Design Wind Loads Including Torsion for Rectangular Buildings with Horizontal Aspect Ratio of 1.6
Publication: Journal of Structural Engineering
Volume 140, Issue 4
Abstract
Limited information is available regarding wind-induced torsional loads on buildings. This paper presents results of tests carried out in a boundary-layer wind tunnel using building models with the same plan dimensions (aspect ratio of 1.6) and located in a simulated open terrain exposure for different wind directions. Synchronized wind pressure measurements allowed estimating instantaneous base-shear forces and torsional moments on the tested rigid building models. Results were normalized and presented in terms of shear and torsional coefficients for two load cases, namely: maximum torsion and corresponding shear, and maximum shear and corresponding torsion. Comparison of the wind-tunnel test results with current torsion- and shear-related provisions in the American standard demonstrates good agreement for low-rise buildings but differences for medium-rise buildings.
Get full access to this article
View all available purchase options and get full access to this article.
References
ASCE. (2010). “Minimum design loads for buildings and other structures.”, Structural Engineering Institute, Reston, VA.
Elsharawy, M., Stathopoulos, T., and Galal, K. (2012). “Wind-Induced torsional loads on low buildings.” J. Wind Eng. Ind. Aerod., 104–106, 40–48.
European Committee for Standardisation (CEN). (2005). “Eurocode 1: Actions on structures—Part 1–4: General actions—Wind actions.”, Brussels.
Isyumov, N., and Case, P. C. (2000). “Wind-Induced torsional loads and responses of buildings.” Proc., Structures Congress, ASCE/SEI, Reston, VA.
Keast, D. C., Barbagallo, A., and Wood, G. S. (2012). “Correlation of wind load combinations including torsion on medium-rise buildings.” Wind Struct. Int. J., 15(5), 423–439.
National Research Council of Canada (NBCC). (2010). User’s guide—NBC 2010, Structural Commentaries (Part 4 of Division B), Canadian Commission on Buildings and Fire Codes, Ottawa.
Standards Australia. (2011). “Structural design actions part 2: Wind actions.” AS/NZS 1170.2-2011, Standards Australia, Sydney NSW.
Tamura, Y., Kikuchi, H., and Hibi, K. (2001). “Extreme wind pressure distributions on low- and middle-rise building models.” J. Wind Eng. Ind. Aerod., 89(14–15), 1635–1646.
Tamura, Y., Kikuchi, H., and Hibi, K. (2008). “Peak normal stresses and effects of wind direction on wind load combinations for medium-rise buildings.” J. Wind Eng. Ind. Aerod., 96(6–7), 1043–1057.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 19, 2012
Accepted: Oct 21, 2013
Published online: Dec 13, 2013
Published in print: Apr 1, 2014
Discussion open until: May 13, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.