Development of Dissipation Model of Excess Pore Pressure in Liquefied Sandy Ground
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 135, Issue 4
Abstract
Recently, several studies on the dissipation of excess pore pressure in liquefied sandy grounds have been reported on evaluation of postliquefaction behavior of structures. To further contribute to the understanding of this complicated dynamic phenomenon, centrifuge tests were performed in this research to analyze the liquefaction behavior of level saturated sandy grounds. The test results showed that the excess pore pressure in the liquefied sand was dissipated by the combined process of the solidification of the sand grains and the consolidation of the solidified layer. Based on the test results, a nonlinear model for the solidified layer thickness versus time, i.e., the solidification velocity, was developed. A new dissipation model was also developed by combining the nonlinear solidification model with Scott’s theory to improve the prediction for the time history of excess pore pressure. In addition, a method for evaluating the input parameters in the dissipation model was proposed by relating the parameters to the particle size and the relative density of soils. The proposed dissipation model properly estimated the dissipation of excess pore pressure with time observed in the centrifuge experiments.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was supported by research funds from Dong-A University.
References
Burmister, D. M. (1962). “Physical, stress-strain, and strength response of granular soils.” Proc., Symp. on Field Testing of Soils, STP 322, ASTM, 67–97.
Dewoolkar, M. M., Ko, H. Y., Stadler, A. T., and Astaneh, S. M. F. (1999). “A substitute pore fluid for seismic centrifuge modeling.” Geotech. Test. J., 22(3), 196–210.
Earth Technology Corporation (TETC). (1992). “VELACS laboratory testing program,” Soil Data Rep., Technical Rep.
Fiegel, G. L., and Kutter, B. L. (1994). “Liquefaction mechanism for layered soils.” J. Geotech. Engrg., 120(4), 737–755.
Florin, V. A., and Ivanov, P. L. (1961). “Liquefaction of saturated sandy soils.” Proc., 5th Int. Conf. on Soil Mechanics and Foundation Engineering, 107–111.
Gibson, A. D. (1997). “Physical scale modeling of geotechnical structures at one-g.” Ph.D. thesis, California Institute of Technology, Pasadena, Calif.
Gibson, R. E. (1958). “The progress of consolidation in a clay layer increasing in thickness with time.” Geotechnique, 18, 171–182.
Ha, I. S., Park, Y. H., and Kim, M. M. (2003). “Dissipation pattern of excess pore pressure after liquefaction in saturated sand deposits.” Transportation Research Record. 1821, Transportation Research Board, Washington, D.C., 59–67.
Kim, S. R., Hwang, J. I., Bao, Y., Ko, H. Y., and Kim, M. M. (2006). “Comparison of and centrifuge model tests for liquefied sands.” Proc. 6th Int. Conf. on Physical Modelling in Geotechnics, 18–22.
Kokusho, T. (1999). “Water film effect on lateral spreading of liquefied sand.” J. Geotech. Geoenviron. Eng., 125(10), 817–826.
Lambe, P. C. (1981). “Dynamic centrifuge modeling of a horizontal sand stratum.” Sc.D. thesis, Dept. of Civil Engineering, Massachusetts Institute of Technology, Cambridge, Mass.
NCHRP. (2002). “Comprehensive specification for the seismic design of bridges,” Rep. No. 472, National Academy Press, Washington. D.C.
Overseas Coastal Area Development Institute of Japan (OCDI). (2002). Technical standards and commentaries for port and harbour facilities in Japan, Y. Goda, T. Tabata, and S. Yamamoto, eds., Daikousha Printing Co., Japan.
Scott, R. F. (1986). “Solidification and consolidation of a liquefied sand column.” Soils Found., 26(4), 23–31.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Jun 14, 2007
Accepted: Jul 2, 2008
Published online: Apr 1, 2009
Published in print: Apr 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.