Effect of Vertical and Horizontal Web Reinforcement on the Strength and Deformation of Concrete Deep Beams Reinforced with GFRP Bars
Publication: Journal of Structural Engineering
Volume 143, Issue 8
Abstract
Ten full-scale concrete deep beams reinforced with glass fiber-reinforced polymer (GFRP) with a cross section of were tested to failure under two-point loading. The test variables were the configuration of web reinforcement (horizontal and/or vertical) and shear span-to-depth ratio (, 1.13, and 0.83). All specimens exhibited sufficient deformation required to develop arch action, which was confirmed by crack propagation and an almost linear strain profile in the main longitudinal reinforcement, in addition to the typical failure mode of crushing in the concrete diagonal strut. The results show that the vertical web reinforcement had no clear impact on ultimate capacity, while the configuration with horizontal-only web reinforcement unexpectedly resulted in a lower ultimate capacity compared to the specimens without web reinforcement. The web reinforcement’s main contribution was significant crack-width control.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to express their special thanks and gratitude to the Natural Science and Engineering Research Council of Canada (NSERC), the Canada Research Chair in Advanced FRP Composite Materials for Civil Structures, the NSERC Research Chair in FRP Reinforcement for Concrete Infrastructure, the Fonds de la recherche du Québec en nature et technologies (FRQ-NT), the Canadian Foundation for Innovation (CFI), and the technical staff of the structural lab in the Department of Civil Engineering at the University of Sherbrooke.
References
AASHTO. (2007). “AASHTO LRFD bridge design specifications.” Washington, DC.
ACI (American Concrete Institute). (2004). “Guide test methods for fiber-reinforced polymers (FRPs) for reinforcing or strengthening concrete structures.” ACI 440.3R-04, Farmington Hills, MI.
ACI (American Concrete Institute). (2007). “Report on fiber-reinforced polymer (FRP) reinforcement concrete structures.” ACI 440R-07, Farmington Hills, MI.
ACI (American Concrete Institute). (2014). “Building code requirements for structural concrete and commentary.” ACI 318-11, Farmington Hills, MI.
ACI (American Concrete Institute). (2015). “Guide for the design and construction of structural concrete reinforced with fiber-reinforced polymer (FRP) bars.” ACI 440.1R-15, Farmington Hills, MI.
Andermatt, M. F., and Lubell, A. S. (2013a). “Behavior of concrete deep beams reinforced with internal fiber-reinforced polymer—Experimental study.” ACI Struct. J., 110(4), 585–594.
Andermatt, M. F., and Lubell, A. S. (2013b). “Strength modeling of concrete deep beams reinforced with internal fiber-reinforced polymer.” ACI Struct. J., 110(4), 595–605.
Bakis, C. E., et al. (2002). “Fiber-reinforced polymer composites for construction—State-of-the-art review.” J. Compos. Constr., 73–87.
Birrcher, D. B., Tuchscherer, R. G., Huizinga, M., and Bayrak, O. (2013). “Minimum web reinforcement in deep beams.” ACI Struct. J., 110(2), 297–306.
Brown, M. D., and Bayrak, O. (2007). “Investigation of deep beams with various load configurations.” ACI Struct. J., 104(5), 611–620.
Collins, M. P., Bentz, E. C., and Sherwood, E. G. (2008). “Where is shear reinforcement required? Review of research results and design procedures.” ACI Struct. J., 105(5), 590–600.
CSA (Canadian Standards Association). (2012). “Design and construction of building components with fiber-reinforced polymers.” CSA S806, Mississauga, ON, Canada.
CSA (Canadian Standards Association). (2014a). “Canadian highway bridge design code.” CSA S6-14, Mississauga, ON, Canada.
CSA (Canadian Standards Association). (2014b). “Design of concrete structures.” CSA A23.3, Mississauga, ON, Canada.
El-Salakawy, E., Benmokrane, B., El-Ragaby, A., and Nadeau, D. (2005). “Field investigation on the first bridge deck slab reinforced with glass FRP bars constructed in Canada.” J. Compos. Constr., 470–479.
Farghaly, A. S., and Benmokrane, B. (2013). “Shear behavior of FRP-reinforced concrete deep beams without web reinforcement.” J. Compos. Constr., .
fib (Fédération Internationale du Béton). (2007). “FRP reinforcement in RC structures.”, Lausanne, Switzerland.
JSCE (Japan Society of Civil Engineers). (1997). “Recommendation for design and construction of concrete structures using continuous fiber reinforcing materials.” Concrete engineering series 23, A. Machida, ed., Research Committee on Continuous Fiber Reinforcing Materials, JSCE, Tokyo.
Kassem, C., Farghaly, A. S., and Benmokrane, B. (2011). “Evaluation of flexural behavior and serviceability performance of concrete beams reinforced with FRP bars.” J. Compos. Constr., 682–695.
MacGregor, J. G. (1997). Reinforced concrete: Mechanics and design, 3rd Ed., Prentice Hall, Upper Saddle River, NJ.
Mau, S. T., and Hsu, T. T. C. (1989). “Formula for the shear strength of deep beams.” ACI Struct. J., 86(5), 516–523.
Mihaylov, B. I., Bentz, E. C., and Collins, M. P. (2010). “Behavior of large deep beams subjected to monotonic and reversed cyclic shear.” ACI Struct. J., 107(6), 726–734.
Mihaylov, B. I., Bentz, E. C., and Collins, M. P. (2013). “Tow-parameter kinematic theory for shear behavior of deep beams.” ACI Struct. J., 110(3), 447–456.
Mohamed, N., Farghaly, A. S., Benmokrane, B., and Neale, K. W. (2014). “Experimental investigation of concrete shear walls reinforced with glass fiber-reinforced bars under lateral cyclic loading.” J. Compos. Constr., A4014001.1-11.
Pultrall, Inc. (2012). “Data sheet—V-ROD GFRP rebars.” Thetford Mines, QC.
Quintero-Febres, C. G., Parra-Montesinos, G., and Wight, J. K. (2006). “Strength of struts in deep concrete members designed using strut-and-tie method.” ACI Struct. J., 103(4), 577–586.
Razaqpur, A. G., Isgor, B. O., Greenaway, S., and Selley, A. (2004). “Concrete contribution to the shear resistance of fiber reinforced polymer reinforced concrete members.” J. Compos. Constr., 452–460.
Smith, K. N., and Vantsiotis, A. S. (1982). “Shear strength of deep beams.” ACI Struct. J., 79(3), 201–213.
Tan, K. H., Kong, F. K., Teng, S., and Weng, L. W. (1997). “Effect of web reinforcement on high-strength concrete deep beams.” ACI Struct. J., 94(5), 572–582.
Tan, K. H., and Lu, H. Y. (1999). “Shear behavior of large reinforced concrete deep beams and code comparison.” ACI Struct. J., 96(5), 836–845.
Tobbi, H., Farghaly, A. S., and Benmokrane, B. (2012). “Concrete columns reinforced longitudinally and transversally with glass fiber-reinforced polymer bars.” ACI Struct. J., 109(4), 551–558.
Tuchscherer, R., Birrcher, D., Huizinga, M., and Bayrak, O. (2011). “Distribution of stirrups across web of deep beams.” ACI Struct. J., 108(1), 108–115.
Tuscherer, R. G., Birrcher, D. B., Williams, C. S., Deschenes, D. J., and Bayrak, O. (2014). “Evaluation of existing strut-and-tie methods and recommended improvements.” ACI Struct. J., 111(6), 1451–1460.
Vecchio, F. J., and Collins, M. P. (1986). “Modified compression field theory for reinforced concrete elements subjected to shear.” ACI Struct. J., 83(2), 219–231.
Zhang, L. X., and Hsu, T. T. C. (1998). “Behavior and analysis of 100 MPa concrete membrane elements.” J. Struct. Eng., 24–34.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jul 8, 2015
Accepted: Dec 21, 2016
Published ahead of print: Apr 14, 2017
Published online: Apr 15, 2017
Published in print: Aug 1, 2017
Discussion open until: Sep 15, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.