Experimental Study on the Stability of Railroad Silt Subgrade with Increasing Train Speed
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 136, Issue 6
Abstract
The comfort and safety of a moving train is largely determined by the dynamic response of the railway track and its foundation (i.e., subgrade). To study the dynamic stability of a silt subgrade subjected to train traffic loading with increasing speed, cyclic triaxial tests were conducted for compacted silt specimens with varying dry density, water content, dynamic stress, and load frequency. The laboratory test results and field measurements of the subgrade dynamic stress under train loading indicate that with increasing train speed, an increase in dynamic stress and load frequency does not impair the stability of the silt subgrade, provided the subgrade is in sound physical condition (i.e., its natural water content approximates the optimal water content) and the relative compaction is at least 90%. However, if the relative compaction is 85%, the subgrade is stable only at a dynamic stress level that is below 70 kPa, and the subgrade may suffer shear failure at a higher dynamic stress level. The elastic deformation of the subgrade linearly increases with an increase in train speed. However, if the degree of saturation of the silt subgrade increases, the thresholds of both the dynamic stress and resilient modulus decrease markedly, accompanied by sharp increases in elastic deformation and cumulative deformation and can even result in the shear failure of the subgrade. These conditions are unfavorable for the high speeds and stability needed for trains; therefore, train speeds should be limited in wet conditions to reduce subgrade dynamic stress and load frequency.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is supported by the National Natural Science Foundation of China (NSFC) under Grant No. UNSPECIFIED50678020.
References
Brown, S. F., Lashine, A. K. F., and Hyde, A. F. L. (1975). “Repeated load triaxial testing of a silty clay.” Geotechnique, 25(1), 95–114.
Cheung, L. W. (1994). “Laboratory assessment of pavement foundation materials.” Ph.D. thesis, University of Nottingham, Nottingham, U.K.
China Railway Press. (2004). “Code for soil test of railway engineering.” TB10102-2004, Beijing.
China Railway Press. (2007). “Technical standards of 200 km/h moving trains on existing railway (tentative standard).” Railway technology 2006-747, Beijing
Chinese Academy of Railway Science (CARS). (2006). Measurements of subgrade dynamic responses on Chinese existing railway with train moving at speed of 200 km/h, CARS, Beijing.
Drumm, E. C., Reeves, J. S., Madgett, M. R., and Trolinger, W. D. (1997). “Subgrade resilient modulus correction for saturation effects.” J. Geotech. Geoenviron. Eng., 123(7), 663–670.
Fortin, J. P. (1983). “Dynamic track deformation.” French Railway Review, 1(1), 3–12.
Guan, Y., Drumm, E. C., and Jackson, N. M. (1998). “Weighting factor for seasonal subgrade resilient modulus.” Transportation Research Record. 1619, Transportation Research Board, National Research Council, Washington, D.C., 94–101.
Han, Z. L. (2002). “Research on the countermeasure of railway subgrade on existing railways.” China Railway Science, 23(2), 53–58.
Han, Z. L., and Zhang, Q. L. (2005). “Dynamic stress analysis on speed-increase subgrade of existing railway.” China Railway Science, 26(5), 1–5.
Heath, D. L., Shenton, M. J., Sparrow, R. W., and Waters, J. M. (1972). “Design of conventional rail track foundations.” Proc. -Inst. Civ. Eng., 51, 251–267.
Jin, M. S., Kovacs, W. D., and Lee, K. W. (1994). “Seasonal variation of resilient modulus of subgrade soils.” J. Transp. Eng., 120(4), 603–616.
Larew, H. G. (1960). “Strength and deformation characteristics of compacted soils under the action of repeated axial loads.” Ph.D. thesis, Purdue Univ., West Lafayette, Ind.
Li, D., and Selig, E. T. (1994). “Resilient modulus for fine-grained subgrade soils.” J. Geotech. Engrg., 120(6), 939–957.
Li, D., and Selig, E. T. (1996). “Cumulative plastic deformation for fine grained subgrade soils.” J. Geotech. Engrg., 122(12), 1006–1013.
Liu, J. K. (2006). Subgrade engineering, The Architecture and Building Industry Publishing House of China, Beijing.
Miller, G. A., et al. (2000). “Cyclic shear strength of soft railroad subgrade.” J. Geotech. Geoenviron. Eng., 126(2), 139–147.
Mohammad, L. N., Titi, H. H., and Herath, A. (2002). “Effect of moisture content and dry unit weight on the resilient modulus of subgrade soils predicted by cone penetration test.” Louisiana Transportation Research Center Rep. No. FHWA/LA-00/355, Federal Highway Administration, Texas A&M Univ., College Station, Tex.
Monismith, C. L., Ogawa, N., and Freeme, C. R. (1975). “Cumulative deformation characteristics of subgrade soils due to repeated loading.” Transportation Research Record. 537, Transportation Research Board, Washington, D.C., 1–17.
Qiu, Y. J. (1998). “Permanent deformation of subgrade soils: Laboratory investigation and application in mechanistic-based pavement design.” Ph.D. thesis, Univ. of Arkansas, Ark.
Seed, H. B., Chan, C. K., and Monismith, C L (1955). “Effects of repeated loading on the strength and deformation of compacted clay.” Proc., Highway Research Board, 34, 541–558.
Wang, L. J., Zhang, Q. L., and Zhao, H. Y. (2005). “Subgrade distress and its countermeasure of heavy load railway.” Railway Construction, 7, 67–68.
Xiao, J. H. (2008). “Study on the dynamic properties of silt and subgrade stability subjected to train moving loading.” Ph.D. thesis, Beijing Jiaotong Univ., Beijing, China.
Xiao, J. H., Liu, J. K., and Chen, L. H. (2008). “Effect of dry density and moisture content on the behavior of Yellow River alluvial silt.” Rock Soil Mech., 29(2), 409–414.
Yang, C. W. (1990). “Experimental study of dynamic behaviors of subgrade soil.” Research Rep. Prepared for Chinese Academy of Railway Science, Beijing, China.
Zhou, S. G. (1996). “Research on the designed dynamic stress of railroad subgrade.” Subgrade Engineering 68(5), 6–11.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Dec 27, 2008
Accepted: Nov 9, 2009
Published online: Nov 18, 2009
Published in print: Jun 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.