Increasing the Service Life of Bridge Decks by Incorporating Phase-Change Materials to Reduce Freeze-Thaw Cycles
Publication: Journal of Materials in Civil Engineering
Volume 24, Issue 8
Abstract
During a freezing event, pore solution in cementitious bodies expands and creates stresses that can cause damage; therefore, reducing the number of freeze/thaw cycles experienced by a structure will extend the structure’s service life. The incorporation of phase-change materials (PCMs) to reduce the number of freeze/thaw cycles experienced by bridge decks has been investigated by modeling, mechanical testing, calorimetry, and X-ray microtomography. Models identified geographical regions in which freeze/thaw damage is not a significant concern and regions where this technology may be practical, increasing the service life of a bridge deck by at least 1 year. The incorporation of PCM reduces strength by varying amounts and for varying reasons, depending on which PCM is used and how it is introduced into the concrete. Because a variety of methods exist to address this loss in strength, PCM incorporation shows promise as a technique for addressing one aspect of worldwide infrastructure maintenance challenges.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank Dr. Jeffrey Bullard and Ryan Lockard for their help with programming, and Entropy Solutions, Inc. for supplying the PT4.
References
AASHTO. (2008). “Bridging the gap—Restoring and rebuilding the nation’s bridges.” Washington, D.C.
ASCE. (2010). “Report card for America’s infrastructure.” 〈www.infrastructurereportcard.org〉 (June 20, 2010).
ASTM. (2005). “Specification for lightweight aggregate for structural concrete.” C330-05, West Conshohocken, PA.
ASTM. (2007). “Standard test method for compressive strength of hydraulic cement mortars [using 2-in. or (50-mm) cube specimens].” C109/C109M-07, West Conshohocken, PA.
Barde, V., Radlinska, A., Cohen, M., and Weiss, W. J. (2009). “Relating material properties to exposure conditions for predicting service life in concrete bridge decks in Indiana.” Publication FHWA/IN/JTRP-2007/27., Indiana DOT and Purdue Univ., West Lafayette, IN.
Bentz, D. P. (2000). A computer model to predict the surface temperature and time-of-wetness of concrete pavements and bridge decks, National Institute of Standards and Technology (NIST), Gaithersburg, MD.
Bentz, D. P., Halleck, P. M., Grader, A. S., and Roberts, J. W. (2006). “Water movement during internal curing: Direct observation using X-ray microtomography.” Concr. Int.CNCIEH, 28(10), 39–45.
Bentz, D. P., and Turpin, R. (2007). “Potential applications of phase change materials in concrete technology.” Cem. Concr. Compos.CCOCEG, 29(7), 527–532.
Bentz, D. P., and Weiss, W. J. (2011). “Internal Curing: A 2010 State-of-the-Art-Review.” NISTIR 7765, U.S. Dept. of Commerce, Washington, D.C.
Berg, A. C., Bank, L. C., Oliva, M. G., and Russell, J. S. (2006). “Construction and cost analysis of an FRP reinforced concrete bridge deck.” Constr. Build. Mater.CBUMEZ, 20(8), 515–526.
Cabeza, L. F., Castell, A., Barreneche, C., de Gracia, A., and Fernández, A. I. (2011). “Materials used as PCM in thermal energy storage in buildings: A review.” Renew. Sustain. Energ. Rev.RSERFH, 15(3), 1675–1695.
Cabeza, L. F., Castellón, C., Nogués, M., Medrano, M., Leppers, R., and Zubillaga, O. (2007). “Use of microencapsulated PCM in concrete walls for energy savings.” Energy Build.ENEBDR, 39(2), 113–119.
Cengel, Y. A., and Boles, M. A. (2002). Thermodynamics: An engineering approach, 4th Ed., McGraw-Hill, New York.
Emmons, P. H., and Sordyl, D. J. (2006). “The state of the concrete repair industry, and a vision for its future.” Concrete Repair Bulletin, International Concrete Repair Institute, Rosemont, IL, 7–14.
Federal Highway Administration. (2011). Deficient bridges by state and highway system, 〈http://www.fhwa.dot.gov/bridge/nbi/defbr10.cfm〉 (Mar. 25, 2011).
Gustafsson, S. E. (1991). “Transient plane source techniques for thermal conductivity and thermal diffusivity measurements of solid materials.” Rev. Sci. Instrum.RSINAK, 62(3), 797–804.
He, Y. (2005). “Rapid thermal conductivity measurement with a hot disk sensor: Part 1. Theoretical considerations.” Thermochim. ActaTHACAS, 436(1–2), 122–129.
Hong, T., and Hastak, M. (2007). “Evaluation and determination of optimal MR&R strategies in concrete bridge decks.” Autom. Constr.AUCOES, 16(2), 165–175.
Hunger, M., Entrop, A. G., Mandilaras, I., Brouwers, H. J. H., and Founti, M. (2009). “The behavior of self-compacting concrete containing micro-encapsulated phase change materials.” Cem. Concr. Compos.CCOCEG, 31(10), 731–743.
Kan, L. L., Shi, H. S., Sakulich, A. R., and Li, V. C. (2010). “Self-healing characterization of engineered cementitious composite materials.” ACI Mater. J.AMAJEF, 107(6), 619–626.
Kuznik, F., David, D., Johannes, K., and Roux, J. J. (2011). “A review on phase change materials integrated in building walls.” Renew. Sustain. Energ. Rev.RSERFH, 15(1), 379–391.
Lopez-Anido, R. (2001). “Life-cycle cost survey of concrete bridge decks a benchmark for FRP bridge deck replacement.” Transportation Research Board 80th Annual Meeting, Transportation Research Board, Washington, D.C.
Marion, W., and Urban, K. (1995). User’s manual for TMY2s typical meteorological years, National Renewable Energy Laboratory, Golden, CO.
Martys, N. S., and Ferraris, C. F. (1997). “Capillary transport in mortars and concrete.” Cem. Concr. Res.CCNRAI, 27(5), 747–760.
Pasupathy, A., Velraj, R., and Seeniraj, R. V. (2008). “Phase change material-based building architecture for thermal management in residential and commercial establishments.” Renew. Sustain. Energ. Rev.RSERFH, 12(1), 39–64.
Schossig, P., Henning, H. M., Gschwander, S., and Haussmann, T. (2005). “Micro-encapsulated phase-change materials integrated into construction materials.” Solar Energy Mater. Sol. CellsSEMCEQ, 89(2–3), 297–306.
Stoll, F., Drake, M. L., and Salyer, I. O. (1996). Use of phase change materials to prevent overnight freezing of bridge decks, Transportation Research Board, Washington, D.C.
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Jun 16, 2011
Accepted: Aug 17, 2011
Published online: Aug 19, 2011
Published in print: Aug 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.