Optical Measurements of Tsunami Inundation and Debris Movement in a Large-Scale Wave Basin
Publication: Journal of Waterway, Port, Coastal, and Ocean Engineering
Volume 141, Issue 1
Abstract
This paper presents optical measurements of debris movement and tsunami inundation over an unobstructed beach in a laboratory wave basin. The debris consisted of rectangular boxes and was placed unconstrained on a flat section raised above the basin floor with no still water on the raised section. Debris movement was measured using two overhead video cameras and a novel object-tracking algorithm. Two standard optical techniques, wave edge detection and particle image velocimetry, were used to compare optical and in situ measurements of fluid velocity. The debris motion (position, velocity) in the onshore direction was found to be repeatable, but the offshore motion varied between trials because of the irregular nature of the flow field during the return. For debris in free translation, as the number of debris specimens increased, the peak average velocity decreased and the onset of the peak was delayed in the onshore direction. In the offshore direction, the velocity was lower by a factor 4–6 and was independent of the quantity of debris. The decrease in the peak onshore velocity with increasing amount of debris was observed for debris that undergoes an initial rotation. The peak onshore velocity was nearly independent of whether the initial motion was purely translational or a combination of rotation and translation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Support for this research by Oregon Sea Grant and the National Science Foundation under No. CMMI-0830378 is gratefully acknowledged. The Tsunami Facility is supported by the Network for Earthquake Engineering Simulation (NEES) Program of the National Science Foundation under award No. CMMI-0402490. The authors gratefully acknowledge the work of the staff of the O. H. Hinsdale Wave Research Laboratory and several other undergraduate student workers (Kyle Mayfield, Jose Lozano, and Brittany Snyder) in conducting the physical model experiments. The authors thank the two anonymous reviewers for their comments to improve the manuscript.
References
Arikawa, T., Ohtsubo, D., Nakano, F., Shimosako, K., and Ishikawa, N. (2009). “Large model tests of drifting container impact force due to surge front tsunami.” Proc., Conf. on Coastal Engineering, Japan Society of Civil Engineers, Tokyo (in Japanese).
Arikawa, T., and Yashizaki, M. (2009). “Large scale tests on concrete wall destruction by tsunami with driftwood.” Proc., Conf. on Coastal Engineering, Japan Society of Civil Engineers, Tokyo (in Japanese).
Baldock, T. E., Cox, D., Maddux, T., Killian, J., and Fayler, L. (2009). “Kinematics of breaking tsunami wavefronts: A data set from large scale laboratory experiments.” Coastal Eng., 56(5–6), 506–516.
Cox, D., Tomita, T., Lynett, P., and Holman, R. A. (2008). “Tsunami inundation with macro-roughness in the constructed environment.” Proc., 31st Int. Conf. on Coastal Engineering, ASCE, Reston, VA, 1421–1432.
Foytong, P., Ruangrassamee, A., Shoji, G., Hiraki, Y., and Ezura, Y. (2013). “Analysis of tsunami flow velocities during the March 2011 Tohoku, Japan Tsunami.” Earthquake Spectra, 29(S1), S161–S181.
Fritz, H. M., et al. (2012). “The 2011 Japan tsunami current velocity measurements from survivor videos at Kesennuma Bay using LiDAR.” Geophys. Res. Lett., 39(7), L00G23.
Goring, D. G. (1978). “Tsunamis—The propagation of long waves onto a shelf.” Rep. No. Kh-R-38, W. M. Keck Laboratory of Hydraulics and Water Resources, California Institute of Technology, Pasadena, CA.
Gorst, N. J. S., Williamson, S. J., Pallett, P. F., and Clark, L. A. (2003). “Friction in temporary works.” Research Rep. 071, Univ. of Birmingham, Birmingham, U.K.
Hayashi, S., and Koshimura, S. (2013). “The 2011 Tohoku Tsunami flow velocity estimation by the aerial video analysis and numerical modeling.” J. Disaster Res., 8(4), 561–572.
Holman, R. A., and Stanley, J. (2007). “The history and technical capabilities of Argus.” Coastal Eng., 54(6–7), 477–491.
MATLAB R2011b [Computer software]. Natick, MA, MathWorks.
Matsutomi, H. (2009). “Method for estimating collision force of driftwood accompanying tsunami inundation flow.” J. Disaster Res., 4(6), 435–440.
Mori, N., Takahashi, T., Yasuda, T., and Yanagisawa, H. (2011). “Survey of 2011 Tohoku earthquake tsunami inundation and run-up.” Geophys. Res. Lett., 38(7), L00G14.
Naito, C., Cercone, C., Riggs, H. R., and Cox, D. (2014). “Procedure for site assessment of the potential for tsunami debris impact.” J. Waterway, Port, Coastal, Ocean Eng., 223–232.
Naito, C., Cox, D., Yu, Q.-S., and Brooker, H. (2013). “Fuel storage container performance during the 2011 Tohoku, Japan, tsunami.” J. Perform. Constr. Facil., 373–380.
Okal, E. A., et al. (2010). “Field survey of the Samoa tsunami of 29 September 2009.” Seismol. Res. Lett., 81(4), 577–591.
Oshnack, M. B., Aguiniga, F., Cox, D., Gupta, R., and van de Lindt, J. (2009). “Effectiveness of small onshore seawalls in reducing forces induced by tsunami bore: Large scale experimental study.” J. Disaster Res., 4(6), 382–390.
Park, H., Cox, D. T., Lynett, P. J., Wiebe, D. M., and Shin, S. (2013). “Tsunami inundation modeling in constructed environments: A physical and numerical comparison of free-surface elevation, velocity, and momentum flux.” Coastal Eng., 79(Sep), 9–21.
Park, S., van de Lindt, J. W., Cox, D., Gupta, R., and Aguiniga, F. (2012). “Successive earthquake-tsunami analysis to develop collapse fragilities.” J. Earthquake Eng., 16(6), 851–863.
Reuben, M., Holman, R., Cox, D., Shin, S., Killian, J., and Stanley, J. (2011). “Optical measurements of tsunami inundation through an urban waterfront modeled in a large-scale laboratory basin.” Coastal Eng., 58(3), 229–238.
Ruangrassamee, A., Yanagisawa, H., Foytong, P., Lukkunaprasit, P., Koshimura, S., and Imamura, F. (2006). “Investigation of tsunami-induced damage and fragility of buildings in Thailand after the December 2004 Indian Ocean tsunami.” Earthquake Spectra, 22(S3), S377–S401.
Saatcioglu, M., Ghobarah, A., and Nistor, I. (2006). “Performance of structures in Thailand during the December 2004 Great Sumatra earthquake and Indian Ocean tsunami.” Earthquake Spectra, 22(S3), S355–S375.
Takahashi, S., et al. (2010). “Joint survey for 2010 Chilean earthquake and tsunami disaster in ports and coasts.” PARI Technical Note 1224, Port and Airport Research Institute, Kuriyama, Japan.
Thomas, S., and Cox, D. (2012). “Influence of finite-length seawalls for tsunami loading on coastal structures.” J. Waterway, Port, Coastal, Ocean Eng., 203–214.
USGS Tsunami Pilot Study Working Group. (2006). “Seaside, Oregon tsunami pilot study—Modernization of FEMA flood hazard maps.” Open-File Rep. 2006-1234, U.S. Dept. of the Interior, USGS, Washington, DC.
Yeom, G., Nakamura, T., and Mizutani, N. (2009). “Collision analysis of container drifted by run-up tsunami using drift collision model.” J. Disaster Res., 4(6), 441–449.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Oct 28, 2013
Accepted: Apr 8, 2014
Published online: May 29, 2014
Published in print: Jan 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.