j.engstruct.2019.03.083.
Kazempour, S., R. J. Chenari, H. Ahmadi, M. Payan, and K. Senetakis. 2021. “Assessment of the compression characteristics and coefficient of lateral earth pressure of aggregate-expanded polystyrene beads composite fill-backfill using large oedometer experiments.” Constr. Build. Mater. 302 (Oct): 124145. https://doi.org/10.1016/j.conbuildmat.2021.124145.
Khalaj, O., S. M. A. G. Siabil, M. Azizian, S. N. M. Tafreshi, B. Masek, M. Kepka, and H. Jirkova. 2020. “Experimental and numerical investigation of expanded polystyrene (EPS) geofoam samples under monotonic loading.” Geomech. Eng. 22 (6): 475–488. https://doi.org/10.12989/gae.2020.22.6.475.
Kim, H., B. Choi, and J. Kim. 2010. “Reduction of earth pressure on buried pipes by EPS geofoam inclusions.” Geotech. Test. J. 33 (4): 1–10. https://doi.org/10.1520/GTJ102315.
Li, L., J. Yang, H. Xiao, L. Zhang, Z. Hu, and Y. Liu. 2020a. “Behavior of tire-geogrid-reinforced retaining wall system under dynamic vehicle load.” Int. J. Geomech. 20 (4): 04020017. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001566.
Li, S., G. Han, I. H. Ho, L. Ma, Q. Wang, and B. Yu. 2020b. “Coupled effect of cross-sectional shape and load reduction on high-filled cut-and-cover tunnels considering soil–structure interaction.” Int. J. Geomech. 20 (7): 04020082. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001696.
Ma, Q., C. Huang, H. Xiao, and Z. Chen. 2018. “Embankment filling loads on an assembled concrete culvert beneath high embankment.” Int. J. Corros. 2018 (Jan): 1–11. https://doi.org/10.1155/2018/9870673.
Ma, Q., Z. Ku, H. Xiao, and B. Hu. 2019a. “Calculation of earth pressure on culvert underlying flexible subgrade.” Results Phys. 12 (Mar): 535–542. https://doi.org/10.1016/j.rinp.2018.11.100.
Ma, Q., Z. Ku, and H. L. Xiao. 2019b. “Model tests of earth pressure on buried rigid pipes and flexible pipes underneath expanded polystyrene (EPS).” Adv. Civ. Eng. 2019 (PT.2): 1–13. https://doi.org/10.1155/2019/9156129.
Ma, Q., J.-J. Zheng, and H.-L. Xiao. 2019c. “Analysis of pressure on the roof of a culvert underneath a ditch with compressible material covered by a geosynthetic layer.” Eur. J. Environ. Civ. Eng. 25 (6): 1025–1041. https://doi.org/10.1080/19648189.2018.1564703.
Marston, A. 1930. “The theory of external loads on closed conduits in the light of the latest experiments.” In Proc., 9th Annual Meeting of the Highway Research Board, 138–170. Washington, DC: Highway Research Board.
Marston, A., and A. Anderson. 1913. The theory of loads on pipes in ditches: And tests of cement and clay drain tile and sewer pipe. Ames, IA: Iowa State College of Agriculture and Mechanic Arts.
McAffee, R. P. 2005. “Soil-structure interaction in rigid culverts installed in induced trenches.” Ph.D. dissertation, Dept. of Civil Engineering, Univ. of New Brunswick.
McGuigan, B. L., and A. J. Valsangkar. 2011a. “Earth pressures on twin positive projecting and induced trench box culverts under high embankments.” Can. Geotech. J. 48 (2): 173–185. https://doi.org/10.1139/T10-058.
McGuigan, B. L., and A. J. Valsangkar. 2011b. “Field monitoring and analysis of twin 3660 mm inside diameter induced trench culverts installed under 21.7 m of fill.” Can. Geotech. J. 48 (5): 781–794. https://doi.org/10.1139/t11-002.
Pires, A. C. G., and E. M. Palmeira. 2021. “The influence of geosynthetic reinforcement on the mechanical behaviour of soil-pipe systems.” Geotext. Geomembr. 49 (5): 1117–1128. https://doi.org/10.1016/j.geotexmem.2021.03.006.
Rakitin, B., and M. Xu. 2014. “Centrifuge modeling of large diameter underground pipes subjected to heavy traffic loads.” Can. Geotech. J. 51 (4): 353–368. https://doi.org/10.1139/cgj-2013-0253.
Spangler, M. G. 1951. “A theory on loads on negative projecting conduits.” In Proc., 13th Annual Meeting of the Highway Research Board, 153–161. Washington, DC: Highway Research Board.
Tao, Q. D., Z. Y. He, and Y. Jia. 2020. “Influence of filling properties and culvert structure parameters on the soil arching effect of upper-buried-type culverts.” Results Phys. 16 (6): 103003. https://doi.org/10.1016/j.rinp.2020.103003.
Trandafir, A. C., S. F. Bartlett, and B. N. Lingwall. 2010. “Behavior of EPS geofoam in stress-controlled cyclic uniaxial tests.” Geotext. Geomembr. 28 (6): 514–524. https://doi.org/10.1016/j.geotexmem.2010.01.002.
Viswanadham, B. V. S., and R. R. Mahajan. 2007. “Centrifuge model tests on geotextile-reinforced slopes.” Geosynth. Int. 14(6): 365–379. https://doi.org/10.1680/gein.2007.14.6.365.
Wang, J., and J. Huang. 2021. “Full-scale field study of using geofoam to reduce earth pressures on buried concrete culverts.” Geotext. Geomembr. 49 (5): 1355–1367. https://doi.org/10.1016/j.geotexmem.2021.05.008.
Information & Authors
Information
Published In
Journal of Pipeline Systems Engineering and Practice
Volume 15 • Issue 1 • February 2024
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Jun 12, 2022
Accepted: Feb 16, 2023
Published online: Oct 11, 2023
Published in print: Feb 1, 2024
Discussion open until: Mar 11, 2024
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.