Approach to Developing Design Charts for Quantifying the Influence of Blast Wave Clearing on Target Deformation
Publication: Journal of Structural Engineering
Volume 143, Issue 1
Abstract
If a structural component is located close to the free edge of a building, clearing of the blast wave around the target edge may significantly influence the temporal characteristics of the applied pressure. Because of this, traditional analysis methods assuming a linear decaying load may not be valid, particularly if the blast event imparts a relatively large impulse from the negative phase. Treatment of this phenomenon is brief in the literature, and its influence is usually neglected. This article presents an approach to quantifying the influence of clearing on target deformation, through rigorous analysis of elastic–perfectly-plastic equivalent single-degree-of-freedom (SDOF) systems. The cleared load is evaluated for structural components situated at various distances from the free edge of a reflecting surface using the Hudson acoustic approximation. The results from the SDOF analyses are then used to draw up design charts for determination of the likely influence clearing may have on the design of blast-resistant structural components. Four regions are identified: areas where clearing is beneficial, where clearing has no effect, where clearing is acting adversely, or where clearing is acting highly adversely. The method presented herein provides clear demarcation of these regions.
Get full access to this article
View all available purchase options and get full access to this article.
References
Biggs, J. M. (1964). Introduction to structural dynamics, McGraw-Hill, New York.
CSA (Canadian Standards Association). (2012). “Design and assessment of buildings subjected to blast loads.” CSA-S850-12, Mississauga, Canada.
Dusenberry, D. O. (2010). Handbook for blast-resistant design of buildings, Wiley, Hoboken, NJ.
Gantes, C., and Pnevmatikos, N. (2004). “Elastic-plastic response spectra for exponential blast loading.” Int. J. Impact Eng., 30(3), 323–343.
Hudson, C. C. (1955). “Sound pulse approximations to blast loading (with comments on transient drag).”, Sandia Corporation, Albuquerque, NM.
Hyde, D. W. (1991). “Conventional weapons program (ConWep).” U.S. Army Waterways Experimental Station, Vicksburg, MS.
Kingery, C. N., and Bulmash, G. (1984). “Airblast parameters from TNT spherical air burst and hemispherical surface burst.”, U.S. Army BRL, Aberdeen Proving Ground, Aberdeen, MD.
Kinney, G. F., and Graham, K. J. (1985). Explosive shocks in air, Springer, New York.
Morison, C. (2007). “The resistance of laminated glass to blast pressure loading and the coefficients for single degree of freedom analysis of laminated glass.” Ph.D. thesis, Defence College Management and Technology, Cranfield Univ., Cranfield, U.K.
Norris, C. H., Hansen, R. J., Myle, J. H., Biggs, J. M., Namyet, S., and Minami, J. K. (1959). Structural design for dynamic loads, McGraw-Hill, New York.
Rigby, S. E. (2014). “Blast wave clearing effects on finite-sized targets subjected to explosive loads.” Ph.D. thesis, Dept. of Civil and Structural Engineering, Univ. of Sheffield, Sheffield, U.K.
Rigby, S. E., Tyas, A., and Bennett, T. (2012). “Single-degree-of-freedom response of finite targets subjected to blast loading—The influence of clearing.” Eng. Struct., 45, 396–404.
Rigby, S. E., Tyas, A., and Bennett, T. (2014a). “Elastic-plastic response of plates subjected to cleared blast loads.” Int. J. Impact Eng., 66, 37–47.
Rigby, S. E., Tyas, A., Bennett, T., Clarke, S. D., and Fay, S. D. (2014b). “The negative phase of the blast load.” Int. J. Protective Struct., 5(1), 1–20.
Rigby, S. E., Tyas, A., Bennett, T., Fay, S. D., Clarke, S. D., and Warren, J. A. (2014c). “A numerical investigation of blast loading and clearing on small targets.” Int. J. Protective Struct., 5(3), 253–274.
Rigby, S. E., Tyas, A., Bennett, T., Warren, J. A., and Fay, S. (2013). “Clearing effects on plates subjected to blast loads.” Eng. Comput. Mech., 166(3), 140–148.
Rose, T. A., and Smith, P. D. (2000). “An approach to the problem of blast wave clearing on finite structures using empirical procedures based on numerical calculations.” 16th Symp. on the Military Aspects of Blast and Shock (MABS16), Oxford, U.K., 113–120.
Tyas, A., Warren, J., Bennett, T., and Fay, S. (2011). “Prediction of clearing effects in far-field blast loading of finite targets.” Shock Waves, 21(2), 111–119.
U.S. Department of Defense. (2008). “Structures to resist the effects of accidental explosions.” UFC-3-340-02, Washington, DC.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Aug 19, 2015
Accepted: Jun 16, 2016
Published online: Jul 27, 2016
Discussion open until: Dec 27, 2016
Published in print: Jan 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.