Aging-Effect Incorporation into the Fatigue-Damage Modeling of Asphalt Mixtures Using the S-VECD Model
Publication: Journal of Materials in Civil Engineering
Volume 28, Issue 12
Abstract
This work focuses on modeling fatigue for aged asphalt mixtures. This is accomplished by combining existing models and adapting asphalt mixture aging laboratory procedures. The aging model used is based on the evolution of an internal state variable, and it is capable of taking into account the effect of aging temperature. The simplified viscoelastic continuum damage (S-VECD) model was selected for representing the fatigue damage behavior. Results at four aging states were analyzed, including the unaged mixture. Aged mixtures were obtained by heating loose asphalt mixture in an oven for two periods (2 and 45 days) and two temperatures (85 and 135°C). Based on the results from linear viscoelastic and S-VECD characterization, it was concluded that aging produces less damage tolerant materials; i.e., fatigue failure is observed for less evolved damage states. However, depending on the pavement conditions and on the pavement cross section geometry, because of the increase in material stiffness, aging may not be responsible for a decrease in fatigue life.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (2011). “Standard method of test for determining dynamic modulus of hot mix asphalt concrete mixtures.” AASHTO T 342, Washington, DC.
AASHTO. (2014a). “Determining the damage characteristic curve of asphalt concrete from direct tension cyclic fatigue tests.” AASHTO TP 107, Washington, DC.
AASHTO. (2014b). “Standard practice for mixture conditioning of hot mix asphalt (HMA).” AASHTO R 30, Washington, DC.
Al-Rub, R. K. A., Darabi, M. K., Kim, S.-M., Little, D. N., and Glover, C. J. (2013). “Mechanistic-based constitutive modeling of oxidative aging in aging-susceptible materials and its effect on the damage potential of asphalt concrete.” Constr. Build. Mater., 41, 439–454.
Babadopulos, L. F. A. L. (2014). “A contribution to couple aging to hot mix asphalt (HMA) mechanical characterization under load-induced damage.” M.Sc. thesis, Federal Univ. of Ceará, Fortaleza, Brazil.
Babadopulos, L. F. A. L., Ferreira, J. L. S., and Soares, J. B. (2016). “An approach to couple aging to stiffness and permanent deformation modeling of asphalt mixtures.” Mater. Struct., 1–17.
Babadopulos, L. F. A. L., Soares, J. B., and Castelo Branco, V. T. F. (2014). “Aging and constitutive modeling of asphalt mixtures: Research developments in Brazil.” Proc., Int. Conf. on Asphalt Pavements, CRC Press, Boca Raton, FL, 1059–1068.
Baek, C., Underwood, B. S., and Kim, Y. R. (2012). “Effects of oxidative aging on asphalt mixture properties.” Transp. Res. Rec., 2296, 77–85.
Bell, C. A., Wieder, A. J., and Fellin, M. J. (1994). “Laboratory aging of asphalt-aggregate mixtures: Field validation.”, National Research Council, Washington, DC.
Chehab, G. R. (2002) “Characterization of asphalt concrete in tension using a viscoelastoplastic model.” Ph.D. thesis, North Carolina State Univ., Raleigh, NC.
Coutinho, R. P., Babadopulos, L. F. A. L., Freire, R. A., Castelo Branco, V. T. F., and Soares, J. B. (2014). “The use of stress sweep tests for asphalt mixtures nonlinear viscoelastic and fatigue damage responses identification.” Mater. Struct., 47(5), 895–909.
Daniel, J. S., and Kim, Y. R. (2002). “Development of a simplified fatigue test and analysis procedure using a viscoelastic continuum damage model.” J. Assoc. Asphalt Paving Technol., 71, 619–650.
Farrar, M. J., Turner, T. F., Planche, J.-P., Schabron, J. F., and Harnsberger, P. M. (2013) “Evolution of the crossover modulus with oxidative aging: Method to estimate change in viscoelastic properties of asphalt binder with time and depth on the road.” Transp. Res. Rec., 2370, 76–83.
Ghuzlan, K. A., and Carpenter, S. H. (2000). “Energy-derived, damage-based failure criterion for fatigue testing.” Transp. Res. Rec., 1723, 141–149.
Glover, C. J., et al. (2008). “Evaluation of binder aging and its influence in aging of hot mix asphalt concrete: Literature review and experimental design.”, Texas Transportation Institute, Texas A&M Univ. System, College Station, TX.
Liu, M., Ferry, M. A., Davison, R. R., Glover, C. J., and Bullin, J. A. (1998). “Oxygen uptake as correlated to carbonyl growth in aged asphalts and asphalt Corbett fractions.” Ind. Eng. Chem. Res., 37(12), 4669–4674.
Mangiafico, S., Sauzéat, C., Di Benedetto, H., Pouget, S., Olard, F., and Planque, L. (2015). “Quantification of biasing effects during fatigue tests on asphalt mixes: Non-linearity, self-heating and thixotropy.” Road Mater. Pavement Des., 16(2), 73–99.
MATLAB [Computer software]. MathWorks, Natick, MA.
Nascimento, L. A. H. (2015). “Implementation and validation of the viscoelastic continuum damage theory for asphalt mixture and pavement analysis in Brazil.” Ph.D. thesis, North Carolina State Univ., Raleigh, NC.
Nascimento, L. A. H., Rocha, S. M. N., Nascimento, C. E. H., Kim, Y. R., Chacur, M., and Martins, A. T. (2014). “Uso da mecânica do dano contínuo na caracterização de misturas asfálticas brasileiras.” Proc., 21st Encontro de Asfalto of IBP, Instituto Brasileiro de Petróleo, Gás e Biocombustíveis-IBP, RJ, Brazil, 1–14 (in Portuguese).
Park, S. W., and Kim, Y. R. (2001). “Fitting Prony-series viscoelastic models with power-law presmoothing.” J. Mater. Civ. Eng., 13(1), 26–32.
Park, S. W., Kim, Y. R., and Schapery, R. A. (1996). “Viscoelastic continuum damage model and its application to uniaxial behavior of asphalt concrete.” Mech. Mater., 24(4), 241–255.
Partl, M. N., et al. (2012). “Advances in interlaboratory testing and evaluation of bituminous materials.” State-of-the-Art Rep. of the RILEM Technical Committee No. 206-ATB, Springer, Dordrecht.
Pronk, A. C., and Hopman, P. C. (1990). “Energy dissipation: The leading factor of fatigue.” Proc., United States Strategic Highway Research Program–Sharing the Benefits, Institution of Civil Engineers (ICE), London, 255–267.
Robinette, C., and Williams, R. C. (2006). “The effects of the testing history and preparation method on the superpave simple performance test.” J. Assoc. Asphalt Paving Technol., 75, 297–320.
Sabouri, M., and Kim, Y. R. (2014). “Development of a failure criterion for asphalt mixtures under different modes of fatigue loading.” Transp. Res. Rec., 2447, 117–125.
Schapery, R. A. (1990). “Simplifications in the behavior of viscoelastic composites with growing damage.” Symp. Inelastic Deformation of Composite Materials, Mechanics and Materials Center, Texas A&M Univ., College Station, TX.
Underwood, B. S., Baek, C., and Kim, Y. R. (2012). “Simplified viscoelastic continuum damage model as platform for asphalt concrete fatigue analysis.” Transp. Res. Rec., 2296, 36–45.
Underwood, B. S., and Kim, Y. R. (2013). “Nonlinear viscoelastic behavior of asphalt concrete and its implication for fatigue modeling.” Transp. Res. Rec., 2373, 100–108.
Underwood, B. S., Kim, Y. R., Savadatti, S., Thirunavukkarasu, S., and Guddati, M. (2009). “Response and fatigue performance modeling of ALF pavements using 3-D finite element analysis and a simplified viscoelastic continuum damage model.” J. Assoc. Asphalt Paving Technol., 78, 829–868.
Walubita, L. F. (2006). “Comparison of fatigue analysis approaches for predicting fatigue lives of hot mix asphalt concrete mixtures (HMA).” Ph.D. thesis, Texas A&M Univ., College Station, TX.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Feb 4, 2016
Accepted: Apr 21, 2016
Published online: Jul 13, 2016
Published in print: Dec 1, 2016
Discussion open until: Dec 13, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.