Influence of the Copper Content of Catalyst on Performance
Publication: Journal of Energy Engineering
Volume 141, Issue 4
Abstract
A series of the mixed oxides were prepared by using the acid-processed gelatin method, characterized by Brunauer-Emmett-Teller (BET), X-ray diffraction (XRD), Fourier transform infrared (FT-IR), and transmission electron microscopy (TEM) techniques and applied as sulfur transfer catalysts under conditions similar to those of fluid catalytic cracking (FCC) units. The analysis of the abatement curves as a function of the copper content indicates that the reaction mechanism of uptake depends on two reversible surface processes (the chemisorptions of and its oxidation by copper ions) and a nearly irreversible process (bulk diffusion of the sulphate species). The results also show that the mixed oxides catalysts achieve the highest oxidative rate when they contain 11.1% (mol) copper (sample ).
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The project was supported by research fund of the National Natural Science Foundation of China (21306162), the National 973 Project of China (2010CB226903) and Key Laboratory for Advanced Technology in Environmental Protection of Jiangsu Province (AE201309).
References
Bhattacharyya, A. A., Woltermann, G. M., Yoo, J. S., John, A. K., and William, E. C. (1988). “Catalytic SOx abatement: The role of magnesium aluminate spinel in the removal of SOx from fluid catalytic cracking flue gas.” Ind. Eng. Chem. Res., 27(8), 1356–1360.
Cantu, M., Lopez-Salinas, E., and Valente, J. S. (2005). “SOx removal by calcined MgAlFe hydrotalcite-like materials: Effect of the chemical composition and the cerium incorporation method.” Environ. Sci. Technol., 39(24), 9715–9720.
Centi, G., and Perathoner, S. (2007). “Performances of SOx traps derived from Cu/Al hydrotalcite for the protection of NOx traps from the deactivation by sulphur.” Appl. Catal. B Environ., 70(1–4), 172–178.
Cheng, W. C., Kim, G., Peters, A. W., Zhao, X., and Rajagopalan, K. (1998). “Environmental fluid catalytic cracking technology.” Cat. Rev. Sci. Eng., 40(1–2), 39–79.
Corma, A., Palomares, A. E., Rey, F., and Marques, F. (1997). “Simultaneous catalytic removal of SOx and NOx with hydrotalcite-derived mixed oxides containing copper, and their possibilities to be used in FCC units.” J. Catal., 170(1), 140–149.
Dimitriadis, V. D., and Vasalos, I. A. (1992). “Evaluation and kinetics of commercially available additives for sulfur oxide (SOx) control in fluid catalytic cracking units.” Ind. Eng. Chem. Res., 31(12), 2741–2748.
Jiang, R., Shan, H., Li, C. H., and Yang, C. H. (2012). “The influence of surface area of De-SOx catalyst on its performance.” Sep. Purif. Technol., 95, 144–148.
Khalafalla, S. E., and Shah, I. D. (1970). “Oxidative roasting of covellite with minimal retardation from the film.” Metall. Trans., 1(8), 2151–2156.
Kim, G., and Juskelis, M. V. (1996). “Catalytic reduction of Stored in SOx transfer catalysts—A temperature-programmed reaction study.” Stud. Surf. Sci. Catal., 101, 137–142.
Lee, S. J., Jung, S. Y., Lee, S. C., Jun, H. K., Ryu, C. K., and Kim, J. C. (2009). “ removal and regeneration of MgO-based sorbents promoted with titanium oxide.” Ind. Eng. Chem. Res., 48(5), 2691–2696.
Pereira, H. B., Polato, C. M. S., Monteiro, J. L. F., and Henriques, C. A. (2010). “Mn/Mg/Al-spinels as catalysts for SOx abatement influence of incorporation and catalytic stability.” Catal. Today, 149(3–4), 309–315.
Polato, C. M. S., Rodrigues, A. C. C., Monteiro, J. L. F., and Henriques, C. A. (2010). “High surface area Mn, Mg, Al-spinels as catalyst additives for SOx abatement in fluid catalytic cracking units.” Ind. Eng. Chem. Res., 49(3), 1252–1258.
Rodas-Grapain, A., Arenas-Alatorre, J., Gomez-Cortes, A., and Diaz, G. (2005). “Catalytic properties of a sorbent-catalyst for De-SOx reaction.” Catal. Today, 107, 168–174.
Velu, S., Shah, N., Jyothi, T. M., and Sivasanker, S. (1999). “Effect of manganese substitution on the physicochemical properties and catalytic toluene oxidation activities of Mg-Al layered double hydroxides.” Microporous Mesoporous Mater., 33(1–3), 61–75.
Wang, J. A., and Li, C. L. (2000). “ adsorption and thermal stability and reducibility of sulfates formed on the magnesium-aluminate spinel sulfur-transfer catalyst.” Appl. Surf. Sci., 161(3–4), 406–416.
Waqif, M., Saur, O., Lavalley, J. C., Perathoner, S., and Centi, G. (1991). “Nature and mechanism of formation of sulfate species on copper/alumina sorbent-catalysts for sulfur dioxide removal.” J. Phys. Chem., 95(10), 4051–4058.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Feb 12, 2014
Accepted: Jul 14, 2014
Published online: Aug 14, 2014
Discussion open until: Jan 14, 2015
Published in print: Dec 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.