Chapter
Mar 17, 2022

The Influence of Cyclic Loading Frequency on the Response of an Unsaturated Railway Formation Soil

Publication: Geo-Congress 2022

ABSTRACT

This paper presents the results of cyclic triaxial tests conducted on unsaturated soil samples recovered from the railway embankment of a South African coal line to investigate the influence of cyclic loading frequency on a formation layer material, in this case a clayey sand. The testing involved suction-monitored repeated loading tests accounting for the conditions likely to be encountered in practice under varying train speed. The results of single-stage loading tests with a frequency applied individually in a range of 0.5–4 Hz were compared to the results of multistage loading tests with a frequency increasing from 1 to 4 Hz. The results of the single-stage loading tests indicated that the accumulated axial strain increased with an increase in the cyclic frequency, implying that a higher train speed would result in a higher level of the permanent deformation. The staged increase in the frequency of the multistage loading tests showed that the permanent deformation mainly took place during the first packet of cyclic loads whereas the deformations measured during the following repeated loads were negligible. Suction reduction and an increase in degree of saturation during cyclic loading was dependent on the water-retention state of the sample. The results were then interpreted in terms of resilient modulus.

Get full access to this article

View all available purchase options and get full access to this chapter.

REFERENCES

Azizi, A., Kumar, A., Lingwanda, M., and Toll, D. G. (2020). “The influence of rates of drying and wetting on measurements of soil water retention curves” 4th European Conference on Unsaturated Soils, Lisbon, Portugal, E3S Web of Conferences 195, 03005.
Azizi, A., Kumar, A., and Toll, D. G. (2021). “Coupling cyclic and water retention response of a clayey sand subjected to traffic and environmental loading cycles” Géotechnique (Accepted).
Brown, S. F. (1996). “Soil mechanics in pavement engineering.” 36th Rankine Lecture of theBritish Geotechnical Society. Géotechnique., 46(3), 383–426.
Burrow, M. P. N., Bowness, D., and Ghataora, G. S. (2007). “A comparison of railway track foundation design methods.” Proc. I MechE. Part F: J. Rail Rapid Transp., 221(1), 1–12.
Blackmore, L., Clayton, C. R. I., Powrie, W., Priest, J. A., and Otter, L. (2019). Saturation and its effect on the resilient modulus of a pavement formation material. Géotechnique., 1–11.
Drumm, E. C., Poku, Y. B., and Peirce, T. J. (1990). “Estimation of subgrade resilient modulus from standard tests.” J. Geotech. Eng., 116(5), 774–789.
Grabe, P. J. (2002). Resilient and permanent deformation of railway foundations under principal stress rotation. PhD thesis, Dept. of Civil and Env. Engn, University of Southampton.
Kumar, A., Azizi, A., and Toll, D. G. (2021). “On the application of suction monitoring technique for cyclic triaxial testing for compacted soil.” Submitted to J. Geotech Geoenviron. Engn.
Liu, G., Toll, D. G., Kong, L., and Asquith, J. D. (2020). Matric suction and volume characteristics of compacted clay soil under drying and wetting cycles, Geo. Test. J., 43(2), 464–479.
Liu, J., and Xiao, J. (2010). “Experimental Study on the Stability of Railroad Silt Subgrade with Increasing Train Speed.” J. Geotech Geoenviron. Engn., 136(6), 833–841.
Li, D., and Selig, E. T. (1996). “Cumulative plastic deformation for fine-grained subgrade soils.” J. Geotech. Engng., 122(12), 1006–1013.
Sivakumar, V., Kodikara, J., O’Hagan, R., Hughes, D., Cairns, P., and McKinley, J. D. (2013). “Effects of confining pressure and water content on performance of unsaturated compacted clay under repeated loading.” Géotechnique., 63(8), 628–640.
Schulz-Poblete, M. V., Gräbe, P. J., and Jacobsz, S. W. (2019). “The influence of soil suctions on the deformation characteristics of railway formation materials.” Transport Geotech., 18, 111–123.
Toll, D. G., Lourenço, S. D. N., and Mendes, J. (2013). “Advances in Suction Measurements Using High Suction Tensiometers.” Engng. Geol., 165(24), 29–37.

Information & Authors

Information

Published In

Go to Geo-Congress 2022
Geo-Congress 2022
Pages: 274 - 283

History

Published online: Mar 17, 2022

Permissions

Request permissions for this article.

Authors

Affiliations

Ashutosh Kumar, Ph.D. [email protected]
1Assistant Professor, School of Engineering, IIT Mandi, Himachal Pradesh, India. Email: [email protected]
Arash Azizi, Ph.D. [email protected]
2Lecturer, School of Environment, Geography, and Geosciences, Univ. of Portsmouth, UK. Email: [email protected]
David Toll, Ph.D. [email protected]
3Professor, Dept. of Engineering, Durham Univ., Durham, UK. Email: [email protected]

Metrics & Citations

Metrics

Citations

Download citation

If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.

View Options

Get Access

Access content

Please select your options to get access

Log in/Register Log in via your institution (Shibboleth)
ASCE Members: Please log in to see member pricing

Purchase

Save for later Information on ASCE Library Cards
ASCE Library Cards let you download journal articles, proceedings papers, and available book chapters across the entire ASCE Library platform. ASCE Library Cards remain active for 24 months or until all downloads are used. Note: This content will be debited as one download at time of checkout.

Terms of Use: ASCE Library Cards are for individual, personal use only. Reselling, republishing, or forwarding the materials to libraries or reading rooms is prohibited.
ASCE Library Card (5 downloads)
$105.00
Add to cart
ASCE Library Card (20 downloads)
$280.00
Add to cart
Buy Single Paper
$35.00
Add to cart
Buy E-book
$110.00
Add to cart

Get Access

Access content

Please select your options to get access

Log in/Register Log in via your institution (Shibboleth)
ASCE Members: Please log in to see member pricing

Purchase

Save for later Information on ASCE Library Cards
ASCE Library Cards let you download journal articles, proceedings papers, and available book chapters across the entire ASCE Library platform. ASCE Library Cards remain active for 24 months or until all downloads are used. Note: This content will be debited as one download at time of checkout.

Terms of Use: ASCE Library Cards are for individual, personal use only. Reselling, republishing, or forwarding the materials to libraries or reading rooms is prohibited.
ASCE Library Card (5 downloads)
$105.00
Add to cart
ASCE Library Card (20 downloads)
$280.00
Add to cart
Buy Single Paper
$35.00
Add to cart
Buy E-book
$110.00
Add to cart

Media

Figures

Other

Tables

Share

Share

Copy the content Link

Share with email

Email a colleague

Share