Corrosion Characteristics of Steel Bars Embedded in Recycled Concrete Beams under Static Loads
Publication: Journal of Materials in Civil Engineering
Volume 32, Issue 9
Abstract
To investigate the corrosion characteristics of steel bars embedded in recycled concrete beams under static loads, 12 recycled concrete beams were designed for electrochemical corrosion test taking into consideration a combination of 3 types of recycled coarse aggregate (RCA) replacement ratios (i.e., 0%, 50%, and 100%) and 4 levels of static load (i.e., 0, 0.2, 0.4, and 0.6). The results indicate that the mass losses of longitudinal tensile reinforcement and stirrup increase with both the RCA replacement ratio and the applied static load level. For corroded beams with a 50% RCA replacement ratio, the effect of an increase of 0.2 in the applied static load level on the corrosion of longitudinal tensile steel bars is greater than that of an increase of 50% in the RCA replacement ratio. For corroded beams with the same RCA replacement ratio, the maximum mass losses of longitudinal tensile reinforcement and short limbs of stirrups in the tension zone of the beams have a linear relationship with their average mass losses, and there is a positive correlation in the corrosion degree between the short limbs of stirrups in the tension zone of the beams and the longitudinal tensile steel bar. There exists a linear relationship between the pitting factor of longitudinal tensile reinforcement and its average mass loss, and the pitting factor decreases with the increase in average mass loss, which indicates that the corrosion of longitudinal tensile reinforcement tends to be uniform along the length with its increasing average mass loss.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All experimental data, computed data, models, and code generated or used during the study appear in this article.
Acknowledgments
The authors would like to acknowledge the financial support of the Transportation Science and Technology Project of Shaanxi Transportation Department of China (10-43K) for this research.
References
Arredondo-Rea, S. P., R. Corral-Higuera, M. A. Neri-Flores, J. M. Gómez-Soberón, F. Almeraya-Calderón, J. H. Castorena-González, and J. L. Almaral-Sánchez. 2011. “Electrochemical corrosion and electrical resistivity of reinforced recycled aggregate concrete.” Int. J. Electrochem. Sci. 6: 475–483.
Cao, F., C. Wang, L. Liu, Y. Xin, J. Li, and Z. Tian. 2015. “Experimental study and rigidity analysis on corroded reinforced recycled concrete beams.” [In Chinese.] Build. Struct. 45 (10): 49–55. https://doi.org/10.19701/j.jzjg.2015.10.010.
Chinese Standard. 2009. Standard for test methods of long-term performance and durability of ordinary concrete. [In Chinese.] GB/T 50082. Beijing: China Architecture & Building Press.
Chinese Standard. 2010a. Code for design of concrete structures. [In Chinese.] GB 50010. Beijing: China Architecture & Building Press.
Chinese Standard. 2010b. Recycled coarse aggregate for concrete. [In Chinese.] GB/T 25177. Beijing: Standards Press of China.
Dong, J., Y. Zhao, K. Wang, and W. Jin. 2017. “Crack propagation and flexural behaviour of RC beams under simultaneous sustained loading and steel corrosion.” Constr. Build. Mater. 151 (Oct): 208–219. https://doi.org/10.1016/j.conbuildmat.2017.05.193.
Fu, C., N. Jin, H. Ye, X. Jin, and W. Dai. 2017. “Corrosion characteristics of a 4-year naturally corroded reinforced concrete beam with load-induced transverse cracks.” Corros. Sci. 117 (Mar): 11–23. https://doi.org/10.1016/j.corsci.2017.01.002.
Gao, Z., R. Y. Liang, and A. K. Patnaik. 2016. “Effects of sustained loading and pre-existing cracks on corrosion behavior of reinforced concrete slabs.” Constr. Build. Mater. 124 (Oct): 776–785. https://doi.org/10.1016/j.conbuildmat.2016.08.010.
Ji, Y. S. 2011. Performance and prediction of reinforced concrete in full service life due to corrosion damage. [In Chinese.] Beijing: China Railway Publishing House.
Koushkbaghi, M., M. Jafarkazemi, H. Mosavi, and E. Mohseni. 2019. “Acid resistance and durability properties of steel fiber-reinforced concrete incorporating rice husk ash and recycled aggregate.” Constr. Build. Mater. 202 (Mar): 266–275. https://doi.org/10.1016/j.conbuildmat.2018.12.224.
Levy, S. M., and P. Helene. 2004. “Durability of recycled aggregates concrete: A safe way to sustainable development.” Cem. Concr. Res. 34 (11): 1975–1980. https://doi.org/10.1016/j.cemconres.2004.02.009.
Li, H., B. Li, R. Jin, S. Li, and J. G. Yu. 2018. “Effects of sustained loading and corrosion on the performance of reinforced concrete beams.” Constr. Build. Mater. 169 (Apr): 179–187. https://doi.org/10.1016/j.conbuildmat.2018.02.199.
Malumbela, G., M. Alexander, and P. Moyo. 2010. “Variation of steel loss and its effect on the ultimate flexural capacity of RC beams corroded and repaired under load.” Constr. Build. Mater. 24 (6): 1051–1059. https://doi.org/10.1016/j.conbuildmat.2009.11.012.
Olorunsogo, F. T., and N. Padayachee. 2002. “Performance of recycled aggregate concrete monitored by durability indexes.” Cem. Concr. Res. 32 (2): 179–185. https://doi.org/10.1016/S0008-8846(01)00653-6.
Otsuki, N., S. I. Miyazato, and W. Yodsudjai. 2003. “Influence of recycled aggregate on interfacial transition zone, strength, chloride penetration and carbonation of concrete.” J. Mater. Civ. Eng. 15 (5): 443–451. https://doi.org/10.1061/(ASCE)0899-1561(2003)15:5(443).
Poursaee, A., and C. M. Hansson. 2009. “Potential pitfalls in assessing chloride-induced corrosion of steel in concrete.” Cem. Concr. Res. 39 (5): 391–400. https://doi.org/10.1016/j.cemconres.2009.01.015.
Srubar, W. V., III. 2015. “Stochastic service-life modeling of chloride-induced corrosion in recycled-aggregate concrete.” Cem. Concr. Compos. 55 (Jan): 103–111. https://doi.org/10.1016/j.cemconcomp.2014.09.003.
Stambaugh, N. D., T. L. Bergman, and W. V. Srubar III. 2018. “Numerical service-life modeling of chloride-induced corrosion in recycled-aggregate concrete.” Constr. Build. Mater. 161 (Feb): 236–245. https://doi.org/10.1016/j.conbuildmat.2017.11.084.
Sun, Y. 2009. “Experimental study on the ability of anti-carbonation of recycled concrete and its steel bar corrosion.” [In Chinese.] Master thesis, Dept. of Civil Engineering, College of Civil Engineering and Architecture, Zhejiang Univ. of Technology.
Topçu, I. B. 1997. “Physical and mechanical properties of concretes produced with waste concrete.” Cem. Concr. Res. 27 (12): 1817–1823. https://doi.org/10.1016/S0008-8846(97)00190-7.
Villagrán-Zaccardi, Y. A., C. J. Zega, and Á. A. Di Maio. 2008. “Chloride penetration and binding in recycled concrete.” J. Mater. Civ. Eng. 20 (6): 449–455. https://doi.org/10.1061/(ASCE)0899-1561(2008)20:6(449).
Wei, J. 2017. “Experimental study on flexural behavior of recycled concrete beams.” [In Chinese.] Master thesis, Dept. of Bridge Engineering, School of Civil Engineering, Beijing Jiaotong Univ.
Wu, Y. 2013. “Two-stage model and crack development in reinforced concrete structures with rebar corrosion.” [In Chinese.] Master thesis, Dept. of Structural Engineering, College of Civil Engineering and Architecture, Zhejiang Univ.
Ye, H., C. Fu, N. Jin, and X. Jin. 2018. “Performance of reinforced concrete beams corroded under sustained service loads: A comparative study of two accelerated corrosion techniques.” Constr. Build. Mater. 162 (Feb): 286–297. https://doi.org/10.1016/j.conbuildmat.2017.10.108.
Ye, T., W. Cao, Q. Qiao, and Y. Zhang. 2017. “Experimental study on the flexural properties of corroded reinforced high-strength recycled concrete beams.” [In Chinese.] J. Nat. Disaster 26 (6): 93–101. https://doi.org/10.13577/j.jnd.2017.0611.
Yoon, S., K. Wang, W. J. Weiss, and S. P. Shah. 2000. “Interaction between loading, corrosion, and serviceability of reinforced concrete.” ACI Mater. J. 97 (6): 637–644.
Yuan, Y., Y. Ji, and S. P. Shah. 2007. “Comparison of two accelerated corrosion techniques for concrete structures.” ACI Struct. J. 104 (3): 344–347.
Yuan, Y. S. 2013. Durability design evaluation and test of reinforced concrete structure. [In Chinese.] Xuzhou, China: China Univ. of Mining and Technology Press.
Zhang, C. 2016. “Steel corrosion and cracking due to corrosion in recycled aggregate concrete.” [In Chinese.] Master thesis, Dept. of Construction Engineering, College of Civil Engineering and Architecture, Guangxi Univ.
Zhang, H., and Y. Zhao. 2015. “Integrated interface parameters of recycled aggregate concrete.” Constr. Build. Mater. 101 (Dec): 861–877. https://doi.org/10.1016/j.conbuildmat.2015.10.084.
Zhang, H., and Y. Zhao. 2016. “Performance of recycled concrete beams under sustained loads coupled with chloride ion (Cl−) ingress.” Constr. Build. Mater. 128 (Dec): 96–107. https://doi.org/10.1016/j.conbuildmat.2016.10.028.
Zhang, H., and Y. Zhao. 2019. “Cracking of reinforced recycled aggregate concrete beams subjected to loads and steel corrosion.” Constr. Build. Mater. 210 (Jun): 364–379. https://doi.org/10.1016/j.conbuildmat.2019.03.161.
Zhang, X., C. Zhang, and Z. Dai. 2016. “Prediction model of critical corrosion rate in recycled aggregate concrete structures.” [In Chinese.] J. Guangxi Univ. (Nat. Sci. Ed.) 41 (4): 945–952. https://doi.org/10.13624/j.cnki.issn.1001-7445.2016.0945.
Zhao, P., G. Xu, Q. Wang, and G. Tang. 2019. “Influence of sustained load on corrosion characteristics of reinforced concrete beams under galvanostatic accelerated corrosion.” Constr. Build. Mater. 215 (Aug): 30–42. https://doi.org/10.1016/j.conbuildmat.2019.04.142.
Zhao, Y., J. Dong, Y. Wu, H. Wang, X. Li, and Q. Xu. 2014. “Steel corrosion and corrosion-induced cracking in recycled aggregate concrete.” Corros. Sci. 85 (Aug): 241–250. https://doi.org/10.1016/j.corsci.2014.04.028.
Zhu, W., and R. François. 2015. “Structural performance of RC beams in relation with the corroded period in chloride environment.” Mater. Struct. 48 (6): 1757–1769. https://doi.org/10.1617/s11527-014-0270-2.
Zhu, W., R. François, D. Coronelli, and D. Cleland. 2013. “Effect of corrosion of reinforcement on the mechanical behaviour of highly corroded RC beams.” Eng. Struct. 56 (Nov): 544–554. https://doi.org/10.1016/j.engstruct.2013.04.017.
Zhu, W., R. François, and Y. Liu. 2017. “Propagation of corrosion and corrosion patterns of bars embedded in RC beams stored in chloride environment for various periods.” Constr. Build. Mater. 145 (Aug): 147–156. https://doi.org/10.1016/j.conbuildmat.2017.03.210.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: Oct 16, 2019
Accepted: Mar 17, 2020
Published online: Jul 1, 2020
Published in print: Sep 1, 2020
Discussion open until: Dec 1, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.