Numerical Evaluation of the Behavior of GRS Walls with Segmental Block Facing under Working Stress Conditions
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 141, Issue 3
Abstract
This study numerically evaluated the combined effects of different controlling factors (i.e., wall height, stresses induced during backfill compaction, reinforcement stiffness, toe conditions, and facing stiffness) on the behavior of geosynthetic-reinforced soil (GRS) walls under working stress conditions. The results were compared with values predicted by different currently used methods. It was shown that toe resistance has a major effect on the prediction capability of those design methods. Parametric analyses have shown that the amount of tension in the reinforcement varies with restraint at the base of the block facing. For free-base conditions with a constant value for reinforcement stiffness, the tension in the reinforcements was the same irrespective of the facing stiffness and the wall height. For the fixed-base conditions, the amount of tension in the reinforcements and horizontal toe load varied as a function of the facing stiffness. Comparing individual measurements of reinforcement tension verified the significant effect that the toe restraint has on the amount of tension mobilized in the reinforcements at the bottom of the wall. The results showed that the amount of tension in the reinforcement is a function of the magnitude of the compaction-induced stress and the reinforcement stiffness. These results indicate that the compaction-induced stress does not significantly affect the magnitude of the horizontal toe load.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (2012). LRFD bridge design specifications, 6th Ed., Washington, DC.
Adib, M. E. (1988). “Internal lateral earth pressure in earth walls.” Ph.D. thesis, Univ. of California, Berkeley, CA.
Al-Hussaini, M. M., and Johnson, L. D. (1978). “Numerical analysis of a reinforced earth wall.” Proc., Symp. on Earth Reinforcement, ASCE, New York, 351–379.
Allen, T. M., and Bathurst, R. J. (2013). “Comparison of working stress and limit equilibrium behavior of reinforced soil walls.” Geo-Congress 2013: Sound Geotechnical Research to Practice: Honoring Robert D. Holtz II, Geotechnical special publication 230, R. D. Holtz II, A. W. Stuedlein, and B. R. Christopher, eds., ASCE, Reston, VA, 499–513.
Bathurst, R. J., Miyata, Y., Nernheim, A., and Allen, A. M. (2008). “Refinement of K-stiffness method for geosynthetic-reinforced soil walls.” Geosynth. Int., 15(4), 269–295.
Bathurst, R. J., Nernheim, A., Walters, D. L., Allen, T. M., Burgess, P., and Saunders, D. D. (2009). “Influence of reinforcement stiffness and compaction on the performance of four geosynthetic-reinforced soil walls.” Geosynth. Int., 16(1), 43–59.
Bathurst, R. J., Vlachopoulos, N., Walters, D. L., Burgess, P. G., and Allen, T. M. (2006). “The influence of facing stiffness on the performance of two geosynthetic reinforced soil retaining walls.” Can. Geotech. J., 43(12), 1225–1237.
Bathurst, R. J., Vlachopoulos, N. P., Walters, D. L., Burgess, P. G., and Allen, T. M. (2007). “Reply to the discussions on ‘The influence of facing stiffness on the performance of two geosynthetic reinforced soil retaining walls’.” Can. Geotech. J., 44(12), 1484–1490.
Brinkgreve, R. B. J., and Vermeer, P. A. (2002). PLAXIS: Finite element code for soil and rock analyses, version 8, CRC Press/Balkema, Leiden, Netherlands.
Chen, J. F., and Bathurst, R. J. (2013). “Investigation of interface toe sliding of reinforced soil block face walls using FLAC.” Proc., Continuum and Distinct Element Numerical Modeling in Geomechanics, Itasca International, Shanghai, China.
Duncan, J. M., and Chang, C. Y. (1970). “Nonlinear analysis of stress and strain in soils.” J. Soil Mech. and Found. Div., 96(5), 1629–1653.
Dyer, N. R., and Milligan, G. W. E. (1984). “A photoelastic investigation of the interaction of a cohesionless soil with reinforcement placed at different orientations.” Proc., Int. Conf. on In-Situ Soil and Rock Reinforcement, International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE), London, 257–262.
Ehrlich, M., and Becker, L. (2010). Reinforced soil walls and slopes: Design and construction, Taylor & Francis, Abingdon, U.K.
Ehrlich, M., Dantas, B. T., Zornberg, J. G., Sitar, N., and Mitchell, J. K. (2000). “Limit equilibrium as basis for design of geosynthetic reinforced slopes.” J. Geotech. Geoenviron. Eng., 286–288.
Ehrlich, M., and Mirmoradi, S. H. (2013). “Evaluation of the effects of facing stiffness and toe resistance on the behavior of GRS walls.” J. Geotextile Geomembr., 40(Oct), 28–36.
Ehrlich, M., Mirmoradi, S. H., and Saramago, R. P. (2012). “Evaluation of the effect of compaction on the behavior of geosynthetic-reinforced soil walls.” J. Geotextile Geomembr., 34(Oct), 108–115.
Ehrlich, M., and Mitchell, J. K. (1994). “Working stress design method for reinforced soil walls.” J. Geotech. Engrg., 625–645.
Fast Lagrangian Analysis of Continua (FLAC) 4.00 [Computer software]. Minneapolis, Itasca Consulting Group.
Federal Highway Administration (FHWA). (2008). “Geosynthetic design and construction guidelines.” FHWA NHI-07-092, Washington, DC.
Guler, E., Hamderi, M., and Demirkan, M. M. (2007). “Numerical analysis of reinforced soil-retaining wall structures with cohesive and granular backfills.” Geosynth. Int., 14(6), 330–345.
Hatami, K., and Bathurst, R. J. (2005). “Development and verification of a numerical model for the analysis of geosynthetic-reinforced soil segmental walls under working stress conditions.” Can. Geotech. J., 42(4), 1066–1085.
Hatami, K., and Bathurst, R. J. (2006). “Numerical model for reinforced soil segmental walls under surcharge loading.” J. Geotech. Geoenviron. Eng., 673–684.
Helwany, S. M. B., Reardon, G., and Wu, J. T. H. (1999). “Effects of backfill on the performance of GRS retaining walls.” J. Geotextile Geomembr., 17(1), 1–16.
Hermann, L. R., and Al-Yassin, Z. (1978). “Numerical analysis of reinforced soil systems.” Proc., Symp. on Earth Reinforcement, ASCE, Reston, VA, 428–457.
Huang, B., Bathurst, R. J., Hatami, K., and Allen, T. M. (2010). “Influence of toe restraint on reinforced soil segmental walls.” Can. Geotech. J., 47(8), 885–904.
Janbu, J. (1963). “Soil compressibility as determined by oedometer and triaxial tests.” Proc., European Conf. on Soil Mechanics and Foundation Engineering, Vol. 1, International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE), London, 19–25.
Jewell, R. A. (1980). “Some effects of reinforcement on the mechanical behavior of soils.” Ph.D. thesis, Univ. of Cambridge, Cambridge, U.K.
Leshchinsky, D. (2009). “On global equilibrium in design of geosynthetic reinforced walls.” J. Geotech. Geoenviron. Eng., 309–315.
Leshchinsky, D., and Boedeker, R. H. (1989). “Geosynthetic reinforced structures.” J. Geotech. Engrg., 1459–1478.
Leshchinsky, D., and Tatsuoka, F. (2013). “Geosynthetic reinforced walls in the public sector: performance, design, and redundancy.” Geosynth. Mag., 31(3), 12–21.
Leshchinsky, D., and Vahedifard, F. (2012). “Impact of toe resistance in reinforced masonry block walls: Design dilemma.” J. Geotech. Geoenviron. Eng., 236–240.
Ling, H. I., Cardany, C. P., Sun, L. X., and Hashimoto, H. (2000). “Finite element study of a geosynthetic-reinforced soil retaining wall with concrete-block facing.” Geosynth. Int., 7(2), 137–162.
Ling, H. I., and Leshchinsky, D. (2003). “Finite element parametric study of the behavior of segmental block reinforced-soil retaining walls.” Geosynth. Int., 10(3), 77–94.
Mirmoradi, S. H., and Ehrlich, M. (2013). “Numerical evaluation of the behavior of reinforced soil retaining walls.” Proc., 18th Int. Conf. on Soil Mechanics and Geotechnical Engineering, International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE), London, 773–776.
Mirmoradi, S. H., and Ehrlich, M. (2014). “Modeling of the compaction-induced stresses in numerical analyses of GRS walls.” Int. J. Comput. Methods, 11(2), 1342002.
Mohamad, G., Lourenço, P. B., and Roman, H. R. (2007). “Mechanics of hollow concrete block masonry prisms under compression: Review and prospects.” Cement Concr. Compos., 29(3), 181–192.
Nakane, A., Taki, M., Yokota, Y., and Miyatake, H. (1996). “FEM comparative analysis of facing rigidity of geotextile reinforced soil walls.” Proc., Int. Symp. on Earth Reinforcement, Balkema, Rotterdam, Netherlands, 433–438.
National Concrete Masonry Association (NCMA). (2009). Design manual for segmental retaining walls, 3rd Ed., M. Bernardi, ed., Herndon, VA.
Naylor, D. J. (1978). “A study of reinforced earth walls allowing strip slip.” Proc., Symp. on Earth Reinforcement, ASCE, Reston, VA, 618–643.
PLAXIS 8 [Computer software]. Balkema, Rotterdam, Netherlands.
Riccio, M., Ehrlich, M., and Dias, D. (2014). “Field monitoring and analyses of the response of a block-faced geogrid wall using fine-grained tropical soils.” J. Geotextile Geomembr., 42(2), 127–138.
Romstad, K. M., Herrmann, L. R., and Shen, C. K. (1976). “Integrated study on reinforced earth. I: Theoretical formulation.” J. Geotech. Engrg. Div., 102(5), 457–472.
Rowe, R. K., and Ho, S. K. (1993). “A review of the behavior of reinforced soil walls.” Proc., Int. Symp. on Earth Reinforcement, Balkema, Leiden, Netherlands, 801–830.
Steward, J. E., Willianson, R., and Mohney, J. (1977). “Earth reinforcement.” Chapter 5, Guidelines for use of fabrics in construction and maintenance of low-volume roads, USDA Forest Service, Portland, OR.
Tatsuoka, F. (1993). “Roles of facing rigidity in soil reinforcing. Keynote lecture.” Proc., Int. Symp. on Earth Reinforcement, Balkema, Leiden, Netherlands, 831–870.
Tatsuoka, F., Koseki, J., and Kuwano, J. (2014). “Natural disasters mitigation by using construction methods with geosynthetics (earthquakes).” Proc., 10th Int. Conf. on Geosynthetics, International Society of Soil Mechanics and Geotechnical Engineering (ISSMGE), London.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 141 • Issue 3 • March 2015
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Aug 26, 2013
Accepted: Oct 1, 2014
Published online: Nov 3, 2014
Published in print: Mar 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.