Eighth International Conference on Case Histories in Geotechnical Engineering
Index Properties and Classification of Marginal Fills or Coarse-Fine Mixtures
Publication: Geo-Congress 2019: Engineering Geology, Site Characterization, and Geophysics (GSP 311)
ABSTRACT
The behavior of soil under loading is strongly influenced, and in some cases governed, by the relative percentage of coarse and fine particles. There are many intermediate graded soils whose response simply cannot be explained by “granular (non-cohesive)” versus “clayey (cohesive)” soil behavior. These soils have been commonly referred to as marginal fills. The limiting fines content when soil behavior changes from coarse-grained to fine-grained-dominated (i.e. fines fraction corresponding to a given behavioral threshold) is critical for developing a better understanding and more effective design decisions. Soil classification systems are beneficial in grouping soils into similar behavioral categories. Yet, there are limitations/drawbacks in currently utilized classification systems, when it comes to classification of marginal fills, since they fail to capture the dominant role of fines on the mechanical and hydraulic properties of soils. In this study, a total of ten sandy soil mixtures with 0%, 12%, 20%, 30%, and 40% fines, and plasticity indexes of 5% and 15% were prepared in the laboratory by mixing different proportions of coarse and fine sands, non-plastic silt, kaolin, and bentonite. All index properties including grain size distribution curves, Atterberg limits, maximum and minimum void ratios, maximum dry density, and optimum water content were determined. The mixtures were classified according to USCS, AASHTO, and revised soil classification system. Comparisons of different classification systems and their limitations were demonstrated for these marginal soils.
Get full access to this article
View all available purchase options and get full access to this chapter.
REFERENCES
AASHTO (American Association of State Highway and Transportation Officials). (2009). Standard Specifications for Highway Bridges, 17th ed. Washington, DC, USA.
Abdi, M.R., Sadrnejad, A., Arjomand, M.A. (2009). “Strength enhancement of clay by encapsulating geogrids in thin layers of sand.” Geotext. Geomembr. 27 (6), 447-455.
ASTM (American Society for Testing and Materials). D2487 Standard Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System)
Bayoglu, E. (1995). "Shear Strength and Compressibility Behavior of Sand-Clay Mixtures." M.S. Thesis, Middle East Technical University, Turkey.
Christopher, B.R., Zornberg, J.G., and Mitchell, J.K. (1998). “Design Guidance for Reinforced Soil Structures with Marginal Soil Backfills.” Proceedings of the Sixth International Conference on Geosynthetics, Atlanta, Georgia, March 1998, Vol. 2, pp. 797-804.
Christopher, B.R., Stuglis, R.S. (2005). “Low permeable backfill soils in geosyntheticreinforced soil wall: state of the practice in North America.” Proceedings ofNorth American Geosynthetics Conference (NAGS), Las Vegas, Nevada, USA, GRI-19, pp. 14-16.
Durukan, Z. and Tezcan, S. (1992). “Cost Analysis of Reinforced Soil Walls.” Geotextiles and Geomembranes, Vol. 11, No. 1, pp. 29-43.
FHWA (Federal Highway Administration). (2009). Mechanically Stabilized Earth Walls and Reinforced Soil Slopes. Design and Construction Guidelines, Publication No. FHWA-NHI-10-025, Washington DC.
Li, Y. (2016). Shear behavior of composite soils. CRC Press
NCHRP (National Cooperative Highway Research Program) Project No. 24-22. (2013). “Selecting Backfill Materials for MSE Retaining Walls.” Transportation Research Board, National Research Council, Washington, D.C.
NCMA (National Concrete Masonry Association). (2006). Design Manual for Segmental Retaining Walls, 3rd Edition.
O’Kelly, B.C. and Naughton, P.J. (2008). “On the interface shear resistance of a novel geogrid with in-plane drainage capacity.” Technical Note. In press, Geotextiles and Geomembranes.
Olmez, S. (2008). "Shear Strength Behavior of Sand-Clay Mixtures." M.S. Thesis, Middle East Technical University, Turkey.
Park, J., Santamarina, J.C. (2017). “Revised Soil Classification System for Coarse-Fine Mixtures.” Journal of Geotechnical and Geoenvironmental Engineering 143: 04017039. Available: http://dx.doi.org/10.1061/(asce)gt.1943-5606.0001705.
Raja, J., Fraser, I., Fowmes, G., (2012). “Designing with marginal Fills: Understanding and Practice.” lls. Presented at EuroGeo5: the 5th European Geosynthetics Congress, 16th-19th September 2012, Valencia, Spain.
Stark, T.D., H. Choi, and S. McCone. (2005). “Drained Shear Strength Parameters for Analysis of Landslides.” J. of Geotechnical and Geoenvironmental Engrg., ASCE, Vol. 131, No. 5, pp. 575-588.
Shipton, B., Coop, M.R. (2012). “On the compression behaviour of reconstituted soils.” Soils and Foundations, Vol. 52 (4), 668–681.
UNEP GEAS (United Nations Environment Program - Global Environmental Alert System (2014). “Sand, rarer than one thinks”, pp. 1-15.
Zornberg, J.G., and Mitchell, J.K. (1994). “Reinforced soil structures with poorly draining backfills.” Part I: Reinforcement interactions and functions. Geosynthetics International, Vol.1, No. 2, pp. 103-148
Zornberg, J.G. and Kang, Y. (2005). “Pullout of geosynthetic reinforcement with inplane drainage capability.” Proc. ASCE Geo-Frontiers, 24–26 January, Austin, Texas.
Information & Authors
Information
Published In
Geo-Congress 2019: Engineering Geology, Site Characterization, and Geophysics (GSP 311)
Pages: 91 - 99
Editors: Christopher L. Meehan, Ph.D., University of Delaware, Sanjeev Kumar, Ph.D., Southern Illinois University Carbondale, Miguel A. Pando, Ph.D., University of North Carolina Charlotte, and Joseph T. Coe, Ph.D., Temple University
ISBN (Online): 978-0-7844-8213-1
Copyright
© 2019 American Society of Civil Engineers.
History
Published online: Mar 21, 2019
Published in print: Mar 21, 2019
ASCE Technical Topics:
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.