Breakage and Permeability Reduction of Tailings Sand under High-Pressure Oedometric Compression and Creep
Publication: Geo-Congress 2024
ABSTRACT
Tailings dams are constructed as a means of containing the byproducts of mining operations. They are often built using the coarser fraction of the tailings referred to as the tailings underflow or tailings sand. Due to the expected high overburden pressure, grain crushing may occur at the base of tall tailings dams. This may result in reduced hydraulic conductivity or drainage capability, thus undermining the long-term performance of the dam. To accurately evaluate the safety margin when designing tall tailings dams, it is important to understand the evolution of the hydromechanical behavior of the tailings sand. In this paper, laboratory-scale high-stress compression tests were conducted, and hydraulic conductivity measurements were taken using a specially designed oedometer cell. The experimental results were then analyzed using an enhanced continuum breakage mechanics model. The results indicate that an increase in stress from 5 to 40 MPa can result in an increase in fines content (mass percentage of particles smaller than 0.075 mm) from 11% to 17% and a corresponding decrease in hydraulic conductivity of up to one order of magnitude for the tested materials. We also report the preliminary results of a three-month creep test on tailings sand subjected to 3 MPa confining pressure to study the time effect associated with grain crushing.
Get full access to this article
View all available purchase options and get full access to this chapter.
REFERENCES
ASTM. ASTM D1140-17. (2017). D1140-17: Standard Test Methods for Determining the Amount of Material Finer than 75-μm (No. 200) Sieve in Soils by Washing. West Conshohocken, PA, American Standard of Testing Materials.
ASTM. ASTM D5856-15. (2015). D5856-15: Standard Test Method for Measurement of Hydraulic Conductivity of Porous Material Using a Rigid-Wall, Compaction-Mold Permeameter. West Conshohocken, PA, ASTM International.
Barrera, S., Valenzuela, L., and Campaña, J. (2011). Sand tailings dams: design, construction and operation. In Proceedings of Tailings and Mine Waste.), Vancouver, BC.
Bedin, J., Schnaid, F., Da Fonseca, A., and Costa Filho, L. D. M. (2012). Gold tailings liquefaction under critical state soil mechanics. Géotechnique 62(3):263–267.
Fourie, A., and Papageorgiou, G. (2001). Defining an appropriate steady state line for Merriespruit gold tailings. Canadian Geotechnical Journal 38(4):695–706.
Hendron, A., Jr. (1963). The behavior of sand in one-dimensional compression.
Mair, K., and Abe, S. (2008). 3D numerical simulations of fault gouge evolution during shear: Grain size reduction and strain localization. Earth and Planetary Science Letters 274(1-2):72–81.
Mcdowell, G. (2002). On the yielding and plastic compression of sand. Soils and foundations 42(1):139–145.
Mcdowell, G., Bolton, M., and Robertson, D. (1996). The fractal crushing of granular materials. Journal of the Mechanics and Physics of Solids 44(12):2079–2101.
Nakata, Y., Kato, Y., Hyodo, M., Hyde, A. F., and Murata, H. (2001). One-dimensional compression behaviour of uniformly graded sand related to single particle crushing strength. Soils and Foundations 41(2):39–51.
Obermeyer, J., and Alexieva, T. (2011). Design, construction and operation of a large centerline tailings storage facility with high rate of rise. In Tailings and Mine Waste.).
Pestana, J. M., and Whittle, A. (1995). Compression model for cohesionless soils. Géotechnique 45(4):611–632.
Riemer, M., Moriwaki, Y., and Obermeyer, J. (2008). Effect of high confining stresses on static and cyclic strengths of mine tailing materials. In Geotechnical earthquake engineering and soil dynamics IV.), pp. 1–10.
Singh, S., Zurakowski, Z., Dai, S., and Zhang, Y. (2021). Effect of grain crushing on hydraulic conductivity of tailings sand. Journal of Geotechnical and Geoenvironmental Engineering 147(12):04021143.
Tsoungui, O., Vallet, D., and Charmet, J.-C. (1999). Numerical model of crushing of grains inside two-dimensional granular materials. Powder Technology 105(1):190–198.
Valenzuela, L. (2018). Design, construction, operation and the effect of fines content and permeability on the seismic performance of tailings sand dams in Chile. Obras y Proyectos(19):6–22.
Zhang, Y., Buscarnera, G., and Einav, I. (2016). Grain size dependence of yielding in granular soils interpreted using fracture mechanics, breakage mechanics and Weibull statistics. Géotechnique 66(2):149–160.
Zhang, Y., Park, J., Gao, S., Sonta, A., Horin, B., and Buscarnera, G. (2017). Effect of grain crushing and grain size on the evolution of water retention curves. In PanAm Unsaturated Soils 2017.), pp. 268–278.
Information & Authors
Information
Published In
Geo-Congress 2024
Pages: 321 - 328
History
Published online: Feb 22, 2024
ASCE Technical Topics:
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.