Condition Prediction of Deteriorating Concrete Bridges Using Bayesian Updating
This article has a reply.
VIEW THE REPLYPublication: Journal of Structural Engineering
Volume 125, Issue 10
Abstract
It is well known that the U.S. infrastructure is in need of extensive repair. To ensure that the scarce resources available for maintaining the U.S. bridge inventory are spent in an optimal manner, bridge management programs have been mandated by the Federal Highway Administration. However, these programs are mainly based on data from subjective condition assessments and do not use time-variant bridge reliability for decision making. Many nondestructive test methods exist for the detailed inspection of bridges. Predictions based solely on inspection data may be questionable, particularly if limitations and errors in the measurement methods that are used are not considered. Through the application of Bayesian techniques, information from both inspection data and engineering judgment can be combined and used in a rational manner to better predict future bridge conditions. In this study, the influence of inspection updating on time-variant bridge reliability is illustrated for an existing reinforced concrete bridge. Inspection results are combined with prior information in a Bayesian light. The approach is illustrated for a reinforced concrete bridge located near Pueblo, Colo. For this bridge the effects of corrosion initiation time and rate on time-variant strength are illustrated using simulation. Inspection results are combined with prior information using Bayesian updating. Time-variant bridge reliability computations are performed using a combined technique of adaptive importance sampling and numerical integration. The approach presented allows accounting for inspection results in the quantitative assessment of condition of bridges and shows how to incorporate quantitative information into bridge system and component condition prediction.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Aktan, A. E., et al. (1996). “Condition assessment for bridge management.”J. Infrastruct. Sys., ASCE, 2(3), 108–117.
2.
Babaei, K. (1986). “Evaluation of half-cell corrosion detection test for concrete bridge decks.” Rep. WA-RD-95.1, Washington State Department of Transportation, Washington.
3.
Berman, H. A. (1972). “Determination of chloride in hardened portland cement paste, mortar, and concrete.” J. Mat., 7(3), 330–335.
4.
Chang, S. E., and Shinozuka, M. (1996). “Life-cycle cost analysis with natural hazard risk.”J. Infrastruct. Sys., ASCE, 2(3), 118–126.
5.
Chase, S. B., and Washer, G. (1997). “Nondestructive evaluation for bridge management in the next century.” Public Roads, July/August, 16–25.
6.
Clear, K. C. (1992). “Measuring rate of corrosion of steel in field concrete structures.” Transp. Res. Rec. 1211, Transportation Research Board, National Research Council, Washington, D.C., 28–37.
7.
Engelund, S., and Sørensen, J. D. (1998). “A probabilistic model for chloride-ingress and initiation of corrosion in reinforced concrete structures.” Struct. Safety, Amsterdam, 20(1), 69–89.
8.
Enright, M. P. ( 1998). “Time-variant reliability of reinforced concrete bridges under environmental attack,” PhD thesis, Dept. of Civ., Envir., and Arch. Engr., University of Colorado, Boulder, Colo.
9.
Enright, M. P., and Frangopol, D. M. (1998a). “Probabilistic analysis of resistance degradation of reinforced concrete bridge beams under corrosion.” Engrg. Struct., 20(11), 960–971.
10.
Enright, M. P., and Frangopol, D. M. (1998b). “Service-life prediction of deteriorating concrete bridges.”J. Struct. Engrg., ASCE, 124(3), 309–317.
11.
Enright, M. P., and Frangopol, D. M. (1999). “Reliability-based condition assessment of deteriorating concrete bridges considering load redistribution.” Struct. Safety, Amsterdam, 21(2), 159–195.
12.
Frangopol, D. M., and Hearn, G., eds. (1996). Structural reliability in bridge engineering. McGraw-Hill, New York.
13.
Funahashi, M. (1990). “Predicting corrosion-free service life of a concrete structure in a chloride environment.” ACI Mat. J., 87(6), 581–587.
14.
Geyskens, P., Der Kiureghian, A., and Monteiro, P. (1998). “Bayesian prediction of elastic modulus of concrete.”J. Struct. Engrg., ASCE, 124(1), 89–95.
15.
Kay, T. (1992). Assessment & renovation of concrete structures. Wiley, New York.
16.
Lipkus, S. E. ( 1994). “BRIDGIT bridge management system software.” Characteristics of bridge management systems, Transp. Res. Circular, No. 423, National Academy Press, Washington, D.C., 43–54.
17.
LRFD bridge design specifications. (1994). 1st Ed., American Association of State Highway and Transportation Officials, Washington, D.C.
18.
MacGregor, J. G., Mirza, S. A., and Ellingwood, B. (1983). “Statistical analysis of resistance of reinforced and prestressed concrete members.” J. Am. Concrete Inst., 80(3), 167–176.
19.
Marshall, S. J. ( 1996). “Evaluation of instrument-based, non-destructive inspection methods for bridges,” MS thesis, Dept. of Civ., Envir., and Arch. Engr., University of Colorado, Boulder, Colo.
20.
Martz, H. F., and Waller, R. A. (1982). Bayesian reliability analysis. Wiley, New York.
21.
Melchers, R. E. (1987). Structural reliability: Analysis and prediction. Ellis Horwood, Chichester, England.
22.
Mori, Y., and Ellingwood, B. ( 1993). “Methodology for reliability-based condition assessment: Application to concrete structures in nuclear plants.” NUREG/CR-6052, U.S. Nuclear Regulatory Commission, Washington, D.C.
23.
Mori, Y., and Ellingwood, B. (1994). “Maintaining reliability of concrete structures. I: Role of inspection/repair.”J. Struct. Engrg., ASCE, 120(3), 824–845.
24.
Normand, S.-L., and Tritchler, D. (1992). “Parameter updating in a Bayes network.” J. Am. Statistical Assn., 87(420), 1109–1115.
25.
Novokshchenov, V. ( 1989). “Salt penetration and corrosion in prestressed concrete members.” Federal Highway Administration, McLean, Va.
26.
Nowak, A. S. (1993). “Calibration of LRFD bridge design code.” Final Rep. NCHRP 12-33, Dept. of Civ. and Envir. Engrg., University of Michigan, Ann Arbor, Mich.
27.
Nowak, A. S., Yamani, A. S., and Tabsh, S. W. (1994). “Probabilistic models for resistance of concrete bridge girders.” ACI Struct. J., 91(3), 269–276.
28.
SAP users manual. (1989). Computers and Structures, Inc., Berkeley, Calif.
29.
Sørensen, J. D. ( 1993). “Reliability-based inspection planning for structural systems.” Reliability and optimization of structural systems, V, P. Thoft-Christensen and H. Ishikawa, eds., Elsevier Science, Amsterdam, 31–46.
30.
Stewart, M. G., and Rosowsky, D. V. (1998a). “Time-dependent reliability of deteriorating reinforced concrete bridge decks.” Struct. Safety, 20(1), 91–109.
31.
Stewart, M. G., and Rosowsky, D. V. (1998b). “Structural safety and serviceability of concrete bridges subject to corrosion.”J. Infrastruct. Sys., ASCE, 4(4), 146–155.
32.
Thoft-Christensen, P., Jensen, F. M., Middleton, C. R., and Blackmore, A. ( 1997). “Assessment of the reliability of concrete slab bridges.” Reliability and optimization of structural systems, D. M. Frangopol, R. B. Corotis, and R. Rackwitz, eds., Pergamon, Tarrytown, New York, 321–328.
33.
Thompson, P. D. ( 1994). “Pontis.” Characteristics of bridge management systems, Transp. Res. Circular No. 423, National Academy Press, Washington, D.C., 35–42.
34.
Van Daveer, J. R. (1975). “Techniques for evaluating reinforced concrete bridge decks.” ACI J., December, 697–704.
35.
Whiting, D. A., Stejskal, B. G., and Nagi, M. A. ( 1993). “Condition of prestressed concrete bridge components: Technology review and field surveys.” FHWA-RD-93-037, Federal Highway Administration, Washington, D.C.
36.
Zheng, R., and Ellingwood, B. R. (1998). “Role of nondestructive evaluation in time-dependent reliability analysis.” Struct. Safety, 20(4), 325–339.
Information & Authors
Information
Published In
Journal of Structural Engineering
Volume 125 • Issue 10 • October 1999
Pages: 1118 - 1125
History
Received: Dec 8, 1998
Published online: Oct 1, 1999
Published in print: Oct 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.