Numerical Model for the Hydraulic Performance of Perforated Pipe Underdrains Surrounded by Loose Aggregate
Publication: Journal of Hydraulic Engineering
Volume 142, Issue 8
Abstract
This paper presents the results of a computational fluid dynamics (CFD) model study of the hydraulics of groundwater flow and porous pipe underdrains. The study was conducted using a three-dimensional CFD model built in ANSYS Fluent. The model was validated by replicating previous experimental results of saturated subsurface flow (water surface level above the aggregate) for a 10.2-cm perforated pipe shrouded in loose laid aggregate. The CFD model consistently overpredicted the flow rate for a given head and aggregate depth by an average of 11%. After considering the effect of pipe perforation blockage due to aggregate, the average overprediction decreased to only 6%. The discharge coefficient for the perforated pipe computed using the CFD model was 0.54 compared with 0.49 from experiments. It was also found that the discharge was quite small at the upstream end of the pipe, with the bulk of the water entering the pipe in the vicinity of the outlet. Finally, the computational results showed that, for saturated flow conditions, the flow was predominantly in the vertical direction within the aggregate whereas it was mainly horizontal when the water surface level was below the top of the aggregate level (unsaturated condition). The losses associated with the two flow scenarios were explored. The results obtained have practical applications in the design and analysis of porous pipe underdrains.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank Dr. Galen Collier and Dr. Nazli Yilmaz for their generous support during the installation and running of the ANSYS Fluent on palmetto cluster of Clemson University.
References
Abida, H., and Sabourin, J. F. (2006). “Grass swale-perforated pipe system for stormwater management.” J. Irrig. Drain. Eng., 55–63.
Abida, H., Sabourin, J. F., Francois, J., and Ellouze, M. (2007). “ANSWAPPS: Model for the analysis of grass swale-perforated pipe systems.” J. Irrig. Drain. Eng., 211–221.
ANSYS Fluent 14 [Computer software]. ANSYS, Canonsburg, PA.
ANSYS Workbench version 14.0 [Computer software]. Ansys, Canonsburg, PA.
Akan, A. O. (2013). “Preliminary design aid for bioretention filters.” J. Hydrol. Eng., 318–323.
Bledsoe, B. P., and Watson, C. C. (2001). “Effects of urbanization on channel instability.” J. Am. Water Resour. Assoc., 37(2), 255–270.
Clemo, T. (2006). “Flow in perforated pipes: A comparison of models and experiments.” SPE Prod. Oper., 21(2), 302–311.
Donaldson, S. (2004). “The effects of urbanization on the water cycle.” Univ. of Nevada Cooperative Extension, Reno, NV.
Driscoll, E. D., Shelley, P. E., and Strecker, E. W. (1990). “Pollutant loadings and impacts from highway stormwater runoff. Volume III: Analytical investigation and research report.”, Federal Highway Administration, McLean, VA.
Duchene, M., and McBean, E. A. (1992). “Discharge characteristics of perforated pipe for use in infiltration trenches.” J. Am. Water Resour. Assoc., 28(3), 517–524.
Duchene, M., McBean, E. A., and Thomson, N. R. (1994). “Modeling of infiltration from trenches for Stormwater control.” J. Water Resour. Plann. Manage., 276–293.
Dybbs, A., and Edwards, R. V. (1984). “A new look at porous media fluid mechanics—Darcy to turbulent.” Fundamentals of transport phenomena in porous media, Springer, Rotterdam, Netherlands, 199–256.
Ergun, S. (1952). “Fluid flow through packed columns.” Chem. Eng. Progress, 48, 89–94.
Field, R., Tafuri, A. N., Muthukrishnan, S., Acquisto, B. A., and Selvakumar, A. (2006). The use of best management practices (BMP) in Urban Watersheds, DEStech, Lancaster, PA.
Guo, J. C. Y., Kocman, S. M., and Ramaswami, A. (2009). “Design of two-layered porous landscaping detention basin.” J. Environ. Eng., 1268–1274.
He, Z., and Davis, A. P. (2011). “Process modeling of storm water flow in a bio retention cell.” J. Irrig. Drain. Eng., 121–131.
Jenks, H. N. (1921). “An investigation of perforated-pipe filter underdrains.” Eng. News-Rec., 86(4), 162–166.
Kirkkala, T., Ventela, A. M., and Tarvainen, M. (2012). “Long-term field experiment on using lime filters in an agricultural catchment.” J. Environ. Qual., 41(2), 410–419.
Li, Y., Buchberger, S. G., and Sansalone, J. J. (1999). “Variably saturated flow in stormwater partial exfiltration trench.” J. Environ. Eng., 556–565.
Murphy, P. (2013). “The hydraulic performance of perforated pipe under-drains surrounded by loose aggregate.” M.S. thesis, Clemson Univ., Clemson, SC.
Murphy, P., Kaye, N. B., and Khan, A. A. (2014). “Hydraulic performance of aggregate beds with perforated pipe underdrains running full.” J. Irrig. Drain. Eng., 04014023.
Nield, D. A., and Bejan, A. (2006). Convection in porous media, 3rd Ed., Springer Science & Business Media, New York.
Papathanasiou, T. D., Markicevic, B., and Dendy, E. D. (2001). “A computational evaluation of the Ergun and Forchheimer equations for fibrous porous media.” Phys. Fluids, 13(10), 2795–2804.
Schlüter, W., Jefferies, C., and Zhang, X. X. (2007). “Modeling of flow through gravel-filled trenches.” Urban Water J., 4(4), 241–251.
Schwartz, S. S. (2010). “Effective curve number and hydrologic design of pervious concrete storm-water systems.” J. Hydrol. Eng., 465–474.
Siwoń, Z. (1987). “Solutions for lateral inflow in perforated conduits.” J. Hydr. Eng., 1117–1132.
Stuyt, L. C. P. M., Dierickx, W., and Martinez Beltran, J. (2005). “Materials for subsurface land drainage systems.” Food and Agriculture Organization of the United Nations, Rome.
Ward, J. C. (1964). “Turbulent flow in porous media.” J. Hydraul. Div., 90(5), 1–12.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 142 • Issue 8 • August 2016
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Apr 1, 2015
Accepted: Dec 8, 2015
Published online: Mar 23, 2016
Published in print: Aug 1, 2016
Discussion open until: Aug 23, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.