Predicted and Observed Cyclic Performance of Piles in Calcareous Sand
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical Engineering
Volume 121, Issue 1
Abstract
The performance of small-scale model piles jacked into calcareous sand and tested under cyclic axial loadings is presented in this paper. The calcareous sand beds used for the tests have been prepared from reconstituted soil that has been consolidated under different overburden pressures using a test vessel of special design. The study is focused on the accumulation of permanent displacement of the piles under both uniform and nonuniform amplitude cyclic loadings. A numerical analysis is employed to predict the cyclic behavior of the model piles, using input parameters derived from the experimental results. Comparisons between the measured and predicted results show reasonable agreement.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Al-Douri, R. H. (1992). “Behaviour of jacked single piles and pile groups in calcareous sediments,” PhD thesis, University of Sydney, Australia.
2.
Al-Douri, R. H., and Poulos, H. G.(1992). “Static and cyclic constant normal stress tests on calcareous sands.”Geotech. Testing J., 15(2), 138–158.
3.
Allman, M. A. (1988). “The behaviour of piles in cemented calcareous soils,” PhD thesis, University of Sydney, Australia.
4.
Andersen, K. H., Hansteen, O. E., Hoeg, K., and Prevost, J. H. (1978). “Soil deformation due to cyclic loads on offshore structures.”Numerical methods in offshore engineering, Zienkiewicz, Lewis, and Stagg, eds., John Wiley, New York, N.Y., 413–452.
5.
Angemeer, J., Carlson, E., and Klick, J. H. (1973). “Techniques and results of offshore pile load testing in calcareous soils.”Proc., 5th Annu. Offshore Technol. Conf., Offshore Technology Conference, Houston, Tex., 677–692.
6.
Datta, M. Rao, and G. V., and Gulhati(1980). “The nature and engineering behaviour of carbonate soils at Bombay High.”Indian Marine Geotechnol., India, 4(4), 307–341.
7.
Diyaljee, U. A., and Raymond, G. P.(1982). “Repetitive load deformation of cohesionless soil.”J. Geotech. Engrg. Div., ASCE, 108(10), 1215–1229.
8.
Dutt, R. N.(1990). “Discussion of `Classification of marine sediments' by I. Noorany.”J. Geotech. Engrg. Div., ASCE, 116(8), 1288.
9.
Kaggwa, W. S., and Poulos, H. G. (1990). “Comparison of the behaviour of dense carbonate sediments and silica in cyclic triaxial tests.”Res. Rep. No. R611, University of Sydney, Australia.
10.
Khorshid, M. S. (1990). “Development of geotechnical experience on the North-West Shelf.”Australian Geomech., Australia, No. 19, 11–21.
11.
Lee, C. Y. (1988). “The behaviour of grouted piles in offshore foundation,” PhD thesis, University of Sydney, Australia.
12.
Lee, C. Y., and Poulos, H. G. (1992). “Static and cyclic load tests on model grouted piles in marine calcareous sediments.”Geotech. Engrg, Vol. 23, 5–27.
13.
Matlock, H., and Foo, S. C. (1980). “Axial analysis of piles using a hysteretic and degrading soil model.”Proc., Conf. Num. Methods in Offshore Piling, Instn. Civ. Engrs., London, England, 127–133.
14.
Poulos, H. G. (1988a). “The mechanics of calcareous sediments.”Australian Geomech., Australia, 8–41.
15.
Poulos, H. G.(1988b). “Cyclic stability diagram for axially loaded piles.”J. Geotech. Engrg., ASCE, 114(8), 877–895.
16.
Poulos, H. G. (1989). “Program SCARP—static and cyclic axial response of piles.”Rep., Centre for Geotechnical Research, University of Sydney, Australia.
17.
Poulos, H. G., and Al-Douri, R. H. (1992). “Influence of soil density on pile skin friction in calcareous sediments.”Proc., 6th ANZ Conf. on Geomech., Christchurch, New Zealand, 375–380.
18.
Poulos, H. G., and Davis, E. H. (1980). Pile foundations analysis and design . John Wiley and Sons, New York, N.Y.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Jan 1, 1995
Published in print: Jan 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.