Mechanism and Effectiveness of a Silicone-Based Warm Mix Additive
Publication: Journal of Materials in Civil Engineering
Volume 31, Issue 1
Abstract
Water damage is a major obstacle to the development of warm mix asphalt (WMA) technology. The addition of antistripping agents (ASAs) increases the difficulty of construction, and it may interact with warm mix additives, resulting in the uncertainty of long-term performance of asphalt mixture. In this paper, a silicone-based warm mix additive with adhesion promoting properties with the proprietary name TEGO, was studied. The warm mixing mechanism of the additive and the effect on asphalt-aggregate interface adhesion was mainly studied. The rotational viscosity (RV) of the asphalt binder and asphalt mortar with different dosages of TEGO at different temperatures was investigated based on the RV test to evaluate the warm mixing efficiency of each component in TEGO from two levels, the binder and the mortar. The infrared (IR) spectrum of asphalt binder before and after modification with TEGO and the two aggregates before and after treatment with TEGO was tested to evaluate the microcosmic mechanism of the additive in the asphalt mixture system. The concept of surface free energy (SFE) and the corresponding indexes [work of cohesion of asphalt, work of adhesion between asphalt and aggregate, and spreading coefficient ()] was tested to evaluate the workability and water damage resistance of the mixture comprehensively. The results showed that the warm mixing mechanism of TEGO mainly includes viscosity reduction, interfacial lubrication, and improvement of wettability of asphalt to aggregate. TEGO can form a good physical combination with aggregates and it enhances the bonding potential of asphalt with aggregates.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was financially supported by the National Natural Science Foundation of China (51778482).
References
An, Q., K. Guo, M. Li, and L. Huang. 2008. “Synthesis, characterization of polyether-b-polysiloxane and its application in defoamer.” Silicone Mater. 22 (6): 344–348.
Arabani, M., H. Roshani, and G. H. Hamedi. 2012. “Estimating moisture sensitivity of warm mix asphalt modified with zycosoil as an antistrip agent using surface free energy method.” J. Mater. Civ. Eng. 24 (7): 889–897. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000455.
Azarhoosh, A., F. M. Nejad, and A. Khodaii. 2016. “Evaluation of the effect of nano- on the adhesion between aggregate and asphalt binder in hot mix asphalt.” Eur. J. Environ. Civ. Eng. 22 (8): 1–16. https://doi.org/10.1080/19648189.2016.1229227.
Bhasin, A., D. N. Little, K. L. Vasconcelos, and E. Masad. 2007. “Surface free energy to identify moisture sensitivity of materials for asphalt mixes.” Transp. Res. Rec. 2001 (1): 37–45. https://doi.org/10.3141/2001-05.
Bhattacharjee, G., V. Barmecha, O. S. Kushwaha, and R. Kumar. 2018. “Kinetic promotion of methane hydrate formation by combining anionic and silicone surfactants: Scalability promise of methane storage due to prevention of foam formation.” J. Chem. Thermodyn. 117: 248–255. https://doi.org/10.1016/j.jct.2017.09.029.
Binder, L., J. Jatschka, D. Baurecht, M. Wirth, and C. Valenta. 2017. “Novel concentrated water-in-oil emulsions based on a non-ionic silicone surfactant: Appealing application properties and tuneable viscoelasticity.” Eur. J. Pharm. Biopharm. 120: 34–42. https://doi.org/10.1016/j.ejpb.2017.08.003.
Diab, A., Z. You, Z. Hossain, and M. Zaman. 2014. “Moisture susceptibility evaluation of nanosize hydrated lime-modified asphalt-aggregate systems based on surface free energy concept.” Transp. Res. Rec. 2446 (1): 52–59. https://doi.org/10.3141/2446-06.
Ding, Y., B. Huang, and X. Shu. 2018. “Blending efficiency evaluation of plant asphalt mixtures using fluorescence microscopy.” Constr. Build. Mater. 161: 461–467. https://doi.org/10.1016/j.conbuildmat.2017.11.138.
Ghabchi, R., D. Singh, M. Zaman, and Q. Tian. 2013. “Mechanistic evaluation of the effect of WMA additives on wettability and moisture susceptibility properties of asphalt mixes.” J. Test. Eval. 41 (6): 20120317. https://doi.org/10.1520/JTE20120317.
Good, R. J., and C. J. Van Oss. 1971. “The modern theory of contact angle and the hydrogen bond components of surface energies.” In Modern approach to wettability. New York: Plenum Press.
Hesami, S., H. Roshani, G. H. Hamedi, and A. Azarhoosh. 2013. “Evaluate the mechanism of the effect of hydrated lime on moisture damage of warm mix asphalt.” Constr. Build. Mater. 47: 935–941. https://doi.org/10.1016/j.conbuildmat.2013.05.079.
Hossain, Z., S. Lewis, M. Zaman, A. Buddhala, and E. O’Rear. 2013. “Evaluation for warm-mix additive-modified asphalt binders using spectroscopy techniques.” J. Mater. Civ. Eng. 25 (2): 149–159. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000562.
Hurley, G. C., and B. D. Prowell. 2005a. Evaluation of Aspha-Min zeolite for use in warm mix asphalt. Auburn, AL: National Center for Asphalt Technology.
Hurley, G. C., and B. D. Prowell. 2005b. Evaluation of Sasobit for use in warm mix asphalt. Auburn, AL: National Center for Asphalt Technology.
Li, B., Z. Zhang, X. Liu, X. Li, and Z. Lv. 2017a. “Adhesion in SBS modified asphalt containing warm mix additive and aggregate system based on surface free theory.” Mater. Rev. 31 (2): 115–120.
Li, L., M. Zhang, and W. Qi. 2017b. “Regeneration of aged SBS modified asphalt and its mechanism analysis.” J. Chang’an Univ. (Nat. Sci. Ed.) 37 (3): 1–8.
Nazzal, M. D., L. Abu-Qtaish, S. Kaya, and D. Powers. 2015. “Using atomic force microscopy to evaluate the nanostructure and nanomechanics of warm mix asphalt.” J. Mater. Civ. Eng. 27 (10): 04015005. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001254.
Oliveira, J. R., H. M. Silva, L. P. Abreu, and S. R. Fernandes. 2013. “Use of a warm mix asphalt additive to reduce the production temperatures and to improve the performance of asphalt rubber mixtures.” J. Cleaner Prod. 41 (41): 15–22. https://doi.org/10.1016/j.jclepro.2012.09.047.
Peng, D., H. Chen, C. Zhang, Y. Li, and J. Qin. 2014. “Research progress of asphalt anti-stripping agents.” Supplement, Mater. Rev. 28 (S1): 325–327.
Sun, D., G. Sun, X. Zhu, F. Ye, and J. Xu. 2018. “Intrinsic temperature sensitive self-healing character of asphalt binders based on molecular dynamics simulations.” Fuel 211: 609–620. https://doi.org/10.1016/j.fuel.2017.09.089.
Teng, X. 2009. Physical chemistry of surfaces. Beijing: Chemical Industry Press.
Tong, L., Y. Yang, X. Luan, J. Shen, and X. Xin. 2017. “Supramolecular hydrogels facilitated by -cyclodextrin and silicone surfactants and their use for drug release.” Colloids Surf. A 522: 470–476. https://doi.org/10.1016/j.colsurfa.2017.03.026.
Wang, H., R. Zhang, Z. He, X. Zhang, and P. He. 2017. “Interfacial performance of coupling agent modified asphalt and egg crushed stone aggregate.” Bull. Chin. Ceram. Soc. 36 (8): 2689–2694.
Wasiuddin, N. M., M. M. Zaman, and E. A. O’Rear. 2008. “Effect of Sasobit and Aspha-min on wettability and adhesion between asphalt binders and aggregates.” Transp. Res. Rec. 2051 (1): 80–89. https://doi.org/10.3141/2051-10.
Woszuk, A., and W. Franus. 2017. “A review of the application of zeolite materials in warm mix asphalt technologies.” Appl. Sci. 7 (3): 293. https://doi.org/10.3390/app7030293.
Xiao, F., W. Zhao, T. Gandhi, and S. N. Amirkhanian. 2010. “Influence of anti-stripping additives on moisture susceptibility of warm mix asphalt mixtures.” J. Mater. Civ. Eng. 22 (10): 1047–1055. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000111.
Yu, H., Z. Leng, F. Xiao, and Z. Gao. 2016. “Rheological and chemical characteristics of rubberized binders with non-foaming warm mix additives.” Constr. Build. Mater. 111: 671–678. https://doi.org/10.1016/j.conbuildmat.2016.02.066.
Zhang, K., R. Luo, and D. Zhang. 2016. “Wettability analysis on colored resin asphalt binder based on surface free energy theory.” China J. Highway Transp. 29 (5): 34–40.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Apr 9, 2018
Accepted: Jun 14, 2018
Published online: Oct 19, 2018
Published in print: Jan 1, 2019
Discussion open until: Mar 19, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.