Evaluation of Asphalt Mixtures’ Moisture Sensitivity by Dynamic Creep Test
Publication: Journal of Materials in Civil Engineering
Volume 23, Issue 2
Abstract
A closer look at a number of researches carried out on the stripping potential of asphalt mixtures shows that there is no global agreement on a comprehensive procedure for evaluation of the moisture sensitivity of these mixtures. Therefore, an attempt was made to assess moisture sensitivity and its interaction with permanent deformation through performing a dynamic creep test on coarse graded and dense graded asphalt mixtures in different environmental and loading conditions, using a UTM25 loading machine. In the next step, test results were interpreted by using a newly developed three-stage creep model. According to the results, the coarse graded mixtures have lower moisture sensitivity and could better resist permanent deformations than the dense graded mixtures. Based on the creep models, low stress levels cannot appropriately show the behavior of asphalt specimens. It was also concluded that, at higher temperatures, asphalt mixtures might become more sensitive to temperature than moisture.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
MACADA Asphalt Company and ASPHALT NEMONE company are gratefully acknowledged for their support in supplying the required materials.
References
Aksoy, A., Samlioglu, K., Tayfur, S., and Ozen, H. (2005). “Effects of various additives on the moisture damage sensitivity of asphalt mixtures.” Constr. Build. Mater., 19(1), 11–18.
Alam, M. M., Tandon, V., Nazarian, S., and Tahmoressi, M. (1998). “Identification of moisture-susceptible asphalt concrete mixes using modified environmental conditioning system.” Transp. Res. Rec., 1630, 106–116.
Aschenbrener, T. (1995). “Evaluation of Hamburg wheel-tracking device to predict moisture damage in hot mix asphalt.” Transp. Res. Rec., 1492, 193–201.
Aschenbrener, T., and Currier, G. (1993). “Influence of testing variables on the results from the Hamburg wheel-tracking device.” CDOT-DTD-R-93-22, Colorado DOT, Denver.
Bennert, T., Maher, A., and Smith, J. (2004). Evaluation of crumb rubber in hot mix asphalt, Dept. of Civil and Environmental Engineering, Rutgers Univ., Piscataway, N.J.
Birgisson, B., Roque, R., and Page, G. C. (2003). “Evaluation of water damage using hot mix asphalt fracture mechanics.” Electron. J. Assoc. Asph. Paving Technol., 72, 516–562.
Bouzid, C., Gokhale, S., Gregory, S., and Howard, M. (2006). “Evaluation of coarse-and fine-graded Superpave mixtures under accelerated pavement testing.” Transp. Res. Rec., 1974, 120–127.
Cheng, D. X., Little, D. N., Lytton, R. L., and Holste, J. C. (2002). “Use of surface free energy properties of the asphalt-aggregate system to predict damage potential.” Electron. J. Assoc. Asph. Paving Technol., 71, 59–88.
Cheng, D. X., Little, D. N., Lytton, R. L., and Holste, J. C.,(2003). “Moisture damage evaluation of asphalt mixtures by considering both moisture diffusion and repeated-load conditions.” Transp. Res. Rec., 1832, 42–49.
Gokhale, S., Choubane, B., Byron, T., and Tia, M. (2005). “Rut initiation mechanisms in asphalt mixtures as generated under accelerated pavement testing.” Transp. Res. Rec., 1940, 36–145.
Iran Highway Asphalt Paving Code. (2003). “Publication No. 234.” Ministry of Road and Transportation Research and Education Center, Iran.
Kaloush, K. E., and Witczak, M. W. (2002). “Tertiary flow characteristics of asphalt mixtures.” Electron. J. Assoc. Asph. Paving Technol., 71, 278–306.
Kaloush, K. E., Witczak, M. W., and Way, G. B. (2002). Performance evaluation of Arizona asphalt rubber mixtures using advanced dynamic material characterization tests, Dept. of Civil and Environmental Engineering, College of Engineering and Applied Sciences, Arizona State Univ., Tempe, Ariz.
Kandhal, P. S. (1992). “Moisture susceptibility of HMA mixes, identification of problem and recommended solutions.” NCAT No. 92-1, Auburn Univ., Auburn, Ala.
Kandhal, P. S., and Rickards, I. J. (2001). “Premature failure of asphalt overlays from stripping: Case histories.” Electron. J. Assoc. Asph. Paving Technol., 70, 347–406.
Kanitpong, K., and Bahia, H. U. (2003). “Role of adhesion and thin film tackiness of asphalt binders in moisture damage of HMA.” Electron. J. Assoc. Asph. Paving Technol., 72, 611–642.
Kanitpong, K., and Bahia, H. U. (2005). “Relating adhesion and cohesion of asphalts to the effect of moisture on laboratory performance of asphalt mixtures.” Transp. Res. Rec., 1901, 33–43.
Khodaii, A., and Mehrara, A. (2009). “Evaluation of permanent deformation of unmodified and SBS modified asphalt mixtures using dynamic creep test.” Constr. Build. Mater., 23(7), 2586–2592.
Kiggundu, B. M., and Robberts, F. L. (1988). “Stripping in HMA mixtures: State-of-the art and critical review of test methods.” NCAT No. 88-2, Auburn Univ., Auburn, Ala.
Kim, S., and Coree, B. J. (2005). “Evaluation of hot mix asphalt moisture sensitivity using the Nottingham asphalt test equipment.” Rep. No. IHRB Project TR-483, Dept. of Civil, Construction, and Environmental Engineering, Iowa State Univ., Ames, Iowa.
Kim, Y. -R., Little, D. N., and Lytton, R. L. (2004). “Effect of moisture damage on material properties and fatigue resistance of asphalt mixtures.” Transp. Res. Rec., 1891, 48–54.
Lottman, R. P. (1978). “Predicting moisture-induced damage to asphalt concrete.” NCHRP 192, Transportation Research Board, Washington, D.C.
Majidzadeh, K., and Brovold, F. N. (1966). “Effect of water on bitumen-aggregate mixtures.” CE-1, Univ. of Florida, Gainesville, Fla.
Pan, C., and White, T. D. (1998). “Evaluation of stripping for asphalt concrete mixtures using accelerated testing methods.” Transp. Res. Rec., 1630, 98–105.
Terrel, R. L., and Al Swailmi, S. (1994). “Water sensitivity of asphalt-aggregate mixes.” SHRP-A-403, Oregon State Univ., Carvallis, Ore. (Sponsored by ‘‘National Research Council, Washington’’.)
IPC Global Company. (2006). UTM software reference manual.
Zhou, F., Scullion, T., and Sun, L. (2004). “Verification and modeling of three-stage permanent deformation behavior of asphalt mixes.” J. Transp. Eng., 130(4), 486–494.
Information & Authors
Information
Published In
Copyright
© 2011 ASCE.
History
Received: Mar 7, 2009
Accepted: Jun 30, 2010
Published online: Jul 2, 2010
Published in print: Feb 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.