Failure Mechanism of Slopes Subjected to Embedded Strip Footing Loads under Seismic Conditions
Publication: International Journal of Geomechanics
Volume 23, Issue 9
Abstract
The stability of slopes subjected to vertical embedded strip footing loads under static and seismic conditions was investigated. The pseudostatic method was considered to represent an earthquake load. Two-dimensional lower-bound finite-element limit analysis (LB-FELA) and the strength reduction method (SRM) were employed to investigate the stability and failure mechanisms of the slopes subjected to the footing loads. It was found that the factor of safety (FOS) started to decrease rapidly after a certain load (defined as a threshold load). The critical location of the footing on the slope (where the FOS was at a minimum) was examined. In addition, a series of numerical analyses were carried out to check the effect of edge distance on slope stability. Changes in the FOS were evaluated for a particular footing edge distance for varying slope angles. The effects of variation in the shear strength parameters and the location of the water table on the slope stability under footing loads were also examined. It was found that the effect of loading intensity on the FOS was significant for gentle slopes, with this effect decreasing for steeper slopes. The influence of footing width on the FOS, for a given slope angle and loading intensity, was also insignificant. The footing near the slip surface at the top of the slope was the most critical location. The effect of the water table on the FOS diminished as the loading intensity on the footing increased. To demonstrate the practical application of this study, we also examined the slope failure that occurred during the 2011 Tohoku, Japan, earthquake.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Financial Assistance from the Ministry of Education (MoE), Govt. of India to the first author for this research work is gratefully acknowledged. The authors are thankful to Prof. Amir M. Kaynia, Norwegian University of Science and Technology (NTNU), Norway, for his critical review and suggestions to improve the quality of this manuscript.
References
Bhasin, R., and A. M. Kaynia. 2004. “Static and dynamic simulation of a 700-m high rock slope in western Norway.” Eng. Geol. 71: 213–226. https://doi.org/10.1016/S0013-7952(03)00135-2.
BIS (Bureau of Indian Standards). 1986. Code of practice for design and construction of foundations in soils: General requirements. IS 1904. New Delhi, India: BIS.
BIS (Bureau of Indian Standards). 2016. Indian standard criteria for earthquake resistant design of structures: General provisions and buildings. IS 1893 (Part 1). New Delhi, India: BIS.
Bishop, A. W. 1955. “The use of the slip circle in the stability analysis of slopes.” Géotechnique 5 (1): 7–17. https://doi.org/10.1680/geot.1955.5.1.7.
BSI (British Standards Institution). 2004. Design provisions for earthquake resistance of structures – Part 5: Foundations, retaining structures and geotechnical aspects. EN1998-5. London: BSI.
Bui, X.-N., M. A. Muazu, and H. Nguyen. 2020. “Optimizing Levenberg–Marquardt backpropagation technique in predicting factor of safety of slopes after two-dimensional OptumG2 analysis.” Eng. Comput. 36: 941–952. https://doi.org/10.1007/s00366-019-00741-0.
Chakraborty, D., and J. Kumar. 2015. “Seismic bearing capacity of shallow embedded foundations on a sloping ground surface.” Int. J. Geomech. 15 (1): 04014035. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000403.
Chen, J., J.-H. Yin, and C. F. Lee. 2003. “Upper bound limit analysis of slope stability using rigid finite elements and nonlinear programming.” Can. Geotech. J. 40 (4): 742–752. https://doi.org/10.1139/t03-032.
Chen, W. F., and X. L. Liu. 1990. Limit analysis in soil mechanics. Amsterdam, Netherlands: Elsevier. ISBN: 9780444598356.
Chen, Y., H. Lin, R. Cao, and C. Zhang. 2021. “Slope stability analysis considering different contributions of shear strength parameters.” Int. J. Geomech. 21 (3): 04020265. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001937.
Choudhury, D., and K. S. Subba Rao. 2006. “Seismic bearing capacity of shallow strip footings embedded in slope.” Int. J. Geomech. 6 (3): 176–184. https://doi.org/10.1061/(ASCE)1532-3641(2006)6:3(176).
Deng, D.-p., L.-h. Zhao, and L. Li. 2016. “Limit equilibrium stability analysis of slopes under external loads.” J. Cent. South Univ. 23 (9): 2382–2396. https://doi.org/10.1007/s11771-016-3297-4.
Donald, I. B., and Z. Chen. 1997. “Slope stability analysis by the upper bound approach: Fundamentals and methods.” Can. Geotech. J. 34 (6): 853–862. https://doi.org/10.1139/t97-061.
Duncan, J. M., S. G. Wright, and T. L. Brandon. 2014. Soil strength and slope stability. Hoboken, NJ: Wiley.
Griffiths, D. V., and P. A. Lane. 1999. “Slope stability analysis by finite elements.” Géotechnique 49 (3): 387–403. https://doi.org/10.1680/geot.1999.49.3.387.
Hansen, J. B. 1970. A revised and extended formula for bearing capacity. Bulletin No. 28. Copenhagen, Denmark: Danish Geotechnical Institute.
Hyodo, M., R. P. Orense, S. Nodaa, S. Furukawac, and T. Furuid. 2012. “Slope failures in residential land on valley fills in Yamamoto town.” Soils Found. 52 (5): 975–986. https://doi.org/10.1016/j.sandf.2012.11.015.
IBM Corp. 2020. IBM SPSS statistics for Windows, version 27.0. Armonk, NY: IBM Corp.
Janbu, N., L. Bjerrum, and B. Kjaernsli. 1956. Soil mechanics applied to some engineering problems. Publication 16. Oslo, Norway: Norwegian Geotechnical Institute.
Keskin, M. S., and M. Laman. 2013. “Model studies of bearing capacity of strip footing on sand slope.” KSCE J. Civ. Eng. 17 (4): 699–711. https://doi.org/10.1007/s12205-013-0406-x.
Krabbenhoft, K., and A. V. Lyamin. 2015. “Strength reduction finite-element limit analysis.” Géotechnique Lett. 5: 250–253. https://doi.org/10.1680/jgele.15.00110.
Krabbenhoft, K., A. V. Lyamin, M. Hjiaj, and S. W. Sloan. 2005. “A new discontinuous upper bound limit analysis formulation.” Int. J. Numer. Methods Eng. 63 (7): 1069–1088. https://doi.org/10.1002/nme.1314.
Krabbenhoft, K., A. V. Lyamin, and J. Krabbenhoft. 2016. “OptumG2: Theory manual.” Optum Computational Engineering. Accessed May 2019. https://optumce.com/wp-content/uploads/2016/05/Theory.pdf.
Kramer, S. L. 1996. Geotechnical earthquake engineering. Hoboken, NJ: Prentice-Hall.
Luo, W., J. Li, G. Tang, J. Chen, and C. Dai. 2021. “Upper-bound limit analysis for slope stability based on modified Mohr–Coulomb failure criterion with tensile cutoff.” Int. J. Geomech. 21 (10): 04021184. https://doi.org/10.1061/(ASCE)GM.1943-5622.0002154.
Lyamin, A. V., and S. W. Sloan. 2001. “Upper bound limit analysis using linear finite elements and non-linear programming.” Int. J. Numer. Anal. Methods Geomech. 26 (2): 181–216. https://doi.org/10.1002/nag.198.
Lyamin, A. V., and S. W. Sloan. 2002. “Lower bound limit analysis using non-linear programming.” Int. J. Numer. Methods Eng. 55 (5): 573–611. https://doi.org/10.1002/nme.511.
Mahajan, A. K., V. Gupta, and V. C. Thakur. 2012. “Macroseismic field observations of 18 September 2011 Sikkim earthquake.” Nat. Hazards 63: 589–603. https://doi.org/10.1007/s11069-012-0170-0.
Maheshwari, B. K., M. L. Sharma, Y. Singh, and A. Sinvhal. 2013. “Geotechnical aspects of Sikkim earthquake of September 18, 2011.” Indian Geotech. J. 43: 170–179. https://doi.org/10.1007/s40098-013-0039-5.
Michalowski, R. L. 1995. “Slope stability analysis: A kinematical approach.” Géotechnique 45 (2): 283–293. https://doi.org/10.1680/geot.1995.45.2.283.
Morgenstern, N. R., and V. E. Price. 1965. “The analysis of the stability of general slip surfaces.” Géotechnique 15 (1): 79–93. https://doi.org/10.1680/geot.1965.15.1.79.
NCHRP (National Cooperative Highway Research Program). 2008. Seismic analysis and design of retaining walls, buried structures, slopes, and embankments. Rep. No. 611. Washington, DC: NCHRP, Transportation Research Board.
Nguyen, P. P. T. 2008. “Study in place and in the laboratory of the behavior in small deformations of natural clay soils.” Ph.D. thesis, Geotechnics, National School of Bridges and Roads.
Noda, S., T. Uwabe, and T. Chiba. 1975. Relation between seismic coefficient and ground acceleration for gravity quay wall. Yokosuka, Japan: Report of the Port and Harbour Research Institute.
Paul, D. K., and S. Kumar. 1997. “Stability analysis of slope with building loads.” Soil Dyn. Earthquake Eng. 16 (6): 395–405. https://doi.org/10.1016/S0267-7261(97)00008-0.
Raj, D., Y. Singh, and A. M. Kaynia. 2018. “Behavior of slopes under multiple adjacent footings and buildings.” Int. J. Geomech. 18 (7): 04018062. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001142.
Sarma, S. K., and Y. C. Chen. 1996. “Bearing capacity of strip footing near sloping ground during earthquake.” In Proc., 11th World Conf., on Earthquake Engineering. Oxford, UK: Pergamon.
Sloan, S. W. 2013. “Geotechnical stability analysis.” Géotechnique 63 (7): 531–571. https://doi.org/10.1680/geot.12.RL.001.
Spencer, E. 1967. “A method of analysis of the stability of embankments assuming parallel inter-slice forces.” Géotechnique 17 (1): 11–26. https://doi.org/10.1680/geot.1967.17.1.11.
Tschuchnigg, F., H. F. Schweiger, S. W. Sloan, A. V. Lyamin, and I. Raissakis. 2015. “Comparison of finite-element limit analysis and strength reduction techniques.” Géotechnique 65 (4): 249–257. https://doi.org/10.1680/geot.14.P.022.
Vesic, A. S. 1973. “Analysis of ultimate loads of shallow foundations.” J. Soil Mech. Found. Div. 99 (1): 45–73. https://doi.org/10.1061/JSFEAQ.0001846.
Vesic, A. S. 1975. “Bearing capacity of shallow foundations.” In Foundation engineering handbook, 1st ed., edited by H. F. Winterkorn, and H. Y. Fang, 121–147. New York: Van Nostrand Reinhold.
Viratjandr, C., and R. L. Michalowski. 2006. “Limit analysis of submerged slopes subjected to water drawdown.” Can. Geotech. J. 43 (8): 802–814. https://doi.org/10.1139/t06-042.
Zheng, H., D. F. Liu, and C. G. Li. 2005. “Slope stability analysis based on elasto-plastic finite element method.” Int. J. Numer. Methods Eng. 64: 1871–1888. https://doi.org/10.1002/nme.1406.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 23 • Issue 9 • September 2023
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Jun 1, 2022
Accepted: Mar 22, 2023
Published online: Jun 23, 2023
Published in print: Sep 1, 2023
Discussion open until: Nov 23, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.