Material Properties of Crushable Concrete for Use in Vehicle Antiram Barriers
Publication: Journal of Materials in Civil Engineering
Volume 29, Issue 4
Abstract
With raised national security awareness because of terroristic threats, more focus recently has been placed on barrier and safety systems that can prevent the loss of life and structural damage as a result of vehicular impact and blast loading. One potential method for dissipating some of a vehicle’s high kinetic energy is to use crushable concrete in the barrier design. In this study, multiple crushable concrete mixtures containing partial and full replacement of aggregate by expanded polystyrene spheres were tested in unconfined and confined compression tests to evaluate their capacity of energy dissipation. Unconfined testing showed high ductility of polystyrene concrete, but the samples ultimately failed in shear. More efficient use of the crushable concrete was encapsulating the specimens. Confined compression tests showed much larger energy absorption capacity of all mixtures studied. Changes in the water-to-cement ratio () and loading rate had minimal effect on energy absorption and strength. However, increasing the amount of polystyrene replaced caused an increase in deformability and decreased the strength capacity. Additionally, dynamic compression tests were conducted on confined samples. Image analysis of the test samples showed that with an increase in strain values, the compression of the polystyrene increased. As a result, the relative volume of concrete increased with a decrease in the relative volume of voids.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the financial support from the U.S. Department of State, funding available from the College of Engineering (CoE) at the Pennsylvania State University via CoE Innovation Grant Program, and the technical assistance of Mr. Dan Fura in laboratory testing. Special thanks to General Electric’s inspection and nondestructive testing facility for assistance in CT imaging. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the authors and do not necessarily reflect those of the U.S. Department of State.
References
ASTM. (2012). “Standard test method for compressive strength of lightweight insulating concrete.” ASTM C495-12, West Conshohocken, PA.
ASTM. (2015). “Standard test method for vehicle crash testing of perimeter barriers.” ASTM F2656-15, West Conshohocken, PA.
Babu, K. G., and Babu, D. S. (2003). “Behaviour of lightweight expanded polystyrene concrete containing silica fume.” Cem. Concr. Res., 33(5), 755–762.
Bassani, M., Sacchi, E., and Canonico, F., (2012). “Performance prediction for innovative crushable material used in aircraft arrestor beds.” J. Mater. Civ. Eng., 725–734.
Bischoff, P. H., Yamura, K., and Perry, S. H. (1990). “Polystyrene aggregate concrete subjected to hard impact.” Proc., Pt 2, Institution of Civil Engineers, Vol. 89, Arkose Press, Great Britain, 225–239.
Chen, B., and Liu, J. (2004). “Properties of lightweight expanded polystyrene concrete reinforced with steel fiber.” Cem. Concr. Res., 34(7), 1259–1263.
Cook, D. J. (1973). “Expanded polystyrene beads as lightweight aggregate for concrete.” Precast Concr., 4(12), 691–693.
Harrison, T. L. (2004). “Design of fixed ram-resistant vehicle barriers for perimeter security.” Proc., 2004 Structures Congress—Building on the Past: Securing the Future, ASCE, Nashville, TN.
Hennin, S., Germana, G., and Garcia, L. (2007). “Integrated perimeter security system.” IEEE Conf. on Technologies for Homeland Security: Enhancing Critical Infrastructure Dependability, Woburn, MA, 70–75.
Herki, B. A., and Khatib, J. M. (2013). “Lightweight concrete incorporating waste expanded polystyrene.” Advanced materials research, Vol. 787, Trans Tech Publications, Pfaffikon, Switzerland, 133–137.
Heymsfield, E., and Halsey, T. L. (2008). “Sensitivity analysis of engineered material arrestor systems to aircraft and arrestor material characteristics.” Trans. Rsrch Rec., 2052, 110–117.
Li, G., and Muthyala, V. D. (2008). “A cement based syntactic foam.” Mater. Sci. Eng.: A, 478(1–2), 77–86.
Ning, X., Liu, J., and Yang, Z. (2011). “Research on expanded polystyrene light-aggregate concrete.” Advanced materials research, Vol. 168–170, Trans Tech Publications, Pfaffikon, Switzerland, 276–280.
Paul, A., and Ramamurty, U. (2000). “Strain rate sensitivity of a closed-cell aluminum foam.” Mater. Sci. Eng., 281(1), 1–7.
Perry, S. H., Bischoff, P. H., and Yamura, K. (1991). “Mix details and material behaviour of polystyrene aggregate concrete.” Mag. Concr. Res., 43(154), 71–76.
Rickman, D. D., Murrell, D. W., and Armstrong, B. J. (2006). “Improved predictive methods for airblast shielding by barrier walls.” Proc., Structures Congress and Exposition, ASCE, Reston, VA.
Santagata, E., Bassani, M., and Sacchi, E. (2010). “Performance of new materials for aircraft arrestor beds.” Transp. Res. Rec., 2177, 124–131.
Schneider, C. A., Rasband, W. S., and Eliceiri, K. W. (2012). “NIH image to imageJ: 25 years of image analysis.” Nat. Methods, 9(7), 671–675.
Visual Sciences Group. (2009). “Avizo user’s guide version 6.” FEI Visual Sciences Group, Burlington, MA.
White, J. C., and Agrawal, S. K. (1993). “Soft ground arresting systems for airports.”, FAA, U.S. Dept. of Transportation, Atlantic City International Airport, NJ.
Zhang, Z. Q., Yang, J. L., and Li, Q. M. (2013). “An analytical model of foamed concrete aircraft arresting system.” Int. J. Impact Eng., 61, 1–12.
Zhen, W. U., Bing, C., and Ning, L. (2013). “Fabrication and compressive properties of expanded polystyrene foamed concrete: Experimental research and modeling.” J. Shanghai Jiaotong Univ., 18(1), 61–69.
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Mar 25, 2016
Accepted: Aug 9, 2016
Published online: Oct 26, 2016
Discussion open until: Mar 26, 2017
Published in print: Apr 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.