Active Stability Analysis of 3D Shallow Tunnel Face with Longitudinally Inclined Ground Surface Based on Nonlinear Mohr–Coulomb Failure Criterion
Publication: International Journal of Geomechanics
Volume 20, Issue 11
Abstract
The longitudinally inclined (the tunnel excavation direction) ground surface often appearing at the shallow tunnel entrance and exit zone threatens and reduces the tunnel face stability. However, studies on this stability have rarely accounted for this inclined angle. Therefore, the effect of this inclined angle on the shallow tunnel face stability is considered, and the corresponding three-dimensional (3D) failure mode is constructed in this article. Then, the expression of active failure pressure is obtained using a nonlinear Mohr–Coulomb failure criterion based on the principle of virtual work. The upper-bound solution of it is examined based on the sequential quadratic programming method. The active failure pressure and failure mechanism are presented based on a series of studies of the key parameters. The results demonstrate that the shallow tunnel face stability is more dependent on the inclined angle (δ), tunneling length (L), and nonlinear shear strength parameters. Under nonlinear conditions, the influence is more significant. When the ground surface failure region is zero, the dimensionless parameter (C/D), tunneling length, and ground surcharge (σs) have no effect on the result. In addition, the longitudinally inclined ground surface is easy to induce the active failure of the shallow tunnel face.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
1.
The data in Figs. 1–10 can provide if requested.
2.
The code required to reproduce these findings cannot be shared at this time. Because it is also forming part of an ongoing study. Surely, if there are any questions about some parts, we can provide the code of corresponding parts and carry out further discussion.
This study was financially supported by the National Natural Science Foundation of China (No. 51878668), the Guizhou Provincial Department of Transportation Foundation (No. 2017122058), and the program of China Scholarship Council. All financial supports are greatly appreciated.
References
Agar, J. G., N. R. Morgenstern, and J. D. Scott. 1987. “Shear strength and stress-strain behaviour of Athabasca oil sand at elevated temperatures and pressures.” Can. Geotech. J. 24 (1): 1–10. https://doi.org/10.1139/t87-001.
Hoek, E., and E. T. Brown. 1982. “Empirical strength criterion for rock masses.” J. Geotech. Geoenviron. Eng. 106 (GT9): 1013–1035.
Hoek, E., and E. T. Brown. 1997. “Practical estimates of rock mass strength.” Int. J. Rock Mech. Min. Sci. 34 (8): 1165–1186. https://doi.org/10.1016/S1365-1609(97)80069-X.
Huang, F., X. L. Yang, L. H. Zhao, and T. H. Ling. 2013. “Upper bound solutions of safety factor for shallow tunnels subjected to nonlinear failure criterion and strength reduction method.” Eng. Mech. 30 (12): 160–166.
Lade, P. V. 1977. “Elasto-plastic stress–strain theory for cohesionless soil with curved yield surfaces.” Int. J. Solids Struct. 13 (11): 1019–1035. https://doi.org/10.1016/0020-7683(77)90073-7.
Leca, E., and L. Dormieux. 1990. “Upper and lower bound solutions for the face stability of shallow circular tunnels in frictional material.” Géotechnique 40 (4): 581–606. https://doi.org/10.1680/geot.1990.40.4.581.
Li, D. J., L. H. Zhao, F. Yang, and X. Cheng. 2016. “Three-dimensional stability analysis of passive failure on shallow tunnel face based on the nonlinear failure criterion.” Chin. J. Rock Mech. Eng. 35 (4): 743–752.
Liu, B. C., Z. L. Cui, and J. F. Tu. 1997. “A study of strength criterion in power function for rock material.” Chin. J. Rock Mech. Eng. 16 (5): 437–444.
Mollon, G., D. Dias, and A. H. Soubra. 2009. “Probabilistic analysis and design of circular tunnels against face stability.” Int. J. Geomech. 9 (6): 237–249. https://doi.org/10.1061/(ASCE)1532-3641(2009)9:6(237).
Mollon, G., D. Dias, and A. H. Soubra. 2010. “Face stability analysis of circular tunnels driven by a pressurized shield.” J. Geotech. Geoenviron. Eng. 136 (1): 215–229. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000194.
Mollon, G., D. Dias, and A. H. Soubra. 2011. “Rotational failure mechanisms for the face stability analysis of tunnels driven by a pressurized shield.” Int. J. Numer. Anal. Methods Geomech. 35 (12): 1363–1388. https://doi.org/10.1002/nag.962.
Mollon, G., D. Dias, and A. H. Soubra. 2013. “Range of the safe retaining pressures of a pressurized tunnel face by a probabilistic approach.” J. Geotech. Geoenviron. Eng. 139 (11): 1954–1967. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000911.
Pan, Q. J., and D. Dias. 2016. “Face stability analysis for a shield-driven tunnel in anisotropic and nonhomogeneous soils by the kinematical approach.” Int. J. Geomech. 16 (3): 04015076. https://doi.org/10.1061/(ASCE)GM.1943-5622.0000569.
Pan, Q. J., and D. Dias. 2017. “Upper-bound analysis on the face stability of a non-circular tunnel.” Tunnelling Underground Space Technol. 62: 96–102. https://doi.org/10.1016/j.tust.2016.11.010.
Soubra, A. H., D. Dias, F. Emeriault, and R. Kastner. 2008. “Three-dimensional face stability analysis of circular tunnels by a kinematical approach.” In GeoCongress 2008: Characterization, Monitoring, and Modeling of GeoSystems, Geotechnical Special Publication 179, edited by A. N. Alshawabkeh, K. R. Reddy, and M. V. Khire, 894–901. Reston, VA: ASCE.
Subrin, D., and H. Wong. 2002. “Tunnel face stability in frictional material: A new 3D failure mechanism.” C.R. Mec. 330 (7): 513–519. https://doi.org/10.1016/S1631-0721(02)01491-2.
Yang, X. L., and Z. W. Wang. 2010. “Limit analysis of earth pressure on shallow tunnel using nonlinear failure criterion.” J. Central South Univ. Technol. 41 (1): 299–302.
Zhang, J. H., X. L. Yang, Q. Liang, B. Zhang, and F. Meng. 2014. “On limit analysis of surrounding rock pressure on shallow tunnel under non-bias and bias conditions.” J. Highway Transp. Res. Dev. 31 (5): 110–118.
Zhang, X. J., and W. F. Chen. 1987. “Stability analysis of slopes with general nonlinear failure criterion.” Int. J. Numer. Anal. Methods Geomech. 11 (1): 33–50. https://doi.org/10.1002/nag.1610110104.
Zhao, L. H., X. Cheng, H. C. Dan, Z. P. Tang, and Y. B. Zhang. 2017a. “Effect of the vertical earthquake component on permanent seismic displacement of soil slopes based on the nonlinear Mohr–Coulomb failure criterion.” Soils Found. 57 (2): 237–251. https://doi.org/10.1016/j.sandf.2016.12.002.
Zhao, L. H., F. Huang, Q. H. Sun, Z. M. Xiang, and W. Luo. 2014. “Rock pressure of unsymmetrical shallow rectangular tunnel based on upper bound limit analysis method.” J. Central South Univ. 45 (9): 3093–3103.
Zhao, L. H., D. J. Li, L. Li, F. Yang, X. Cheng, and W. Luo. 2017b. “Three-dimensional stability analysis of a longitudinally inclined shallow tunnel face.” Comput. Geotech. 87: 32–48. https://doi.org/10.1016/j.compgeo.2017.01.015.
Zhao, L. H., D. J. Li, F. Yang, L. Li, and X. Cheng. 2019. “Dimensionless parameter diagrams for the active and passive stability of a shallow 3D tunnel face.” KSCE J. Civ. Eng. 23 (2): 866–878. https://doi.org/10.1007/s12205-018-5835-0.
Zhao, L. H., L. Li, F. Yang, Q. Luo, and X. Liu. 2010. “Upper bound analysis of slope stability with nonlinear failure criterion based on strength reduction technique.” J. Central South Univ. Technol. 17 (4): 836–844. https://doi.org/10.1007/s11771-010-564-7.
Zhou, X. J., and C. Y. Yang. 2007. “Asymmetric rock pressure on shallow tunnel in strata with inclined ground surface.” J. Southwest Jiaotong Univ. 15 (3): 203–209.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Jun 8, 2019
Accepted: Jun 30, 2020
Published online: Aug 18, 2020
Published in print: Nov 1, 2020
Discussion open until: Jan 18, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.