Experimental Investigation of the Effects of Soil Properties on Levee Breach by Overtopping
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Hydraulic Engineering
Volume 141, Issue 4
Abstract
Levee failure due to overtopping during floods is a common phenomena. An experimental study was conducted in the hydraulics laboratory, University of South Carolina, to develop an understanding of the effects of soil properties on the breaching process of earthen levees. A total of eight experiments were conducted. A new methodology to measure the subaqueous breach evolution has been developed and validated. Measurements of breach width evolution and headcut migration are shown to be related to soil properties. Inclusion of noncohesive, silt size crushed silica in the levee material (45% by weight) significantly reduced the peak discharge and breach evolution time compared to a levee constructed with sand alone. Increase in kaolin clay in the levee material led to an increase in unconfined compressive strength which in turn increased resistance to levee failure. Nondimensional equations relating the breach width evolution and headcut migration to the soil properties have been developed by performing a multivariate analysis of the experimental data.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers thank the National Science Foundation for the financial support under Grant No. OISE 0730246. Any opinion, findings, and conclusions or recommendations expressed in this paper are those of the writers and do not reflect the views of the National Science Foundation.
References
AlQaser, G. (1991). “Progressive failure of an overtopped embankment.” Ph.D. thesis, Colorado State Univ., Fort Collins, CO.
Amos, C. L., et al. (2004). “The stability of tidal flats in Venice Lagoon–The results of in-situ measurements using two benthic, annular flumes.” J. Marine Syst., 51(1–4), 211–241.
ASCE Task Committee on Dam/Levee Breaching. (2011). “Earthen embankment breaching.” J. Hydraul. Eng., 1549–1564.
ASTM. (2007). “Standard test method for particle-size analysis of soils.” D422-63 (2007)e2, West Conshohocken, PA.
ASTM. (2010). “Standard test methods for laboratory determination of water (moisture) content of soil and rock by mass.” D2216-10, West Conshohocken, PA.
ASTM. (2012). “Standard test methods for laboratory compaction characteristics of soil using standard effort ( ()).” D698-e12, West Conshohocken, PA.
Chinnarasri, C., Tingsanchali, T., Weesakul, S., and Wongwises, S. (2003). “Flow patterns and damage of dike overtopping.” Int. J. Sediment Res., 18(4), 301–309.
Coleman, S., Andrews, D., and Webby, G. (2002). “Overtopping breaching of noncohesive homogeneous embankments.” J. Hydraul. Eng., 829–838.
Franca, M., and Almeida, A. (2002). “Experimental tests on rockfill dam breaching process.” Proc., Int. Symp. on Hydraulics and Hydrological Aspects of Reliability and Safety Assessment of Hydraulic Structures, IAHR, Madrid, Spain.
Froehlich, D. (2008). “Embankment dam breach parameters and their uncertainties.” J. Hydraul. Eng., 1708–1721.
Fujita, Y., and Tamamura, T. (1987). “Enlargement of breaches in flood levees on alluvial plains.” Nat. Disaster Sci., 9(1), 37–60.
Hahn, W., Hanson, G., and Cook, K. (2000). “Breach morphology observations of embankment overtopping tests.” Building Partnerships, ASCE, Reston, VA, 1–10.
Hanson, G. J., Cook, K. R., and Hunt, S. L. (2005). “Physical modeling of overtopping erosion and breach formation of cohesive embankments.” Trans. ASAE, 48(5), 1783–1794.
Hanson, G. J., and Hunt, S. L. (2007). “Lessons learned using laboratory JET method to measure soil erodibility of compacted soils.” Appl. Eng. Agric., 23(3), 305–312.
Hunt, S. L., Hanson, G. J., Cook, K. R., and Kadavy, K. C. (2005). “Breach widening observations from earthen embankment tests.” Trans. ASAE, 48(5), 587–595.
Jack, R. (1996). “The mechanics of embankment failure due to overtopping flow.” M.E. thesis, Univ. of Auckland, Auckland, New Zealand.
Mitchener, H., and Torfs, H. (1996). “Erosion of mud/sand mixtures.” Coastal Eng., 29(1–2), 1–25.
Morris, M., Hassan, M., Kortenhaus, A., and Visser, P. (2009). “Breaching process: A state of the art review.”, HR Wallingford, Oxfordshire, U.K.
Morris, M., Hassan, M., and Vaskinn, K. (2007). “Breach formation: Field test and laboratory experiments.” J. Hydraul. Res., 45, 9–17.
Mostafa, T. S., Imran, J., and Chaudhry, M. H. (2008). “Erosion resistance of cohesive soils.” J. Hydraul. Res., 46(6), 777–787.
Ockenden, M. C., and Delo, E. A. (1988). “Consolidation and erosion of estuarine mud and sand mixtures: An experimental study.”, Hydraulics Research Limited, Wallingford, U.K.
Orendorff, B. (2009). “An experimental study of embankment dam breaching.” M.Sc. thesis, Univ. of Ottawa, Ottawa.
Pickert, G., Weitbrecht, V., and Bieberstein, A. (2011). “Breaching of overtopped river embankments controlled by apparent cohesion.” J. Hydraul. Res., 49(2), 143–156.
Powledge, G., Ralston, D., Miller, P., Chen, Y., Clopper, P., and Temple, D. (1989). “Mechanics of overflow erosion on embankments. II: Hydraulic and design considerations.” J. Hydraul. Eng., 1056–1075.
Rozov, A. (2003). “Modeling of washout dams.” J. Hydraul. Res., 41(6), 565–577.
Schmocker, L. (2011). “Hydraulics of dike breaching.” Ph.D. thesis, Swiss Federal Institute of Technology, Zürich, Switzerland.
Schmocker, L., and Hager, W. H. (2009). “Dike breaching due to overtopping.” Proc., Int. Association for Hydro-Environment Engineering and Research (IAHR) Congress, Taylor and Francis, London, 3896–3903.
Schmocker, L., and Hager, W. H. (2012). “Plane dike-breach due to overtopping: Effects of sediment, dike height and discharge.” J. Hydraul. Res., 50(6), 576–586.
Singh, V. P. (1996). Dam breach modeling technology, 1st Ed., Kluwer, Alphen aan den Rijn, Netherlands.
Spinewine, B., Delobbe, A., Elslander, L., and Zech, Y. (2004). “Experimental investigation of the breach growth process in sand dikes.” Proc., Riverflow, M. Greco, A. Carravetta, and R. Della Morte, eds., Taylor and Francis, London.
Thorn, M. F. C., and Parsons, J. G. (1980). “Erosion of cohesive sediments in estuaries: An engineering guide.” Proc., Int. Symp. on Dredging Technology, BHRA Fluid Engineering, Cranfield, England, 349–358.
Walder, J., and O’Connor, J. (1997). “Methods for predicting peak discharge floods caused by failure of natural and constructed earth dams.” Water Resour. Res., 33(10), 2337–2348.
XLSTAT version 2012.1 [Computer software]. New York, Addinsoft.
Xu, Y., and Zhang, L. (2009). “Breaching parameters for earth and rockfill dams.” J. Geotech. Geoenviron. Eng., 1957–1970.
Zhang, J., Xuan, G., Wang, X., and Li, J. (2009). “Overtopping breaching of cohesive homogeneous earth dam with different cohesive strength.” Sci. China Series E Technol. Sci., 52(10), 3024–3029.
Zhu, Y. (2006). “Breach growth in clay-dikes.” Ph.D. thesis, Technical Univ. of Delft, Delft, Netherlands.
Zhu, Y., Visser, P., and Vrijling, J. (2006). “Laboratory observations of embankment breaching.” Proc., Int. Conf. on Hydroscience and Engineering, Michael Piasecki and College of Engineering, Drexel Univ., Philadelphia.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jul 5, 2013
Accepted: Oct 2, 2014
Published online: Nov 25, 2014
Published in print: Apr 1, 2015
Discussion open until: Apr 25, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.