Evaluating Environmental Impact in Water Distribution System Design
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Infrastructure Systems
Volume 15, Issue 3
Abstract
An index-based method for the evaluation of the environmental impact of water distribution systems is introduced. The method is developed according to a set of methodological criteria to assess the environmental effect of water networks. A number of environmental measures are incorporated into the index-based method to account for nonrenewable resource consumption, greenhouse gas emissions, and emissions to air, land, and water. The index-based method can be included into a multiobjective optimization program to find design solutions that minimize cost and environmental impact. The index-based method was applied to the design of a water transmission system over a 20-year design horizon. Design alternatives were compared on the basis of the environmental impact index and cost. For the system analyzed, results indicated that of the hydraulically feasible alternatives, the five most environmentally acceptable alternatives were the five most cost-effective alternatives. Results also showed that the environmental impact index is mainly influenced by pumping energy and partially influenced by pipe diameter selection.
Get full access to this article
View all available purchase options and get full access to this article.
References
Boyd, D. R., and Genuis, S. J. (2008). “The environmental burden of disease in Canada: Respiratory disease, cardiovascular disease, cancer, and congenital affliction.” Environ. Res., 106, 240–249.
Buchberger, S. G., and Li, Z. (2007). “PRPsym: A modeling system for simulation of stochastic water demands.” Proc., World Environmental and Water Resources Congress 2007, ASCE, Reston, Va.
Carnegie Mellon University Green Design Institute (Carnegie). (2008). “Economic input-output life cycle assessment (EIO-LCA) model.” ⟨http://www.eiolca.net/⟩ (Jan. 30, 2008).
Dandy, G., Roberts, A., Hewitson, C., and Chrystie, P. (2006). “Sustainability objectives for the optimization of water distribution networks.” Proc., 8th Annual Water Distribution Systems Analysis Symp., IWA, London, 1–11.
Dennison, F. J., Azapagic, A., Clift, R., and Colbourne, J. S. (1999). “Life cycle assessment: Comparing strategic options for the mains infrastructure—Part I.” Water Sci. Technol., 39(10–11), 315–319.
Energy Information Administration (EIA). (2008a). “Annual energy outlook 2008 with projections to 2030.” Rep. No. DOE/EIA-0383, DOE, Washington, D.C.
Energy Information Administration (EIA). (2008b). “Electric power monthly June 2008.” Rep. No. DOE/EIA-0226, DOE, Washington, D.C.
Environmental Protection Authority (EPA) Victoria. (2005). “EPA ecological footprint calculators: Technical background paper.” Rep. Prepared for EPA Victoria, Publication 972, Victoria, Australia.
Esty, D. C., Levy, M., Srebotnjak, T., and de Sherbinin, A. (2005). 2005 environmental sustainability index: Benchmarking national environmental stewardship, Yale Center for Environmental Law and Policy, New Haven, Conn.
Filion, Y. R., MacLean, H. L., and Karney, B. W. (2004). “Life-cycle energy analysis of a water distribution system.” J. Infrastruct. Syst., 10(3), 120–130.
Ghimire, S. R., and Barkdoll, B. D. (2007). “Incorporating environmental impact decision making for municipal drinking water distribution systems through eco-efficiency analysis.” Proc., EWRI-2007, ASCE, Reston, Va., 1–10.
Hendrickson, C., Horvath, A., Joshi, S., and Lave, L. (1998). “Economic input-output models for environmental life-cycle assessment.” Environ. Sci. Technol., 32(4), 184A–191A.
Jeppsson, U., and Hellstrom, D. (2002). “Systems analysis for environmental assessment of urban water and wastewater systems.” Water Sci. Technol., 46(6–7), 121–129.
Loucks, D. P., and Gladwell, J. S., eds. (1999). “Measuring sustainability.” Sustainability criteria for water resource systems, Cambridge University Press, Cambridge, U.K., 32–41.
Lundie, S., Peters, G. M., and Beavis, P. C. (2004). “Life cycle assessment for sustainable metropolitan water systems planning.” Environ. Sci. Technol., 38, 3465–3473.
Lundie, S., Peters, G. M., and Beavis, P. C. (2005). “Quantitative systems analysis as a strategic planning approach for metropolitan water service providers.” Water Sci. Technol., 52(9), 11–20.
Mall, A., Buccino, S., and Nichols, J. (2007). “Drilling down: Protecting western communities from the health and environmental effects of oil and gas production.” Rep. Prepared for Natural Resources Defense Council and Rocky Mountain Clean Air Action Group, Natural Resources Defense Council, New York.
Monfreda, C., Wackernagel, M., and Deumling, D. (2004). “Establishing national natural capital accounts based on detailed Ecological Footprint and biological capacity assessments.” Land Use Policy, 21, 231–246.
Rossman, L. A. (2000). EPANET 2: User’s manual, National Risk Management Research Laboratory, Cincinnati.
Saling, P., et al. (2002). “Eco-efficiency analysis by BASF: The method.” Int. J. Life Cycle Assess., 7(4), 203–218.
Stokes, J., and Horvath, A. (2006). “Life cycle energy assessment of alternative water supply systems.” Int. J. Life Cycle Assess., 11(5), 335–343.
United Nation Environment Programme (UNEP). (1996). Life cycle assessment: What it is and how to do it, UNEP, Paris.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Apr 21, 2008
Accepted: Jan 11, 2009
Published online: Aug 14, 2009
Published in print: Sep 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.